scholarly journals Development of very-high-frequency field-intensity standards

1950 ◽  
Vol 44 (5) ◽  
pp. 527 ◽  
Author(s):  
F.M. Greene ◽  
M. Solow
Keyword(s):  
Field Intensity ◽  
High Frequency ◽  
High Frequency Field ◽  
Very High Frequency ◽  
Frequency Field ◽  
Very High

R&D of a Microwave Field Intensity Standard Device for the Calibration of High-Frequency Field Probe

2014 ◽  
Vol 631-632 ◽  
pp. 333-338
Author(s):  
Hai Tao Yu
Keyword(s):  
Field Intensity ◽  
High Frequency ◽  
Electromagnetic Compatibility ◽  
Microwave Field ◽  
Field Amplitude ◽  
High Frequency Field ◽  
Frequency Range ◽  
Standard Device ◽  
Frequency Field ◽  
Maximum Field

The purpose of this article is to establish a microwave field intensity standard device to calibrate the high-frequency field probe with frequency range from 1GHz to 18GHz and maximum field amplitude up to 10mW/cm2(200V/m),which can satisfy the calibration requirements of field probe for electromagnetic compatibility test.

Experimental Investigation of very High Frequency Slot Antenna on M-60A-1 Tank

1977 ◽  
Author(s):  
D. V. Campbell ◽  
William Kennebeck ◽  
A. Zanella ◽  
Paul Sexton
Keyword(s):  
Experimental Investigation ◽  
High Frequency ◽  
Slot Antenna ◽  
Very High Frequency ◽  
Very High

A collision feedback based multiple access control protocol for very high frequency data exchange system in E-navigation

2021 ◽  
pp. 1-16
Author(s):  
Xu Hu ◽  
Bin Lin ◽  
Ping Wang ◽  
Hongguang Lyu ◽  
Tie-Shan Li
Keyword(s):  
Access Control ◽  
High Frequency ◽  
Multiple Access ◽  
Data Exchange ◽  
High Frequency Data ◽  
Frequency Data ◽  
Exchange System ◽  
Very High Frequency ◽  
Time Division ◽  
Very High

Abstract The very high frequency data exchange system (VDES) is promising in promoting electronic navigation (E-navigation) and improving navigation safety. The multiple access control (MAC) protocol is crucial to the transmission performance of VDES. The self-organising time division multiple access (SOTDMA) protocol, as the only access mode given by current recommendations, leads to a high rate of transmission collisions in the traditional automatic identification system (AIS), especially with heavy traffic loads. This paper proposes a novel feedback based time division multiple access (FBTDMA) protocol to address the problems caused by SOTDMA, such that collision of transmissions can be avoided in information transmission among vessels. Simulation results demonstrate that the proposed FBTDMA outperforms the traditional SOTDMA in terms of channel utilisation and throughput, and significantly reduces the transmission collision rate. The study is expected to provide insights into VDES standardisation and E-navigation modernisation.

scholarly journals Measurement of Electrical Properties of Superconducting YBCO Thin Films in the VHF Range

Materials ◽  
2021 ◽  
Vol 14 (12) ◽  
pp. 3360
Author(s):  
Yakir Dahan ◽  
Eldad Holdengreber ◽  
Elichai Glassner ◽  
Oz Sorkin ◽  
Shmuel E. Schacham ◽  
...  
Keyword(s):  
Thin Films ◽  
Theoretical Model ◽  
Quality Factor ◽  
High Frequency ◽  
Unit Length ◽  
Superconducting Thin Films ◽  
Electrical Parameters ◽  
Very High Frequency ◽  
Production Constraints ◽  
Very High

A new measurement technique of electrical parameters of superconducting thin films at the Very High Frequency (VHF) range is described, based on resonators with microstrip (MS) structures. The design of an optimal resonator was achieved, based on a thorough theoretical analysis, which is required for derivation of the exact configuration of the MS. A theoretical model is presented, from which an expression for the attenuation of a MS line can be derived. Accordingly, simulations were performed, and an optimal resonator for the VHF range was designed and implemented. Production constraints of YBa2Cu3O7 (YBCO) limited the diameter of the sapphire substrate to 3″. Therefore, a meander configuration was formed to fit the long λ/4 MS line on the wafer. By measuring the complex input reflection coefficients of a λ/4 resonator, we extracted the quality factor, which is mainly affected by the dielectric and conductor attenuations. The experimental results are well fitted by the theoretical model. The dielectric attenuation was calculated using the quasi-static analysis of the MS line. An identical copper resonator was produced and measured to compare the properties of the YBCO resonator in reference to the copper one. A quality factor of ~6·105 was calculated for the YBCO resonator, three orders of magnitude larger than that of the copper resonator. The attenuation per unit length of the YBCO layer was smaller by more than five orders of magnitude than that of the copper.

Sign in / Sign up

Export Citation Format

Share Document