scholarly journals SEDIMENT TRANSPORT DUE TO BREAKING WAVES

1986 ◽  
Vol 1 (20) ◽  
pp. 111 ◽  
Author(s):  
Tomoya Shibayama ◽  
Akihiko Higuchi ◽  
Kiyoshi Horikawa
Keyword(s):  
Water Wave ◽  
Surf Zone ◽  
Breaking Waves ◽  
Wave Flume ◽  
Suspension Process ◽  
Large Vortex ◽  
Sand Movement ◽  
Bed Materials ◽  
Deep Water Wave ◽  
Two Parameters

In the surf zone, the agitation of the bed materials by breaking waves is strong and the suspended sand concentration in the vicinity of the wave plunging point is extremely high. Sand movement in this region was observed and sand concentration was measured in a wave flume. The sand movement in the region was divided into the following two categories: 1) sand suspension due to the large vortex which is created by wave plunging, and 2) sand deposition under turbulent flow. The condition for exciting this suspension process was considered and the result was well explained by the two parameters which are the deep water wave steepness and the bottom slope. Then a numerical model of the sediment suspension process was formulated and the process was well simulated by the model.

scholarly journals MODE AND PERIOD OF SAND TRANSPORT IN THE SURF ZONE

1974 ◽  
Vol 1 (14) ◽  
pp. 47 ◽  
Author(s):  
Benno M. Brenninkmeyer
Keyword(s):  
Deep Water ◽  
Water Wave ◽  
Surf Zone ◽  
Sediment Concentration ◽  
Sand Transport ◽  
Bed Load ◽  
Measuring Devices ◽  
Load Movement ◽  
Sand Movement ◽  
Deep Water Wave

Three almometers-water opacity measuring devices-emplaced perpendicular to the beach, measure instantaneously and continuously the sediment concentration across the surf zone. Most of the variance of the sand movement is centered in frequencies of less than 0.25 Hz and between 1.15 and 1.25 Hz. Modes and frequency of sand transport differ within each of the dynamic zones of the surf. The motion of sediment in the inner and outer surf zones is small and virtually independent of the deep water wave periods. Outside the breaker zone, bed load movement is somewhat coincident with the prevailing swell period. Lighter concentrations move predominantly with a 0.8-0.9 second periodicity. In the breaker zone, sand moves along the bottom with frequencies equal to that of both the swell and sea, but most of the power is in lower frequencies. In the breaker zone sand is rarely thrown into suspension. In the transition zone, sediment motion is largely by suspension with a period a little longer than the swell.

scholarly journals VALIDATION OF A BUOYANCY-MODIFIED TURBULENCE MODEL BY NUMERICAL SIMULATIONS OF BREAKING WAVES OVER A FIXED BAR

2018 ◽  
pp. 71
Author(s):  
Brecht Devolder ◽  
Peter Troch ◽  
Pieter Rauwoens
Keyword(s):  
Numerical Simulations ◽  
Wave Breaking ◽  
Surf Zone ◽  
Breaking Waves ◽  
Navier Stokes ◽  
Two Phase ◽  
Numerical Wave Flume ◽  
Wave Flume ◽  
Nearshore Sediment Transport ◽  
Run Up

The surf zone dynamics are governed by important processes such as turbulence generation , nearshore sediment transport , wave run-up and wave overtopping at a coastal structure. During field observations , it is very challenging to measure and quantify wave breaking turbulence . Complementary to experimental laboratory studies in a more controlled environment , numerical simulations are highly suitable to understand and quantify surf zone processes more accurately. In this study, wave propagation and wave breaking over a fixed barred beach profile is investigated using a two­ phase Navier-Stokes flow solver. We show that accurate predictions of the turbulent two-phase flow field require special attention regarding turbulence modelling. The numerical wave flume is implemented in the open­ source OpenFOAM library. The computed results (surface elevations , velocity profiles and turbulence levels) are compared against experimental measurements in a wave flume (van der A et al., 2017) .

scholarly journals HYDRODYNAMICS UNDER LARGE-SCALE REGULAR AND BICHROMATIC BREAKING WAVES

2018 ◽  
pp. 90
Author(s):  
Dominic Van der A ◽  
Joep Van der Zanden ◽  
Ming Li ◽  
James Cooper ◽  
Simon Clark ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Large Scale ◽  
Surf Zone ◽  
Experimental Studies ◽  
Breaking Waves ◽  
Irregular Waves ◽  
Small Scale ◽  
Breaking Wave ◽  
Wave Flume ◽  
Cfd Models

