Effects of physico-chemical pre-treatment on the performance of an upflow anaerobic sludge blanket (UASB) reactor treating textile wastewater: application of full factorial central composite design

2015 ◽  
Vol 93 (5) ◽  
pp. 808-818 ◽  
Author(s):  
Akshaya K. Verma ◽  
Puspendu Bhunia ◽  
Rajesh R. Dash ◽  
Rajeshwar D. Tyagi ◽  
Rao Y. Surampalli ◽  
...  
Keyword(s):  
Central Composite Design ◽  
Textile Wastewater ◽  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Anaerobic Sludge ◽  
Physico Chemical ◽  
Pre Treatment ◽  
Anaerobic Sludge Blanket ◽  
Full Factorial ◽  
Central Composite

Impact of ozone pre-treatment on the performance of upflow anaerobic sludge blanket treating pre-treated grain distillery wastewater

2014 ◽  
Vol 70 (10) ◽  
pp. 1702-1708 ◽  
Author(s):  
L. Robertson ◽  
T. J. Britz ◽  
G. O. Sigge
Keyword(s):  
Unsaturated Fatty Acids ◽  
Oxygen Demand ◽  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Anaerobic Sludge ◽  
Reactor Performance ◽  
Distillery Wastewater ◽  
Pre Treatment ◽  
Anaerobic Sludge Blanket ◽  
Performance Results

Two 2 L laboratory-scale upflow anaerobic sludge blanket (UASB) reactors were operated for 277 days. The substrate of the control reactor (Rc) contained grain distillery wastewater (GDWW) that had undergone coagulant pre-treatment, and the substrate of the second UASB reactor consisted of GDWW that had undergone coagulant pre-treatment and ozone pre-treatment (Ro). Both reactors treated pre-treated GDWW successfully at ca. 9 kgCOD m−3 d−1. Chemical oxygen demand (COD) reductions of ca. 96% for Rc and 93% for Ro were achieved. Fats, oils and grease (FOG) reductions (%) showed variations throughout the study, and reductions of ca. 88 and 92% were achieved for Rc and Ro, respectively. Rc produced more biogas, and the methane percentage was similar in both reactors. UASB granule washout in Rc suggested possible toxicity of unsaturated fatty acids present in non-ozonated substrate. The feasibility of FOG removal was demonstrated as both reactors successfully treated pre-treated GDWW. Better results were obtained for Ro effluent during post-ozonation. The ozone pre-treatment possibly led to easier degradable wastewater, and better results could potentially be obtained when other post-treatment steps are applied. Ozone pre-treatment did not, however, show an added benefit in the reactor performance results.

scholarly journals Microbial Removal of Pb(II) Using an Upflow Anaerobic Sludge Blanket (UASB) Reactor

Catalysts ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 512
Author(s):  
Jeremiah Chimhundi ◽  
Carla Hörstmann ◽  
Evans M. N. Chirwa ◽  
Hendrik G. Brink
Keyword(s):  
Treatment Process ◽  
Removal Rate ◽  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Anaerobic Sludge ◽  
Reduction Potentials ◽  
Oxidation Reduction ◽  
Anaerobic Sludge Blanket ◽  
Microbial Removal ◽  
Maximum Removal

The main objective of this study was to achieve the continuous biorecovery and bioreduction of Pb(II) using an industrially obtained consortia as a biocatalyst. An upflow anaerobic sludge blanket reactor was used in the treatment process. The bioremediation technique that was applied made use of a yeast extract as the microbial substrate and Pb(NO3)2 as the source of Pb(II). The UASB reactor exhibited removal efficiencies of between 90 and 100% for the inlet Pb concentrations from 80 to 2000 ppm and a maximum removal rate of 1948.4 mg/(L·d) was measured. XRD and XPS analyses of the precipitate revealed the presence of Pb0, PbO, PbS and PbSO4. Supporting experimental work carried out included growth measurements, pH, oxidation–reduction potentials and nitrate levels.

KINETIC MODELS FOR PREDICTION OF COD EFFLUENT FROM UPFLOW ANAEROBIC SLUDGE BLANKET (UASB) REACTOR FOR CANNERY SEAFOOD WASTEWATER TREATMENT

2016 ◽  
Vol 78 (5-6) ◽  
Author(s):  
Sunwanee Jijai ◽  
Chairat Siripatana ◽  
Sompong O-Thong ◽  
Norli Ismail
Keyword(s):  
Palm Oil ◽  
Kinetic Models ◽  
Second Order ◽  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Anaerobic Sludge ◽  
Substrate Removal ◽  
Reactor Kinetic ◽  
Palm Oil Mill ◽  
Anaerobic Sludge Blanket

The three identical lab-scale upflow anaerobic sludge blanket (UASB) reactors were operated continuously for treating cannery seafood wastewater at seven hydraulic retention times (HRTs) of 5, 4, 3, 2, 1, 0.5 and 0.25 days. The different of granule sizes from three sources: a cassava factory (CS), a seafood factory (SS), and a palm oil mill (PS), average sizes in the range 1.5-1.7, 0.7-1.0 and 0.1-0.2 mm respectively were used as inocula for anaerobic digestion. The UASB-R1 used only granules from seafood factory (R1-SS), the UASB-R2 used mixed granules from seafood with cassava factory (R2-SS+CS) and the UASB-R3 used mixed granules from seafood factory with palm oil mill (R3-SS+PS). In this study selected mathematical models including Monod, Contois, Grau second-order and modified Stover-Kicannon kinetic models were applied to determine the substrate removal kinetics of UASB reactor. Kinetic parameters were determined through linear regression using experimental data obtained from the steady-state experiment and subsequently used to predict effluent COD. The results showed that Grau second-order and modified Stover-Kicannon kinetic models were more suitable than that of others for predicting the effluent COD, with high the correlation coefficient (R2). In addition, the UASB-R2 from mixed granules with cassava factory (SS+CS) gave the best performance and highest coefficient value.

