scholarly journals Inviscid limit for free-surface Navier-Stokes equations

2012 ◽  
pp. 1-11 ◽  
Author(s):  
Frédéric Rousset
Keyword(s):  
Free Surface ◽  
Stokes Equations ◽  
Inviscid Limit ◽  
Navier Stokes ◽  
Navier Stokes Equations

Simulation of the Gap Resonance Between Two Rectangular Barges in Regular Waves by a Free Surface Viscous Flow Solver

2013 ◽  
Author(s):  
B. Elie ◽  
G. Reliquet ◽  
P.-E. Guillerm ◽  
O. Thilleul ◽  
P. Ferrant ◽  
...  
Keyword(s):  
Experimental Data ◽  
Free Surface ◽  
Viscous Flow ◽  
Stokes Equations ◽  
Resonance Phenomenon ◽  
Navier Stokes ◽  
Regular Waves ◽  
Navier Stokes Equations ◽  
Flow Solver ◽  
Gap Resonance

This paper compares numerical and experimental results in the study of the resonance phenomenon which appears between two side-by-side fixed barges for different sea-states. Simulations were performed using SWENSE (Spectral Wave Explicit Navier-Stokes Equations) approach and results are compared with experimental data on two fixed barges with different headings and bilges. Numerical results, obtained using the SWENSE approach, are able to predict both the frequency and the magnitude of the RAO functions.

NUMERICAL SOLUTIONS OF 2D AND 3D SLAMMING PROBLEMS

2021 ◽  
Vol 153 (A2) ◽  
Author(s):  
Q Yang ◽  
W Qiu
Keyword(s):  
Free Surface ◽  
Numerical Solutions ◽  
Stokes Equations ◽  
Type Equation ◽  
The Body ◽  
Navier Stokes ◽  
Time Step ◽  
Navier Stokes Equations ◽  
Highly Nonlinear ◽  
2D And 3D

Slamming forces on 2D and 3D bodies have been computed based on a CIP method. The highly nonlinear water entry problem governed by the Navier-Stokes equations was solved by a CIP based finite difference method on a fixed Cartesian grid. In the computation, a compact upwind scheme was employed for the advection calculations and a pressure-based algorithm was applied to treat the multiple phases. The free surface and the body boundaries were captured using density functions. For the pressure calculation, a Poisson-type equation was solved at each time step by the conjugate gradient iterative method. Validation studies were carried out for 2D wedges with various deadrise angles ranging from 0 to 60 degrees at constant vertical velocity. In the cases of wedges with small deadrise angles, the compressibility of air between the bottom of the wedge and the free surface was modelled. Studies were also extended to 3D bodies, such as a sphere, a cylinder and a catamaran, entering calm water. Computed pressures, free surface elevations and hydrodynamic forces were compared with experimental data and the numerical solutions by other methods.

scholarly journals Linear pulse structure and signalling in a film flow on an inclined plane

1999 ◽  
Vol 396 ◽  
pp. 37-71 ◽  
Author(s):  
LEONID BREVDO ◽  
PATRICE LAURE ◽  
FREDERIC DIAS ◽  
THOMAS J. BRIDGES
Keyword(s):  
Free Surface ◽  
Saddle Point ◽  
Convective Instability ◽  
Stokes Equations ◽  
Three Dimensional ◽  
Numerical Results ◽  
Navier Stokes ◽  
Surface Boundary ◽  
Navier Stokes Equations ◽  
Surface Boundary Conditions

