Aerobic Granular Sludge for Dye Biodegradation in a Sequencing Batch Reactor With Anaerobic/Aerobic Cycles

2016 ◽  
Vol 44 (4) ◽  
pp. 438-443 ◽  
Author(s):  
Shabnam Sadri Moghaddam ◽  
Mohammad Reza Alavi Moghaddam
Keyword(s):  
Sequencing Batch Reactor ◽  
Batch Reactor ◽  
Granular Sludge ◽  
Aerobic Granular Sludge

Start-up of an aerobic granular sequencing batch reactor for the treatment of winery wastewater

2009 ◽  
Vol 60 (4) ◽  
pp. 1049-1054 ◽  
Author(s):  
S. López–Palau ◽  
J. Dosta ◽  
J. Mata-Álvarez
Keyword(s):  
Organic Matter ◽  
Sequencing Batch Reactor ◽  
Batch Reactor ◽  
Particle Diameter ◽  
Granular Sludge ◽  
Average Density ◽  
Aerobic Granular Sludge ◽  
Organic Load ◽  
Winery Wastewater ◽  
Start Up

Aerobic granular sludge was cultivated in a sequencing batch reactor (SBR) in order to remove the organic matter present in winery wastewater. The formation of granules was performed using a synthetic substrate. The selection parameter was the settling time, as well as the alternation of feast-famine periods, the air velocity and the height/diameter ratio of the reactor. After 10 days of operation under these conditions, the first aggregates could be observed. Filamentous bacteria were still present in the reactor but they disappeared progressively. During the start-up, COD loading was increased from 2.7 to 22.5 kg COD/(m3 day) in order to obtain a feast period between 30 and 60 minutes. At this point, granules were quite round, with a particle diameter between 3.0 and 4.0 mm and an average density of 6 g L−1. After 120 days of operation, synthetic media was replaced by real winery wastewater, with a COD loading of 6 kg COD/(m3 day). The decrease of the organic load implied a reduction of the aggregate diameter and a density increase up to 13.2 g L−1. The effluent was free of organic matter and the solids concentration in the reactor reached 6 g VSS L−1.

Adsorption of Cd(ii) from aqueous solution by biogenic selenium nanoparticles

RSC Advances ◽  
2016 ◽  
Vol 6 (18) ◽  
pp. 15201-15209 ◽  
Author(s):  
Fanghui Yuan ◽  
Chao Song ◽  
Xuefei Sun ◽  
Linrui Tan ◽  
Yunkun Wang ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Sequencing Batch Reactor ◽  
High Efficiency ◽  
Batch Reactor ◽  
Granular Sludge ◽  
Selenium Nanoparticles ◽  
Aerobic Granular Sludge ◽  
Biogenic Selenium Nanoparticles

BioSeNPs, which were produced by aerobic granular sludge in a sequencing batch reactor, could be used to remove cadmium from aqueous solution with high efficiency.

scholarly journals The treatment of solvent recovery raffinate by aerobic granular sludge in a pilot-scale sequencing batch reactor

2015 ◽  
Vol 13 (3) ◽  
pp. 746-757 ◽  
Author(s):  
Bei Long ◽  
Chang-zhu Yang ◽  
Wen-hong Pu ◽  
Jia-kuan Yang ◽  
Guo-sheng Jiang ◽  
...  
Keyword(s):  
Suspended Solids ◽  
Sequencing Batch Reactor ◽  
Batch Reactor ◽  
Granular Sludge ◽  
Pilot Scale ◽  
Volume Index ◽  
Aerobic Granular Sludge ◽  
Average Particle ◽  
Solvent Recovery ◽  
Mixed Liquor

