The stability of water- and fat-soluble vitamin in dentifrices according to pH level and storage type

2015 ◽  
Vol 30 (2) ◽  
pp. 191-199 ◽  
Author(s):  
Jung-Eun Park ◽  
Ki-Eun Kim ◽  
Yong-Jun Choi ◽  
Yong-Duk Park ◽  
Ha-Jeong Kwon
Keyword(s):  
The Stability ◽  
Ph Level ◽  
Stability Of Water ◽  
And Storage ◽  
Storage Type

scholarly journals Variability of Water-Soluble Forms of Choline Concentrations in Human Milk during Storage, after Pasteurization, and among Women

Nutrients ◽  
2019 ◽  
Vol 11 (12) ◽  
pp. 3024 ◽  
Author(s):  
Sara Moukarzel ◽  
Alejandra M. Wiedeman ◽  
Lynda S. Soberanes ◽  
Roger A. Dyer ◽  
Sheila M. Innis ◽  
...  
Keyword(s):  
Human Milk ◽  
Infant Development ◽  
Sole Source ◽  
Individual Variability ◽  
Water Soluble ◽  
Total Water ◽  
Breastfed Infants ◽  
The Stability ◽  
Stability Of Water ◽  
And Storage

Choline is critical for infant development and mother’s milk is the sole source of choline for fully breastfed infants until six months of age. Human milk choline consists to 85% of water-soluble forms of choline including free choline (FC), phosphocholine (PhosC), and glycerophosphocholine (GPC). Donor milk requires safe handling procedures such as cold storage and pasteurization. However, the stability of water-soluble forms of choline during these processes is not known. The objectives of this research were to determine the effect of storage and pasteurization on milk choline concentration, and the diurnal intra- and inter-individual variability of water-soluble choline forms. Milk samples were collected from healthy women who were fully breastfeeding a full-term, singleton infant <6 months. Milk total water-soluble forms of choline, PhosC, and GPC concentrations did not change during storage at room temperature for up to 4 h. Individual and total water-soluble forms of choline concentrations did not change after storage for 24 h in the refrigerator or for up to one week in the household freezer. Holder pasteurization decreased PhosC and GPC, and thereby total water-soluble choline form concentrations by <5%. We did not observe diurnal variations in PhosC and total water-soluble forms of choline concentrations, but significant differences in FC and GPC concentrations across five sampling time points throughout one day. In conclusion, these outcomes contribute new knowledge for the derivation of evidence-informed guidelines for the handling and storage of expressed human milk as well as the development of optimized milk collection and storage protocols for research studies.

Preparation, Stabilization and Some Properties of Purified Human Plasmin*

1964 ◽  
Vol 11 (01) ◽  
pp. 075-084 ◽  
Author(s):  
Daniel L Kline ◽  
Jacob B Fishman ◽  
Keyword(s):  
Plasminogen Activator ◽  
Stable Form ◽  
Neutral Ph ◽  
The Stability ◽  
And Storage

Summary1. Lysine increased the solubility, decreased the SK requirement and increased the stability of plasmin prepared from purified plasminogen by SK activation.2. A procedure is presented for the rapid and quantitative conversion of plasminogen to plasmin and storage of the plasmin in stable form at neutral pH as a lyophilized powder.3. Approximately 10% for the plasminogen molecule was split off during its activation. No carbohydrate was lost.4. The plasmin isolated was homogeneous in the ultracentrifuge at pH 2.5 and was quantitatively convertible to plasminogen activator by the addition of SK.

Evaluation of the quality and the stability of human samples for analysis and storage in biorepository

2018 ◽  
Vol 50 (1) ◽  
Author(s):  
Leonardo André Lange ◽  
Caroline Galgowski ◽  
Anna Cecília Roncalio ◽  
Fabiana Sehnem ◽  
Grabriela Borgmann ◽  
...  
Keyword(s):  
Human Samples ◽  
The Stability ◽  
And Storage

Effect of particle concentration on the stability of water-based SiO2 nanofluid

2021 ◽  
Vol 379 ◽  
pp. 457-465
Author(s):  
Tiancheng Zhang ◽  
Quanle Zou ◽  
Zhiheng Cheng ◽  
Zihan Chen ◽  
Ying Liu ◽  
...  
Keyword(s):  
Particle Concentration ◽  
Water Based ◽  
The Stability ◽  
Stability Of Water

scholarly journals Eggs viability of Aedes aegypti Linnaeus (Diptera, Culicidae) under different environmental and storage conditions in Manaus, Amazonas, Brazil

2016 ◽  
Vol 77 (2) ◽  
pp. 396-401 ◽  
Author(s):  
V. C. Soares-Pinheiro ◽  
W. Dasso-Pinheiro ◽  
J. M. Trindade-Bezerra ◽  
W. P. Tadei
Keyword(s):  
Aedes Aegypti ◽  
Storage Conditions ◽  
Amazon Region ◽  
Storage Site ◽  
Egg Hatching ◽  
Plastic Bag ◽  
The Mean ◽  
And Storage ◽  
Storage Type ◽  
Hatching Rates