The film flow down an inclined plane has several features that make it an interesting prototype for studying transition in a shear flow: the basic parallel state is an exact explicit solution of the Navier–Stokes equations; the experimentally observed transition of this flow shows many properties in common with boundary-layer transition; and it has a free surface, leading to more than one class of modes. In this paper, unstable wavepackets – associated with the full Navier–Stokes equations with viscous free-surface boundary conditions – are analysed by using the formalism of absolute and convective instabilities based on the exact Briggs collision criterion for multiple k-roots of D(k, ω) = 0; where k is a wavenumber, ω is a frequency and D(k, ω) is the dispersion relation function.The main results of this paper are threefold. First, we work with the full Navier–Stokes equations with viscous free-surface boundary conditions, rather than a model partial differential equation, and, guided by experiments, explore a large region of the parameter space to see if absolute instability – as predicted by some model equations – is possible. Secondly, our numerical results find only convective instability, in complete agreement with experiments. Thirdly, we find a curious saddle-point bifurcation which affects dramatically the interpretation of the convective instability. This is the first finding of this type of bifurcation in a fluids problem and it may have implications for the analysis of wavepackets in other flows, in particular for three-dimensional instabilities. The numerical results of the wavepacket analysis compare well with the available experimental data, confirming the importance of convective instability for this problem.The numerical results on the position of a dominant saddle point obtained by using the exact collision criterion are also compared to the results based on a steepest-descent method coupled with a continuation procedure for tracking convective instability that until now was considered as reliable. While for two-dimensional instabilities a numerical implementation of the collision criterion is readily available, the only existing numerical procedure for studying three-dimensional wavepackets is based on the tracking technique. For the present flow, the comparison shows a failure of the tracking treatment to recover a subinterval of the interval of unstable ray velocities V whose length constitutes 29% of the length of the entire unstable interval of V. The failure occurs due to a bifurcation of the saddle point, where V is a bifurcation parameter. We argue that this bifurcation of unstable ray velocities should be observable in experiments because of the abrupt increase by a factor of about 5.3 of the wavelength across the wavepacket associated with the appearance of the bifurcating branch. Further implications for experiments including the effect on spatial amplification rate are also discussed.

Numerical Modeling of Flow Over a Dam Spillway

2006 ◽  
Author(s):  
Iraj Saeedpanah ◽  
M. Shayanfar ◽  
E. Jabbari ◽  
Mohammad Haji Mohammadi
Keyword(s):  
Free Surface ◽  
Stokes Equations ◽  
Iterative Solution ◽  
Free Surface Flows ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Continuity Equations ◽  
Water Jets ◽  
Pressure Fields ◽  
Good Agreement

Free surface flows are frequently encountered in hydraulic engineering problems including water jets, weirs and around gates. An iterative solution to the incompressible two-dimensional vertical steady Navier-Stokes equations, comprising momentum and continuity equations, is used to solve for the priori unknown free surface, the velocity and the pressure fields. The entire water body is covered by a unstructured finite element grid which is locally refined. The dynamic boundary condition is imposed for the free surface where the pressure vanishes. This procedure is done continuously until the normal velocities components vanish. To overcome numerical errors and oscillations encountering in convection terms, the SUPG (streamline upwinding Petrov-Galerkin) method is applied. The solution method is tested for different discharges onto a standard spillway geometries. The results shows good agreement with available experimental data.

Transonic nozzle flow of dense gases

1993 ◽  
Vol 247 ◽  
pp. 661-688 ◽  
Author(s):  
A. Kluwick
Keyword(s):  
Stokes Equations ◽  
Equations Of State ◽  
Weak Shock ◽  
Inviscid Limit ◽  
Navier Stokes ◽  
Perturbation Equation ◽  
Navier Stokes Equations ◽  
Sonic Point ◽  
Specific Heats ◽  
Dense Gases

The paper deals with the flow properties of dense gases in the throat area of slender nozzles. Starting from the Navier–Stokes equations supplemented with realistic equations of state for gases which have relatively large specific heats a novel form of the viscous transonic small-perturbation equation is derived. Evaluation of the inviscid limit of this equation shows that three sonic points rather than a single sonic point may occur during isentropic expansion of such media, in contrast to the case of perfect gases. As a consequence, a shock-free transition from subsonic to supersonic speeds cannot, in general, be achieved by means of a conventional converging–diverging nozzle. Nozzles leading to shock-free flow fields must have an unusual shape consisting of two throats and an intervening antithroat. Additional new results include the computation of the internal thermoviscous structure of weak shock waves and a phenomenon referred to as impending shock splitting. Finally, the relevance of these results to the description of external transonic flows is discussed briefly.

Modélisation tridimensionnelle de l'écoulement au voisinage d'un aménagement portuaire

1989 ◽  
Vol 16 (6) ◽  
pp. 829-844
Author(s):  
A. Soulaïmani ◽  
Y. Ouellet ◽  
G. Dhatt ◽  
R. Blanchet
Keyword(s):  
Free Surface ◽  
Computational Analysis ◽  
Stokes Equations ◽  
A Priori ◽  
Three Dimensional ◽  
Free Surface Flows ◽  
Solution Algorithm ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Surface Flows

This paper is devoted to the computational analysis of three-dimensional free surface flows. The model solves the Navier-Stokes equations without any a priori restriction on the pressure distribution. The variational formulation along with the solution algorithm are presented. Finally, the model is used to study the hydrodynamic regime in the vicinity of a projected harbor installation. Key words: free surface flows, three-dimensional flows, finite element method.

Sign in / Sign up

Export Citation Format

Share Document