scholarly journals Active Magnetic Suspension and Bearing

10.5772/5971 ◽  
2008 ◽  
Author(s):  
Adam Krzysztof
Keyword(s):  
Magnetic Suspension

Magnetic suspension mechanism using rotary permanent magnets

2020 ◽  
Vol 64 (1-4) ◽  
pp. 977-983
Author(s):  
Koichi Oka ◽  
Kentaro Yamamoto ◽  
Akinori Harada
Keyword(s):  
Permanent Magnets ◽  
Suspension System ◽  
Magnetic Suspension ◽  
Horizontal Force ◽  
Mechanical Contact ◽  
New Type ◽  
Magnetic Suspension System

This paper proposes a new type of noncontact magnetic suspension system using two permanent magnets driven by rotary actuators. The paper aims to explain the proposed concept, configuration of the suspension system, and basic analyses for feasibility by FEM analyses. Two bar-shaped permanent magnets are installed as they are driven by rotary actuators independently. Attractive forces of two magnets act on the iron ball which is located under the magnets. Control of the angles of two magnets can suspend the iron ball stably without mechanical contact and changes the position of the ball. FEM analyses have been carried out for the arrangement of two permanent magnets and forces are simulated for noncontact suspension. Hence, successfully the required enough force against the gravity of the iron ball can be generated and controlled. Control of the horizontal force is also confirmed by the rotation of the permanent magnets.

A Magnetic Suspension Theory and Its Application to the HeartQuest Ventricular Assist Device

2002 ◽  
Vol 26 (11) ◽  
pp. 947-951 ◽  
Author(s):  
Chen Chen ◽  
Brad Paden ◽  
James Antaki ◽  
Jed Ludlow ◽  
Dave Paden ◽  
...  
Keyword(s):  
Ventricular Assist Device ◽  
Magnetic Suspension ◽  
Assist Device ◽  
Ventricular Assist

scholarly journals Density Measurements of an Air-Like Binary Mixture over the Temperature Range from 100 K to 298.15 K at Pressures up to 8.0 MPa

2021 ◽  
Vol 42 (9) ◽  
Author(s):  
Nils von Preetzmann ◽  
Reiner Kleinrahm ◽  
Philipp Eckmann ◽  
Giuseppe Cavuoto ◽  
Markus Richter
Keyword(s):  
Binary Mixture ◽  
Saturated Vapor ◽  
Saturation Pressure ◽  
Transmission Error ◽  
Magnetic Suspension ◽  
Mixture Component ◽  
Liquid Region ◽  
Force Transmission ◽  
Temperature Range ◽  
Combined Uncertainty

AbstractDensities of an air-like binary mixture (0.2094 oxygen + 0.7906 nitrogen, mole fractions) were measured along six isotherms over the temperature range from 100 K to 298.15 K at pressures up to 8.0 MPa, using a low-temperature single-sinker magnetic suspension densimeter. The measurements were carried out at T = (100, 115, and 130) K in the homogeneous gas and liquid region, and at T = (145, 220, and 298.15) K in the supercritical region (critical temperature TC = 132.35 K); in total, we present results for 52 (T, p) state points. The relative expanded combined uncertainty (k = 2) of the experimental densities was estimated to be between 0.03 % and 0.13 %, except for four values near the critical point. The largest error is caused by the magnetic suspension coupling in combination with the mixture component oxygen, which is strongly paramagnetic; the resulting force transmission error is up to 1.1 %. However, this error can be corrected with a proven correction model to an uncertainty contribution in density of less than 0.044 %. Due to a supercritical liquefaction procedure and the integration of a special VLE-cell, it was possible to measure densities in the homogeneous liquid phase without changing the composition of the liquefied mixture. Moreover, saturated liquid and saturated vapor densities were determined at T = (100, 115, and 130) K by extrapolation of the experimental single-phase densities to the saturation pressure. The new experimental results were compared with the mixture model of Lemmon et al. for the system (nitrogen + argon + oxygen) and the GERG-2008 equation of state.

Sign in / Sign up

Export Citation Format

Share Document