scholarly journals Combustion and Exhaust Emission Characteristics of Diesel Micro-Pilot Ignited Dual-Fuel Engine

10.5772/54613 ◽  
2013 ◽  
Author(s):  
Ulugbek Azimov ◽  
Eiji Tomita ◽  
Nobuyuki Kawahar
Keyword(s):  
Exhaust Emission ◽  
Dual Fuel ◽  
Emission Characteristics

Influence of Dual Fuel Twin Injection on Diesel Engine Combustion and Emission Characteristics

2013 ◽  
Vol 768 ◽  
pp. 206-212 ◽  
Author(s):  
K. Senthil Kumar ◽  
R. Thundil Karuppa Raj
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Release Rate ◽  
Exhaust Emission ◽  
Dual Fuel ◽  
Emission Characteristics ◽  
Pilot Injection ◽  
Crank Angle ◽  
Engine Combustion ◽  
Pilot Fuel

The objective of this study is to investigate the feasibility of two-stage injection on combustion and exhaust emission characteristics in diesel (main fuel) ethanol (pilot fuel) fuelled single cylinder diesel engine. The pressure crank angle and net heat release rate diagrams revealed that increase in the ethanol pilot quantity causes an increase in the ignition delay in the pilot combustion and hence the main combustion due to diesel fuel is slightly influenced by the ethanol pilot fuel. The increase in the pilot injection decreases the NOx considerably. The concentration of soot emissions also decreases with increase in pilot injection. The CO emissions increases with increase in pilot injection and a slight increase in HC emission is observed.

scholarly journals A Numerical Study on the Combustion Process and Emission Characteristics of a Natural Gas-Diesel Dual-Fuel Marine Engine at Full Load

Energies ◽  
2021 ◽  
Vol 14 (5) ◽  
pp. 1342
Author(s):  
Van Chien Pham ◽  
Jae-Hyuk Choi ◽  
Beom-Seok Rho ◽  
Jun-Soo Kim ◽  
Kyunam Park ◽  
...  
Keyword(s):  
Natural Gas ◽  
Combustion Process ◽  
Simulation Software ◽  
Dual Fuel ◽  
Injection Timing ◽  
Emission Characteristics ◽  
Cylinder Pressure ◽  
Marine Engine ◽  
Full Load ◽  
Simulation Results

This paper presents research on the combustion and emission characteristics of a four-stroke Natural gas–Diesel dual-fuel marine engine at full load. The AVL FIRE R2018a (AVL List GmbH, Graz, Austria) simulation software was used to conduct three-dimensional simulations of the combustion process and emission formations inside the engine cylinder in both diesel and dual-fuel mode to analyze the in-cylinder pressure, temperature, and emission characteristics. The simulation results were then compared and showed a good agreement with the measured values reported in the engine’s shop test technical data. The simulation results showed reductions in the in-cylinder pressure and temperature peaks by 1.7% and 6.75%, while NO, soot, CO, and CO2 emissions were reduced up to 96%, 96%, 86%, and 15.9%, respectively, in the dual-fuel mode in comparison with the diesel mode. The results also show better and more uniform combustion at the late stage of the combustions inside the cylinder when operating the engine in the dual-fuel mode. Analyzing the emission characteristics and the engine performance when the injection timing varies shows that, operating the engine in the dual-fuel mode with an injection timing of 12 crank angle degrees before the top dead center is the best solution to reduce emissions while keeping the optimal engine power.

Effect of H2 and CO Content in Syngas on the Performance and Emission of Syngas-Diesel Dual Fuel Engine - A Review

2014 ◽  
Vol 699 ◽  
pp. 648-653 ◽  
Author(s):  
Bahaaddein K.M. Mahgoub ◽  
Suhaimi Hassan ◽  
Shaharin Anwar Sulaiman
Keyword(s):  
Carbon Monoxide ◽  
Diesel Engines ◽  
Combustion Process ◽  
Exhaust Emission ◽  
Dual Fuel ◽  
Pure Liquid ◽  
Compression Ignition ◽  
Performance And Emission ◽  
Combustion Duration ◽  
Combustible Gases

In this review, a series of research papers on the effects of hydrogen and carbon monoxide content in syngas composition on the performance and exhaust emission of compression ignition diesel engines, were compiled. Generally, the use of syngas in compression ignition (CI) diesel engine leads to reduce power output due to lower heating value when compared to pure liquid diesel mode. Therefore, variation in syngas composition, especially hydrogen and carbon monoxide (Combustible gases), is suggested to know the appropriate syngas composition. Furthermore, the simulated model of syngas will help to further explore the detailed effects of engine parameters on the combustion process including the ignition delay, combustion duration, heat release rate and combustion phasing. This will also contribute towards the efforts of improvement in performance and reduction in pollutants’ emissions from CI diesel engines running on syngas at dual fuel mode. Generally, the database of syngas composition is not fully developed and there is still room to find the optimum H2 and CO ratio for performance, emission and diesel displacement of CI diesel engines.

Sign in / Sign up

Export Citation Format

Share Document