Multiphase CFD models recently have proved promising in modelling cross‐shore sediment transport and morphodynamics (Jacobsen et al 2014). However, modelling breaking wave turbulence remains a major challenge for these models, because it occurs at very different spatial and temporal length scales and involves the interaction between surface generated turbulence and turbulence generated in the bottom boundary layer. To an extent these challenges arise from a lack of appropriate experimental data, since most previous experimental studies involved breaking waves at small-scale, and have not permitted investigation of the turbulent boundary layer processes. Moreover, most existing studies have concentrated on regular waves, thereby excluding the flow and turbulence dynamics occurring at wave group time-scales under irregular waves within the surf zone. These limitations motivated a new experiment in the large-scale CIEM wave flume in Barcelona involving regular and irregular waves. The experiment was conducted in May-July 2017 within the HYDRALAB+ Transnational Access project HYBRID.

scholarly journals SUSPENDED AND BEDLOAD TRANSPORT IN THE SURF ZONE: IMPLICATIONS FOR SAND TRANSPORT MODELS

2017 ◽  
pp. 30 ◽  
Author(s):  
Joep van der Zanden ◽  
Dominic A. Van der A ◽  
Tom O'Donoghue ◽  
David Hurther ◽  
Ivan Caceres ◽  
...  
Keyword(s):  
Large Scale ◽  
Surf Zone ◽  
Sediment Concentration ◽  
Breaking Waves ◽  
Bedload Transport ◽  
Transport Processes ◽  
Sand Transport ◽  
Wave Flume ◽  
Load Transport ◽  
Particle Velocities

This paper presents results obtained during a large-scale wave flume experiment focused at measuring hydrodynamics and sediment transport processes in the wave breaking region. The experiment involved monochromatic plunging breaking waves over a mobile bed barred profile consisting of D50 = 0.24 mm sand. Vertical profiles of velocity, turbulence, sand concentration and sand fluxes were measured at 12 cross-shore locations, covering the shoaling region up to the inner surf zone. Particularly high-resolution profiles were obtained near the bed within the wave bottom boundary layer, using an acoustic sediment concentration and velocity profiler (ACVP). Sheet flow concentration and particle velocities were measured at two locations near the bar crest using two conductivity-based concentration measurement tanks (CCM+). Total transport rates, obtained from the evolving bed profile measurements, were decomposed into suspended and bedload transport contributions across the bar. The present paper presents a summary of the key findings of the experiment, which are used to discuss existing approaches for modeling suspended and bed load transport in the surf zone.

scholarly journals The Accelerations of a Wave Measurement Buoy Impacted by Breaking Waves in the Surf Zone

2021 ◽  
Vol 9 (2) ◽  
pp. 214
Author(s):  
Adam C. Brown ◽  
Robert K. Paasch
Keyword(s):  
Inertial Measurement Unit ◽  
Surf Zone ◽  
Spherical Wave ◽  
Breaking Waves ◽  
Measurement Unit ◽  
High Fidelity ◽  
Wave Measurement ◽  
Near Shore ◽  
Shoaling Waves ◽  
Multiple Deployments

A spherical wave measurement buoy capable of detecting breaking waves has been designed and built. The buoy is 16 inches in diameter and houses a 9 degree of freedom inertial measurement unit (IMU). The orientation and acceleration of the buoy is continuously logged at frequencies up to 200 Hz providing a high fidelity description of the motion of the buoy as it is impacted by breaking waves. The buoy was deployed several times throughout the winter of 2013–2014. Both moored and free-drifting data were acquired in near-shore shoaling waves off the coast of Newport, OR. Almost 200 breaking waves of varying type and intensity were measured over the course of multiple deployments. The characteristic signature of spilling and plunging breakers was identified in the IMU data.

scholarly journals Development and Validation of Quasi-Eulerian Mean Three-Dimensional Equations of Motion Using the Generalized Lagrangian Mean Method

2021 ◽  
Vol 9 (1) ◽  
pp. 76
Author(s):  
Duoc Nguyen ◽  
Niels Jacobsen ◽  
Dano Roelvink
Keyword(s):  
Surface Waves ◽  
Deep Water ◽  
Surf Zone ◽  
Equations Of Motion ◽  
Three Dimensional ◽  
Breaking Waves ◽  
Successful Implementation ◽  
Random Waves ◽  
Mean Motion ◽  
Generalized Lagrangian

This study aims at developing a new set of equations of mean motion in the presence of surface waves, which is practically applicable from deep water to the coastal zone, estuaries, and outflow areas. The generalized Lagrangian mean (GLM) method is employed to derive a set of quasi-Eulerian mean three-dimensional equations of motion, where effects of the waves are included through source terms. The obtained equations are expressed to the second-order of wave amplitude. Whereas the classical Eulerian-mean equations of motion are only applicable below the wave trough, the new equations are valid until the mean water surface even in the presence of finite-amplitude surface waves. A two-dimensional numerical model (2DV model) is developed to validate the new set of equations of motion. The 2DV model passes the test of steady monochromatic waves propagating over a slope without dissipation (adiabatic condition). This is a primary test for equations of mean motion with a known analytical solution. In addition to this, experimental data for the interaction between random waves and a mean current in both non-breaking and breaking waves are employed to validate the 2DV model. As shown by this successful implementation and validation, the implementation of these equations in any 3D model code is straightforward and may be expected to provide consistent results from deep water to the surf zone, under both weak and strong ambient currents.

