scholarly journals Automatic Lesion Detection in Ultrasonic Images

10.5772/7058 ◽  
2009 ◽  
Author(s):  
Yung-Sheng Chen ◽  
Chih-Kuang Yeh
Keyword(s):  
Lesion Detection ◽  
Ultrasonic Images

F-18-FDG Positron Imaging in Oncological Patients: Gamma Camera Coincidence Detection versus Dedicated PET

1999 ◽  
Vol 38 (04) ◽  
pp. 108-114 ◽  
Author(s):  
H.-J. Kaiser ◽  
U. Cremerius ◽  
O. Sabri ◽  
M. Schreckenberger ◽  
P. Reinartz ◽  
...  
Keyword(s):  
Attenuation Correction ◽  
Spatial Resolution ◽  
Gamma Camera ◽  
Lesion Detection ◽  
Coincidence Detection ◽  
System Sensitivity ◽  
Oncological Patients ◽  
Phantom Studies ◽  
Pet System ◽  
Dedicated Pet

Summary Aim of the present study was to investigate the feasibility of 2-[fluorine-18]-fluoro-2-deoxy-D-glucose (FDG) imaging in oncological patients with a dual head gamma camera modified for coincidence detection (MCD). Methods: Phantom studies were done to determine lesion detection at various lesion-to-background ratios, system sensitivity and spatial resolution. Thirty-two patients with suspected or known malignant disease were first studied with a dedicated full-ring PET system (DPET) applying measured attenuation correction and subsequently with an MCD system without attenuation correction. MCD images were first interpreted without knowledge of the DPET findings. In a second reading, MCD and DPET were evaluated simultaneously. Results: The phantom studies revealed a comparable spatial resolution for DPET and MCD (5.9 × 6.3 × 4.2 mm vs. 5.9 × 6.5 × 6.0 mm). System sensitivity of MCD was less compared to DPET (91 cps/Bq/ml/cmF0V vs. 231 cps/ Bq/ml/cmFOv). At a lesion-to-background ratio of 4:1, DPET depicted a minimal phantom lesion of 1.0 cm in diameter, MCD a minimal lesion of 1.6 cm. With DPET, a total of 91 lesions in 27 patients were classified as malignant. MCD without knowledge of DPET results revealed increased FDG uptake in all patients with positive DPET findings. MCD detected 72 out of 91 DPET lesions (79.1 %). With knowledge of the DPET findings, 11 additional lesions were detected (+12%). MCD missed lesions in six patients with relevance for staging in two patients. All lesions with a diameter above 18 mm were detected. Conclusion: MCD FDG imaging yielded results comparable to dedicated PET in most patients. However, a considerable number of small lesions clearly detectable with DPET were not detected by MCD alone. Therefore, MCD cannot yet replace dedicated PET in all oncological FDG studies. Further technical refinement of this new method is needed to improve image quality (e.g. attenuation correction).

Top-Ten Tips for Dual-Energy CT in MSK Radiology

2019 ◽  
Vol 23 (04) ◽  
pp. 392-404 ◽  
Author(s):  
Frances E. Walstra ◽  
Jonathan Hickle ◽  
Peter Duggan ◽  
Rashid Alsharhan ◽  
Nicolas Murray ◽  
...  
Keyword(s):  
Bone Marrow ◽  
Dual Energy ◽  
Lesion Detection ◽  
Future Application ◽  
Dual Energy Ct ◽  
Ct Arthrography ◽  
Musculoskeletal Pathology ◽  
Conventional Ct ◽  
Clinical Potential ◽  
Collagen Analysis

Dual-energy computed tomography (DECT) has the potential to detect musculoskeletal pathology with greater sensitivity than conventional CT alone at no additional radiation dose to the patient. It therefore has the potential to reduce the need for further diagnostic imaging or procedures (e.g., joint aspirations in the case of gout or magnetic resonance imaging to confirm undisplaced fractures).DECT is a well-established technique for the detection of gout arthropathy. Multiple newer applications have shown clinical potential including bone marrow edema detection and metal artifact reduction. Collagen analysis, bone marrow lesion detection, and iodine mapping in CT arthrography are areas of possible future application and development.This article outlines 10 tips on the use of DECT imaging of the musculoskeletal system, explaining the technique and indications with practical suggestions to help guide the radiologist.

Evaluation of pre-operative clinical finding and per-operative assessment of carcinoma stomach in tertiary settings of Bangladesh

2020 ◽  
Vol 22 (1) ◽  
pp. 43-46
Author(s):  
Mst Jesmen Nahar ◽  
Md Mahiuddin Matubber ◽  
Md Mahbubur Rahman ◽  
Md Mahbubur Rahman ◽  
Syed Muhammad Baqul Billah ◽  
...  
Keyword(s):  
Lymph Node ◽  
Clinical Picture ◽  
Preoperative Evaluation ◽  
Lymph Node Involvement ◽  
Lesion Detection ◽  
Clinical Feature ◽  
P Value ◽  
Operative Finding ◽  
Node Involvement ◽  
Carcinoma Stomach