Treatment of raw sewage in a temperate climate using a UASB reactor and the hanging sponge cubes process

1997 ◽  
Vol 36 (6-7) ◽  
pp. 433-440 ◽  
Author(s):  
Lalit K. Agrawal ◽  
Yasuhiro Ohashi ◽  
Etsuo Mochida ◽  
Hiroyuki Okui ◽  
Yasuko Ueki ◽  
...  
Keyword(s):  
Ammonia Oxidation ◽  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Temperate Climate ◽  
Anaerobic Sludge ◽  
Treatment Efficiency ◽  
Oxidation Rates ◽  
Air Intake ◽  
Anaerobic Sludge Blanket ◽  
Digested Sewage Sludge

The treatability of raw sewage in a temperate climate (wintertime around 10–20°C) using an upflow anaerobic sludge blanket (UASB) reactor and the hanging sponge cubes process was evaluated. After being seeded with digested sewage sludge, a 47.1 L UASB reactor was continuously operated for more than 2 years by feeding raw sewage, which had average COD around 300 mg/L (41% soluble). During summertime at an HRT of 7 h, effluent COD approximately 70 mg/L total, 50 mg/L soluble and BOD5 20 mg/L total, 12 mg/L soluble was obtained. During wintertime also, treatment efficiency and process stability was good. With the hanging sponge cubes process using the effluent of the UASB reactor treating raw sewage, the following results were obtained. The ammonia oxidation rates of 1.9 and 3.5 g NH4-N·m−2·d−1 in a downflow hanging sponge cubes biofilter, under natural air intake only were obtained during wintertime and summertime, respectively. With post-denitrification and an external carbon source, 84% in average N (NO3+NO2) was removed with an HRT of less than 1 hour and in the temperature range of 13 to 30°C using an upflow submerged hanging sponge bed bioreactor, under anaerobic conditions. The overall system using a UASB reactor and the hanging sponge cubes process could be quite an attractive treatment alternative.

scholarly journals Organic Matter Removal in a Simultaneous Nitrification-Denitrification Process Using Fixed-Film System.

2021 ◽  
Author(s):  
Perla Gonzalez ◽  
Ana Aguilar Ruiz ◽  
Andrea Reynosa Varela ◽  
Ulises Durán Hinojosa ◽  
Marco Garzón Zuñiga ◽  
...  
Keyword(s):  
Organic Matter ◽  
Nitrogen Compound ◽  
Upflow Anaerobic Sludge Blanket ◽  
Swine Wastewater ◽  
Uasb Reactor ◽  
Anaerobic Sludge ◽  
Organic Matter Removal ◽  
Fixed Film ◽  
Suspended Biomass ◽  
Anaerobic Sludge Blanket

Abstract This study focused on evaluating different support media for COD and nitrogen compound removal from an Upflow Anaerobic Sludge Blanket (UASB) reactor fed with swine wastewater. Maximum specific nitrification (MSNA) and denitrification (MSDA) activity tests were performed in two fixed-film systems with (1) polyurethane foam (R1) and (2) polyethylene rings (R2). The results showed that the R2 system performed more efficiently than R1, reaching organic matter removal of 77 ± 8% and nitrogen of 98 ± 4%, attributed to higher specific denitrifying activity recorded (5.3 ± 0.34 g NO3--N/g VTS ∙h). In this sense, MSDA tests indicated that the suspended biomass was responsible for at least 70% of nitrogen removal in the form of ammonium compared with 20% attributed to biomass in the form of biofilm. On the other hand, 40 ± 5% of initial nitrogen could not be quantified in the system effluents, but 10 ± 1% was attributed to loss by volatilization. According to the analyses, the previous information infers the development of simultaneous nitrification-denitrification (SND) routes. Respect to the analyses of microbial diversity and abundance in the biofilm of R2 rings, the presence of the genus Pseudomonas dominated the prokaryotic community of the system in 54.4%.

Acid Endurance and Sorption of Zn2+ of Anaerobic Granular Sludge Acclimated by Flue Gas Pretreatment Wastewater

2013 ◽  
Vol 634-638 ◽  
pp. 182-186
Author(s):  
Juan Wang ◽  
Qin Zhong
Keyword(s):  
Flue Gas ◽  
Ph Value ◽  
Granular Sludge ◽  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Anaerobic Sludge ◽  
Anaerobic Granular Sludge ◽  
Methanogenic Activity ◽  
Activity Inhibition ◽  
Anaerobic Sludge Blanket

With the aim to use anaerobic granular sludge, the methanogenic activity inhibition and recovery of anaerobic granular sludge from an industrial anaerobic reactor (s1) were investigated by measuring the methane volume at low pH. A lab-scale upflow anaerobic sludge blanket (UASB) reactor was inoculated with s1.s1 was used to remove Zn2+ in wastewater. The results show that activity of s1 is similar when the pH value is 6.5 to 7.0. The methane volume is obviously decreased when the pH value is 6.0. The activity is completely inhibited when the pH value is 4.5. The activity is fully recovered when the pH is above 6.5 and hardly recovers when the pH fell to 4.5. The main Zn2+ removal mechanism is chemical adsorption.

Sign in / Sign up

Export Citation Format

Share Document