Mature aerobic granular sludge (AGS) was inoculated for the start-up of a pilot-scale sequencing batch reactor for the treatment of high concentration solvent recovery raffinate (SRR). The proportion of simulated wastewater (SW) (w/w) in the influent gradually decreased to zero during the operation, while volume of SRR gradually increased from zero to 10.84 L. AGS was successfully domesticated after 48 days, which maintained its structure during the operation. The domesticated AGS was orange, irregular, smooth and compact. Sludge volume index (SVI), SV30/SV5, mixed liquor volatile suspended solids/mixed liquor suspended solids (MLVSS/MLSS), extracellular polymeric substances, proteins/polysaccharides, average particle size, granulation rate, specific oxygen utilization rates (SOUR)H and (SOUR)N of AGS were about 38 mL/g, 0.97, 0.52, 39.73 mg/g MLVSS, 1.17, 1.51 mm, 96.66%, 47.40 mg O2/h g volatile suspended solids (VSS) and 8.96 mg O2/h g VSS, respectively. Good removal effect was achieved by the reactor. Finally, the removal rates of chemical oxygen demand (COD), total inorganic nitrogen (TIN), NH4+-N and total phosphorus (TP) were more than 98%, 96%, 97% and 97%, respectively. The result indicated gradually increasing the proportion of real wastewater in influent was a useful domestication method, and the feasibility of AGS for treatment of high C/N ratio industrial wastewater.

Sequencing batch reactor (SBR) as optimal method for production of granular activated sludge (GAS) – fluid dynamic investigations

2007 ◽  
Vol 55 (8-9) ◽  
pp. 151-158 ◽  
Author(s):  
B.E. Zima ◽  
L. Díez ◽  
W. Kowalczyk ◽  
A. Delgado
Keyword(s):  
Multiphase Flow ◽  
Activated Sludge ◽  
Sequencing Batch Reactor ◽  
Fluid Dynamic ◽  
Batch Reactor ◽  
Aerobic Condition ◽  
Granular Sludge ◽  
Aerobic Granular Sludge ◽  
Major Influence ◽  
Optimal Method

Fluid dynamic investigations of multiphase flow (fluid, air, granules) in a sequencing batch reactor (SBR) are presented. SBR can be considered as an attractive technology for cultivation of granular activated sludge (GAS). Granulation is a complicated process and its mechanism is not fully understood yet. Many factors influence the formation and structure of aerobic granular sludge in a bioreactor. Extracellular polymer substances (EPS) and superficial gas velocity (SGV) play a crucial role for granules formation. Additionally, it is supposed that EPS production is stimulated by mechanical forces. It is also assumed that hydrodynamic effects have a major influence on the formation, shape and size of GAS in SBR under aerobic condition. However, the influence of stress on granulation is poorly investigated. Thus, in the present paper, fluid dynamic investigations of multiphase flow in a SBR, particularly effect of normal and shear strain, are reported. In order to analyse multiphase flow in the SBR, optical in-situ techniques with particle image velocimetry (PIV) and particle tracking velocimetry (PTV) are implemented. Obtained results show a characteristic flow pattern in a SBR. It is pointed out that additional effects like particle-wall collisions, inter particle collisions, erosion can also affect significantly granules formation.

scholarly journals Settling properties of aerobic granular sludge (AGS) and aerobic granular sludge molasses (AGSM)

2018 ◽  
Vol 34 ◽  
pp. 02022
Author(s):  
Azlina Mat Saad ◽  
Farrah Aini Dahalan ◽  
Naimah Ibrahim ◽  
Sara Yasina Yusuf ◽  
Siti Aqlima Ahmad ◽  
...  
Keyword(s):  
Industrial Wastewater ◽  
Sequencing Batch Reactor ◽  
Settling Velocity ◽  
Batch Reactor ◽  
Granular Sludge ◽  
Aerobic Granular Sludge ◽  
X Ray ◽  
Conventional Activated Sludge ◽  
Physiological Structure ◽  
Granulation Technology

Aerobic granulation technology is applied to treat domestic and industrial wastewater. The Aerobic granular sludge (AGS) cultivated has strong properties that appears to be denser and compact in physiological structure compared to the conventional activated sludge. It offers rapid settling for solid:liquid separation in wastewater treatment. Aerobic granules were developed using sequencing batch reactor (SBR) with intermittent aerobic – anaerobic mode with 8 cycles in 24 hr. This study examined the settling velocity performance of cultivated aerobic granular sludge (AGS) and aerobic granular sludge molasses (AGSM). The elemental composition in both AGS and AGSM were determined using X-ray fluorescence (XRF). The results showed that AGSM has higher settling velocity 30.5 m/h compared to AGS.

Sign in / Sign up

Export Citation Format

Share Document