An experimental and modeling study of ethanol oxidation kinetics in an atmospheric pressure flow reactor

1992 ◽  
Vol 24 (4) ◽  
pp. 319-344 ◽  
Author(s):  
T. S. Norton ◽  
F. L. Dryer
Keyword(s):  
Oxidation Kinetics ◽  
Atmospheric Pressure ◽  
Ethanol Oxidation ◽  
Flow Reactor ◽  
Pressure Flow ◽  
Modeling Study

Adsorption of carbon monoxide on smaller gold-cluster anions in an atmospheric-pressure flow-reactor: temperature and humidity dependence

2005 ◽  
Vol 7 (5) ◽  
pp. 930 ◽  
Author(s):  
William T. WallaceCurrent address: Department ◽  
Richard B. WyrwasCurrent address: Department o ◽  
Andrew J. Leavitt ◽  
Robert L. Whetten
Keyword(s):  
Carbon Monoxide ◽  
Atmospheric Pressure ◽  
Flow Reactor ◽  
Gold Cluster ◽  
Cluster Anions ◽  
Pressure Flow ◽  
Temperature And Humidity ◽  
Reactor Temperature ◽  
Humidity Dependence

Analogues of the active and inactive sodium carbonate

1982 ◽  
Vol 47 (12) ◽  
pp. 3348-3361 ◽  
Author(s):  
Erich Lippert ◽  
Karel Mocek ◽  
Emerich Erdös
Keyword(s):  
Thermal Decomposition ◽  
Time Dependence ◽  
Water Vapour ◽  
Sulphur Dioxide ◽  
Atmospheric Pressure ◽  
Flow Reactor ◽  
Kinetic Measurements ◽  
Sodium Potassium ◽  
Alkaline Metals ◽  
Hydrogen Carbonates

The reactivity of the anhydrous carbonates of alkaline metals with sulphur dioxide has been studied experimentally in dependence both on the nature of the cation and on the way of preparation of the anhydrous carbonate. The carbonates were prepared either by thermal decomposition of hydrogen carbonates or by thermal dehydration of carbonate hydrates. The carbonates of lithium, sodium, potassium, rubidium and caesium have been investigated. Kinetic measurements were carried out in a flow reactor in the integral regime at 423 K under atmospheric pressure, with a gas containing 0.2 vol.% of sulphur dioxide and 2.0 vol.% of water vapour in the nitrogen as a carrier gas. The reactivities have been compared on the basis of time dependence of the conversion of carbonate to sulphite.

Kinetics of the catalytic hydrodesulphurization reaction system; hydrogenolysis of thiophene

1980 ◽  
Vol 45 (10) ◽  
pp. 2728-2741 ◽  
Author(s):  
Pavel Fott ◽  
Petr Schneider
Keyword(s):  
Atmospheric Pressure ◽  
Active Sites ◽  
Flow Reactor ◽  
Kinetic Equations ◽  
Reaction System ◽  
Reaction Products ◽  
Molybdenum Catalyst ◽  
Cobalt Molybdenum Catalyst ◽  
Kinetics Of ◽  
Reaction Schemes

Kinetics have been studied of the reaction system taking place during the reaction of thiophene on the cobalt-molybdenum catalyst in a gradientless circulation flow reactor at 360 °C and atmospheric pressure. Butane has been found present in a small amount in the reaction products even at very low conversion. In view of this, consecutive and parallel-consecutive (triangular) reaction schemes have been proposed. In the former scheme the appearance of butane is accounted for by rate of desorption of butene being comparable with the rate of its hydrogenation. According to the latter scheme part of the butane originates from thiophene via a different route than through hydrogenation of butene. Analysis of the kinetic data has revealed that the reaction of thiophene should be considered to take place on other active sites than that of butene. Kinetic equations derived on this assumption for the consecutive and the triangular reaction schemes correlate experimental data with acceptable accuracy.

Thermocatalytic Hydrodeoxygenation and Depolymerization of Waste Lignin to Oxygenates and Biofuels in a Continuous Flow Reactor at Atmospheric Pressure

2020 ◽  
Vol 8 (35) ◽  
pp. 13195-13205 ◽  
Author(s):  
Swathi Mukundan ◽  
Daria Boffito ◽  
Abhijit Shrotri ◽  
Luqman Atanda ◽  
Jorge Beltramini ◽  
...  
Keyword(s):  
Atmospheric Pressure ◽  
Continuous Flow ◽  
Flow Reactor ◽  
Continuous Flow Reactor

Flow Structure and Heat Transfer in Stagnation Flow CVD Reactor

2010 ◽  
Author(s):  
Nasir Memon ◽  
Yogesh Jaluria
Keyword(s):  
Heat Transfer ◽  
Flow Structure ◽  
Atmospheric Pressure ◽  
Gas Flow ◽  
Flow Reactor ◽  
Chemical Vapor ◽  
Design Parameters ◽  
Stagnation Flow ◽  
Inlet Length ◽  
The Impact

An experimental study is undertaken to investigate the flow structure and heat transfer in a stagnation flow Chemical Vapor Deposition (CVD) reactor at atmospheric pressure. It is critical to develop models that predict flow patterns in such a reactor to achieve uniform deposition across the substrate. Free convection can negatively affect the gas flow as cold inlet gas impinges on the heated substrate, leading to vortices and disturbances in the normal flow path. This experimental research will be used to understand the buoyancy-induced and momentum-driven flow structure encountered in an impinging jet CVD reactor. Investigations are conducted for various operating and design parameters. A modified stagnation flow reactor is built where the height between the inlet and substrate is reduced when compared to a prototypical stagnation flow reactor. By operating such a reactor at certain Reynolds and Grashof numbers it is feasible to sustain smooth and vortex free flow at atmospheric pressure. The modified stagnation flow reactor is compared to other stagnation flow geometries with either a varied inlet length or varied heights between the inlet and substrate. Comparisons are made to understand the impact of such geometric changes on the flow structure and the thermal boundary layer. In addition, heat transfer correlations are obtained for the substrate temperature. Overall, the results obtained provide guidelines for curbing the effects of buoyancy and for improving the flow field to obtain greater film uniformity when operating a stagnation flow CVD reactor at atmospheric pressure.

Sign in / Sign up

Export Citation Format

Share Document