A single-port, dual-frequency SSFIP antenna integrating a low-pass filter

2003 ◽  
Vol 39 (6) ◽  
pp. 472-475
Author(s):  
J-F. Zürcher
Keyword(s):  
Single Port ◽  
Dual Frequency ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass

scholarly journals Theoretical and Experimental Study on Nonlinear Failure of an MEMS Accelerometer under Dual Frequency Acoustic Interference

Sensors ◽  
2021 ◽  
Vol 21 (3) ◽  
pp. 945
Author(s):  
Peng Guo ◽  
Jiayu Zhang ◽  
Lihui Feng ◽  
Jianmin Cui ◽  
Chaoyang Xing
Keyword(s):  
Mathematical Model ◽  
Damping Ratio ◽  
Maximum Amplitude ◽  
Dual Frequency ◽  
Maximum Acceleration ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass ◽  
The Mathematical Model ◽  
Frequency Sweeping

In order to quantitatively study the interfered output of the accelerometer under an acoustic injection attack, a mathematical model for fitting and predicting the accelerometer output was proposed. With ADXL103 as an example, an acoustic injection attack experiment with amplitude sweeping and frequency sweeping was performed. In the mathematical model, the R-squared coefficient was R2 = 0.9990 in the acoustic injection attack experiment with amplitude sweeping, and R2 = 0.9888 with frequency sweeping. Based on the mathematical model, the dual frequency acoustic injection attack mode was proposed. The difference frequency signal caused by the nonlinear effect was not filtered by the low-pass filter. At a 115 dB sound pressure level, the maximum acceleration bias of the output was 4.4 m/s2 and the maximum amplitude of fluctuation was 4.97 m/s2. Two kinds of methods of prevention against acoustic injection attack were proposed, including changing the damping ratio of the accelerometer and adding a preposition low-pass filter.

Design of Programmable Wideband Low Pass Filter with Continuous-Time/Discrete-Time Hybrid Architecture

2017 ◽  
Vol E100.C (10) ◽  
pp. 858-865 ◽  
Author(s):  
Yohei MORISHITA ◽  
Koichi MIZUNO ◽  
Junji SATO ◽  
Koji TAKINAMI ◽  
Kazuaki TAKAHASHI
Keyword(s):  
Discrete Time ◽  
Continuous Time ◽  
Hybrid Architecture ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass

ANALYSIS AND IMPROVEMENT TECHNIQUES FOR THE TRANSFER FUNCTION OF A PLANAR LOW - PASS FILTER

2016 ◽  
Vol 15 (12) ◽  
pp. 2579-2586
Author(s):  
Adina Racasan ◽  
Calin Munteanu ◽  
Vasile Topa ◽  
Claudia Pacurar ◽  
Claudia Hebedean
Keyword(s):  
Transfer Function ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass

scholarly journals Simulating Elliptic Low-pass Filter based on MOCCCII

2020 ◽  
Vol 965 ◽  
pp. 012037
Author(s):  
Nanan Chomnak ◽  
Siradanai Srisamranrungrueang ◽  
Natapong Wongprommoon
Keyword(s):  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass

scholarly journals Noise-Reducing Fabric Electrode for ECG Measurement

Sensors ◽  
2021 ◽  
Vol 21 (13) ◽  
pp. 4305
Author(s):  
Takamasa Terada ◽  
Masahiro Toyoura ◽  
Takahide Sato ◽  
Xiaoyang Mao
Keyword(s):  
Special Structure ◽  
Electrode Impedance ◽  
Electrode Structure ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Chip Type ◽  
Low Pass ◽  
Filter Fabric

In this work, we propose a fabric electrode with a special structure that can play the role of a noise reduction filter. Fabric electrodes made of the conductive fabric have been used for long-term ECG measurements because of their flexibility and non-invasiveness; however, due to the large impedance between the skin and the fabric electrodes, noise is easily introduced into the ECG signal. In contrast to conventional work, in which chip-type passive elements are glued to the electrode to reduce noise, the proposed electrode can obtain a noise-reduced ECG by changing the structure of fabric. Specifically, the proposed electrode was folded multiple times to form a capacitor with a capacitance of about 3 nF. It is combined with the skin-electrode impedance to form a low-pass filter. In the experiment, we made a prototype of the electrodes and measured ECG at rest and during EMG-induced exercise. As a result, the SNR values at rest and during exercise were improved about 12.02 and 10.29 , respectively, compared with the fabric electrode without special structure. In conclusion, we have shown that changing the fabric electrode structure effectively removes noise in ECG measurement.

Sign in / Sign up

Export Citation Format

Share Document