Background: Carcinoma stomach, a major killer cancer all over the world, is still presenting late in developing countries due to delay in early diagnosis, lack of awareness, infrastructure etc. Objectives: To establish the importance of preoperative evaluation on operability of carcinoma stomach. Methods: Sixty clinically and histopathologically diagnosed ca stomach cases who underwent surgery in department of Bangabandhu Sheikh Mujib Medical University, Dhaka, and Dhaka Medical College Hospital, Dhaka in 2011 were assessed with clinical picture, investigations, preoperative evaluation and peroperative findings were recorded. Z test for proportion was used to assess clinical decision predictability with a p value of :s;0.05 as significant. Results: Male (73.33%) predominant with 2.75:1 male:female ratio was observed. Mobility, fixity and abdominal lymphadenopathy were not well detected through clinical assessment (p=0.001) while ascites, metastasis and Shelf of Slummer were similar in both clinical and operative finding. The endoscopy of upper GIT finding gave a unique picture as the findings were almost same as were found during operation. USG detected a lesser proportion of the clinical condition compared to peroperative condition whereas CT performed better than the USG except for the lesion detection. Though Computed Tomography (CT) detected higher percentage of lesion, metastasis, ascites and lymph node involvement compared to ultrasonogram (USG), it was significantly higher only for lesion detection (p=0.002) and lymph node involvement (p=<0.001). In the similar manner USG assessment of lesion detection (p=<0.001) and lymph node involvement (p=0.003) was significantly low compared to operative finding. When we looked between CT and operative finding only lesion detection was significantly low (p=0.01) indicating CT to be most effective predictor of clinical picture for operative decision. Preoperative plan were mostly not in accordance with peroperative decision except for total gastrectomy. Conclusion: The study indicates weakness in clinical detection and pre-operative plan compared to per-operative finding. Hence combination of clinical feature and investigation tools especially endoscopy of upper GIT combined with CT is recommended to predict a better operative decision. Journal of Surgical Sciences (2018) Vol. 22 (1): 43-46

Direct Read and Quantify Damage Nucleotide from an Oligonucleotide Using a Single Molecule Interface

2019 ◽  
Author(s):  
Jiajun Wang ◽  
Meng-Yin Li ◽  
Jie Yang ◽  
Ya-Qian Wang ◽  
Xue-Yuan Wu ◽  
...  
Keyword(s):  
Dna Sequencing ◽  
Single Molecule ◽  
Genetic Diseases ◽  
High Sensitivity ◽  
Dna Lesions ◽  
Lesion Detection ◽  
The Novel ◽  
Structural Variations ◽  
Dna Lesion ◽  
Base Lesion

DNA lesion such as metholcytosine(<sup>m</sup>C), 8-OXO-guanine(<sup>O</sup>G), inosine(I) <i>etc</i> could cause the genetic diseases. Identification of the varieties of lesion bases are usually beyond the capability of conventional DNA sequencing which is mainly designed to discriminate four bases only. Therefore, lesion detection remain challenge due to the massive varieties and less distinguishable readouts for minor structural variations. Moreover, standard amplification and labelling hardly works in DNA lesions detection. Herein, we designed a single molecule interface from the mutant K238Q Aerolysin, whose confined sensing region shows the high compatible to capture and then directly convert each base lesion into distinguishable current readouts. Compared with previous single molecule sensing interface, the resolution of the K238Q Aerolysin nanopore is enhanced by 2-order. The novel K238Q could direct discriminate at least 3 types (<sup>m</sup>C, <sup>O</sup>G, I) lesions without lableing and quantify modification sites under mixed hetero-composition condition of oligonucleotide. Such nanopore could be further applied to diagnose genetic diseases at high sensitivity.

Review of Various Tasks Performed in the Preprocessing Phase of a Diabetic Retinopathy Diagnosis System

2020 ◽  
Vol 16 (4) ◽  
pp. 397-426
Author(s):  
Muhammad Nadeem Ashraf ◽  
Muhammad Hussain ◽  
Zulfiqar Habib
Keyword(s):  
Diabetic Retinopathy ◽  
Blood Vessels ◽  
Early Stage ◽  
Spherical Shape ◽  
Cost Effective ◽  
Lesion Detection ◽  
Diabetic Patients ◽  
Cad System ◽  
Non Invasive ◽  
Optic Discs

Diabetic Retinopathy (DR) is a major cause of blindness in diabetic patients. The increasing population of diabetic patients and difficulty to diagnose it at an early stage are limiting the screening capabilities of manual diagnosis by ophthalmologists. Color fundus images are widely used to detect DR lesions due to their comfortable, cost-effective and non-invasive acquisition procedure. Computer Aided Diagnosis (CAD) of DR based on these images can assist ophthalmologists and help in saving many sight years of diabetic patients. In a CAD system, preprocessing is a crucial phase, which significantly affects its performance. Commonly used preprocessing operations are the enhancement of poor contrast, balancing the illumination imbalance due to the spherical shape of a retina, noise reduction, image resizing to support multi-resolution, color normalization, extraction of a field of view (FOV), etc. Also, the presence of blood vessels and optic discs makes the lesion detection more challenging because these two artifacts exhibit specific attributes, which are similar to those of DR lesions. Preprocessing operations can be broadly divided into three categories: 1) fixing the native defects, 2) segmentation of blood vessels, and 3) localization and segmentation of optic discs. This paper presents a review of the state-of-the-art preprocessing techniques related to three categories of operations, highlighting their significant aspects and limitations. The survey is concluded with the most effective preprocessing methods, which have been shown to improve the accuracy and efficiency of the CAD systems.

Sign in / Sign up

Export Citation Format

Share Document