Abstract The viability of Aedes aegypti eggs was assessed in the Amazon region. The eggs were maintained under different conditions: indoors (insectarium) and outdoors (natural environment), as well as in different storage types (plastic cup, paper envelope, plastic bag) for different days. Egg viability was measured as the mean of hatchings observed from egg-bearing sheets of filter paper immersed in water, using three sheets randomly selected from each storage type and at both sites. There were significant differences in the viability of Ae. aegypti eggs with respect to the location (F=30.40; DF=1; P<0.0001), storage type (F=17.66; DF=2; P<0.0001), and time of storage (F=49.56; DF=9; P<0.0001). The interaction between storage site versus storage type was also significant (F=15.96; DF=2; P<0.0001). A higher hatching mean was observed for the eggs kept in the insectarium than for those outdoors (32.38 versus 7.46). Hatching rates of egg batches stored for 12 to 61 days ranged between 84 and 90%. A reduction was observed between 89 and 118 days, with values of 63 and 48%, respectively. With respect to type of storage, mean egg hatching was higher for the eggs in plastic cups (44.46). It was concluded that the viability of the eggs of Ae. aegypti in the Amazon region remains high up to 4 months, after which it declines drastically, although in this study hatching occurred for up to 8 months in very low percentages.

Effect of pH and temperature on the infectivity of human coronavirus 229E

1989 ◽  
Vol 35 (10) ◽  
pp. 972-974 ◽  
Author(s):  
Alain Lamarre ◽  
Pierre J. Talbot
Keyword(s):  
Incubation Period ◽  
Storage Conditions ◽  
Viral Infectivity ◽  
Human Coronavirus ◽  
Virus Growth ◽  
The Stability ◽  
And Storage ◽  
Influence Of Ph ◽  
Human Coronavirus 229E

The stability of human coronavirus 229E infectivity was maximum at pH 6.0 when incubated at either 4 or 33 °C. However, the influence of pH was more pronounced at 33 °C. Viral infectivity was completely lost after a 14-day incubation period at 22, 33, or 37 °C but remained relatively constant at 4 °C for the same length of time. Finally, the infectious titer did not show any significant reduction when subjected to 25 cycles of thawing and freezing. These studies will contribute to optimize virus growth and storage conditions, which will facilitate the molecular characterization of this important pathogen.Key words: coronavirus, pH, temperature, infectivity, human coronavirus.

scholarly journals Pre-Drawn Syringes of Comirnaty for an Efficient COVID-19 Mass Vaccination: Demonstration of Stability

Pharmaceutics ◽  
2021 ◽  
Vol 13 (7) ◽  
pp. 1029
Author(s):  
Francesca Selmin ◽  
Umberto M. Musazzi ◽  
Silvia Franzè ◽  
Edoardo Scarpa ◽  
Loris Rizzello ◽  
...  
Keyword(s):  
Mechanical Stress ◽  
Real Life ◽  
Storage Conditions ◽  
Lipid Nanoparticles ◽  
Mass Vaccination ◽  
Hydrodynamic Diameter ◽  
The Us ◽  
Real Mass ◽  
The Stability ◽  
And Storage

Moving towards a real mass vaccination in the context of COVID-19, healthcare professionals are required to face some criticisms due to limited data on the stability of a mRNA-based vaccine (Pfizer-BioNTech COVID-19 Vaccine in the US or Comirnaty in EU) as a dose in a 1 mL-syringe. The stability of the lipid nanoparticles and the encapsulated mRNA was evaluated in a “real-life” scenario. Specifically, we investigated the effects of different storing materials (e.g., syringes vs. glass vials), as well as of temperature and mechanical stress on nucleic acid integrity, number, and particle size distribution of lipid nanoparticles. After 5 h in the syringe, lipid nanoparticles maintained the regular round shape, and the hydrodynamic diameter ranged between 80 and 100 nm with a relatively narrow polydispersity (<0.2). Samples were stable independently of syringe materials and storage conditions. Only strong mechanical stress (e.g., shaking) caused massive aggregation of lipid nanoparticles and mRNA degradation. These proof-of-concept experiments support the hypothesis that vaccine doses can be safely prepared in a dedicated area using an aseptic technique and transferred without affecting their stability.

AN ADVANCED ADAPTIVE FINITE ELEMENT CODE APPLIED FOR COATING-SUBSTRATE SIMULATION

2011 ◽  
Vol 03 (01n02) ◽  
pp. 91-107 ◽  
Author(s):  
JÜRGEN LEOPOLD ◽  
KATRIN HELLER ◽  
ARNDT MEYER ◽  
REINER WOHLGEMUTH
Keyword(s):  
Finite Element ◽  
Fe Simulation ◽  
Scale Up ◽  
Computational Time ◽  
Adaptive Finite Element ◽  
Workpiece Surface ◽  
Coated Tools ◽  
Geometrical Simulation ◽  
The Stability ◽  
And Storage

The stability of coating-substrate systems influences the chip formation and the surface integrity of the new generated workpiece surface, too. Using finite element (FE) simulation, deformations, strains and stresses in coated tools, caused by external and internal loads, can be computed on a microscopic scale. Since both, the whole macroscopic tool (in mm-scale) and the microscopic coating layers (in μm-scale up to nm-scale) must be included in the same geometrical simulation model, graded high-resolution FE meshes must be used. Nevertheless, the number of nodes in the 3D computational FE grid reaches some millions, leading to large computational time and storage requirements. For this reason, an advanced adaptive finite element (AAFEM) software has been developed and used for the simulation.

Sign in / Sign up

Export Citation Format

Share Document