Distributions of void fraction under breaking waves in the surf zone

2005 ◽  
Vol 32 (14-15) ◽  
pp. 1829-1840 ◽  
Author(s):  
Ashabul Hoque ◽  
Shin-ichi Aoki
Keyword(s):  
Void Fraction ◽  
Surf Zone ◽  
Breaking Waves

scholarly journals LABORATORY EXPERIMENTS ON THE INFLUENCE OF WIND ON NEARSHORE WAVE BREAKING

1988 ◽  
Vol 1 (21) ◽  
pp. 46
Author(s):  
Scott L. Douglass ◽  
J. Richard Weggel
Keyword(s):  
Wind Direction ◽  
Wave Breaking ◽  
Laboratory Experiments ◽  
Surf Zone ◽  
Breaking Waves ◽  
Wave Tank ◽  
Zone Width

The influence of wind on nearshore breaking waves was investigated in a laboratory wave tank. Breaker location, geometry, and type depended upon the wind acting on the wave as it broke. Onshore winds tended to cause waves to break earlier, in deeper water, and to spill: offshore winds tended to cause waves to break later, in shallower water, and to plunge. A change in wind direction from offshore to onshore increased the surf zone width by up to 100%. Wind's effect was greatest for waves which were near the transition between breaker types in the absence of wind. For onshore winds, it was observed that microscale breaking can initiate spilling breaking by providing a perturbation on the crest of the underlying wave as it shoals.

scholarly journals Computational Fluid Dynamics Simulation of Deep-Water Wave Instabilities Involving Wave Breaking

2021 ◽  
Vol 144 (2) ◽  
Author(s):  
Yuzhu Li ◽  
David R. Fuhrman
Keyword(s):  
Fluid Dynamics ◽  
Computational Fluid Dynamics ◽  
Deep Water ◽  
Wave Breaking ◽  
Water Wave ◽  
Class Ii ◽  
Dynamics Simulation ◽  
Class I ◽  
Wave Instabilities ◽  
Deep Water Wave

Abstract Instabilities of deep-water wave trains subject to initially small perturbations (which then grow exponentially) can lead to extreme waves in offshore regions. The present study focuses on the two-dimensional Benjamin–Feir (or modulational) instability and the three-dimensional crescent (or horseshoe) waves, also known as Class I and Class II instabilities, respectively. Numerical studies on Class I and Class II wave instabilities to date have been mostly limited to models founded on potential flow theory; thus, they could only properly investigate the process from initial growth of the perturbations to the initial breaking point. The present study conducts numerical simulations to investigate the generation and development of wave instabilities involving the wave breaking process. A computational fluid dynamics (CFD) model solving Reynolds-averaged Navier–Stokes (RANS) equations coupled with a turbulence closure model in terms of the Reynolds stress model is applied. Wave form evolutions, Fourier amplitudes, and the turbulence beneath the broken waves are investigated.

scholarly journals Wave-Induced Sediment Motion Beyond the Surf Zone: Case Study of Lubiatowo (Poland)

2015 ◽  
Vol 62 (1-2) ◽  
pp. 27-39 ◽  
Author(s):  
Grzegorz R. Cerkowniak ◽  
Rafał Ostrowski ◽  
Magdalena Stella
Keyword(s):  
Surf Zone ◽  
Shear Stresses ◽  
Research Station ◽  
Wave Parameters ◽  
Sea Bottom ◽  
Theoretical Investigations ◽  
Deep Water Wave ◽  
Offshore Wave ◽  
Wave Induced

AbstractThe paper presents results of field and theoretical investigations of a natural sandy shore located near the IBW PAN Coastal Research Station in Lubiatowo (Poland, the south Baltic Sea). The study site displays multi-bar cross-shore profiles that intensively dissipate wave energy, mostly by breaking. The main field data comprise offshore wave parameters and three cross-shore bathymetric profiles. Waveinduced nearbed velocities and bed shear stresses are theoretically modelled for weak, moderate, strong and extreme storm conditions to determine sediment motion regimes at various locations on the seaward boundary of the surf zone. The paper contains a discussion on the depth of closure concept, according to which the offshore range of sea bottom changes can be determined by the extreme seasonal deep-water wave parameters.

Sign in / Sign up

Export Citation Format

Share Document