scholarly journals PATHOLOGICAL ENLARGEMENT OF RESIN CANALS IN PICEA

1934 ◽  
Vol 10 (2) ◽  
pp. 129-136
Author(s):  
J. B. Prince
Keyword(s):  
Resin Canals

Seasonal Variation in Traumatic Resin Canal Formation in Chamaecyparis Obtusa Phloem

IAWA Journal ◽  
1998 ◽  
Vol 19 (2) ◽  
pp. 181-189 ◽  
Author(s):  
Keiko Kuroda
Keyword(s):  
Annual Ring ◽  
Stem Canker ◽  
Chamaecyparis Obtusa ◽  
Resin Canal ◽  
Annual Rings ◽  
Secondary Phloem ◽  
Resinous Stem Canker ◽  
Traumatic Resin Canals ◽  
Resin Canals ◽  
Artificial Wounding

Trunks of Chamaecyparis obtusa were injured to examine seasonal differences in traumatic resin canal formation in secondary phloem. Even after wounding during winter, differentiation of axial parenchyma into epithelium was initiated, and vertical resin canals formed. After winter wounding, resin canal development was slower and the tangential extent of resin canals was narrower than after spring wounding, and it took one to two months until resin secretion began. After spring wounding, the sites of resin canal formation were the 1- and 2-year-old annual rings of phloem. In August, the location of resin canal formation shifted into the current and 1-year-old annual ring. Resin canals never formed in secondary phloem areas that were 3 or more years old. In C. obtusa trunks that are affected by the resinous stem canker, numerous tangentiallines of resin canals are found throughout the phloem, not just recent and 1- to 2-year-old phloem. The present research indicates that these many lines of resin canals were not formed at one time, and that the stimuli that induce traumatic resin canals must occur repeatedly over many years. The data on artificial wounding effects are useful for understanding resinous stem canker.

Analysis of Turee Microscopic Cuaracters for Separating the Wood of Pinus Contorta and P. Ponderosa

IAWA Journal ◽  
2003 ◽  
Vol 24 (3) ◽  
pp. 257-267
Author(s):  
Alex C. Wiedenhoeft ◽  
Regis B. Miller ◽  
Terra J. Theim
Keyword(s):  
Pinus Ponderosa ◽  
Pinus Contorta ◽  
Resin Canal ◽  
Diagnostic Character ◽  
Resin Canals

Three microscopic characters were evaluated for the identification of Pinus contorta and Pinus ponderosa. The tangential diameter of the resin canals, including the epithelium, was compared to the tangential diameter of the entire resin canal complex. The latter measurement was shown to give diagnostic results for these species. Data from the examination of ray composition do not support previously published methods for separating P. contorta and P. ponderosa. The presence or absence of small elongate crystals in the subsidiary parenchyma of the resin canal complexes was shown to be the most powerful diagnostic character for separating the wood of these species.

scholarly journals Resin canals in spruce (Picea abis /L./ Karst.) with the occurrence of reaction wood

2005 ◽  
Vol 53 (1) ◽  
pp. 85-92 ◽  
Author(s):  
Vladimír Gryc ◽  
Petr Horáček
Keyword(s):  
Compression Wood ◽  
3D Models ◽  
Resin Canal ◽  
The Other ◽  
Stem Length ◽  
Reaction Wood ◽  
Spruce Wood ◽  
Other Hand ◽  
Resin Canals

The paper was aimed at the determination of variability of horizontal resin canal dimension in spruce wood in relation to the position in a spruce stem. Significant changes of dimensions in horizontal resin canal along the stem length and radius were found. On the basis obtained of results 3D models (for CW, OW, SWL and SWP zones) describing changes in resin canal dimensions in spruce in relation to the position in a stem were created. In the models, the resin canal dimension decreases with the height of a stem and on the other hand, with an increasing distance from the stem pith the dimension of resin canal increases. The importance of the paper consists in the enlargement of findings about the structure of spruce with compression wood.

scholarly journals Interpopulational variability of Pinus sylvestris L. in eight Polish localities expressed in morphological and anatomical traits of needles

2014 ◽  
Vol 63 (1) ◽  
pp. 67-76 ◽  
Author(s):  
Maria A. Bobowicz ◽  
Adolf F. Korczyk
Keyword(s):  
Pinus Sylvestris ◽  
Minimum Spanning Tree ◽  
Multivariate Statistical ◽  
Mahalanobis Distances ◽  
The North ◽  
Flat Side ◽  
Standing Trees ◽  
Statistical Hypotheses ◽  
Resin Canals ◽  
Interpopulational Variability

Two-year old needles were collected from 272 standing trees of <i>Pinus sylvestris</i> L., representing 8 Polish populations. The needles were studied in respect to IS morphological and anatomical traits. The obtained data were subjected to multivariate statistical analysis in an attempt to delineate interpopulational variability. Multivariate analysis of variance with testing of statistical hypotheses and discriminant analysis were conducted. Mahalanobis distances were calculated between each of population in pairs and their significance was estimated using Hotelling T<sup>2</sup> statistics. On the basis of the shortest Mahalanobis distances a minimum spanning tree was constructed and on the basis of Euklidean distances hierarchy grouping was performed. A large majority of the populations was found to differ significantly from the remaining populations. The population from Bolewice proved to be most divergent. The principal variables which proved capable of discriminating between populations were found to include: needle length, the number of stomata on the flat side of the needle and the number of resin canals. Using Bryant's test, the studied populations were found to belong to two geographic groups: the North-Polish one or the South-Polish one.

scholarly journals α-l-Fucosidases from Bursaphelenchus xylophilus Secretome—Molecular Characterization and Their Possible Role in Breaking Down Plant Cell Walls

Forests ◽  
2020 ◽  
Vol 11 (3) ◽  
pp. 265
Author(s):  
Joana M.S. Cardoso ◽  
Luís Fonseca ◽  
Isabel Abrantes
Keyword(s):  
Cell Wall ◽  
Molecular Characterization ◽  
Three Dimensional ◽  
Pine Wilt Disease ◽  
Bursaphelenchus Xylophilus ◽  
Pinewood Nematode ◽  
Cell Wall Degrading Enzymes ◽  
Degrading Enzymes ◽  
Host Trees ◽  
Resin Canals

The pinewood nematode (PWN) Bursaphelenchus xylophilus, the causal agent of the pine wilt disease (PWD), enters above-ground parts of the tree, migrates through the resin canals and feeds on plant cells causing extensive damage. In order to penetrate the cell wall and establish a parasitic relationship with host trees, the PWN needs to secretea mixture of active cell wall degrading enzymes. In maritime pine, Pinus pinaster, which is high susceptible to PWN, xyloglucan is the major hemicellulosic polysaccharide in primary cells. The xyloglucan backbone is susceptible to hydrolysis by numerous endoglucanases, some of them specific to xyloglucan. However, to completely degrade xyloglucan, all substitutions on the glucan backbones must be released, and l-fucose residues in xyloglucan branches are released by α-l-fucosidases. In the present study, the molecular characterization of two α-l-fucosidases found in PWN secretome was performed. Moreover, a novel α-l-fucosidase was identified and its cDNA and gene sequence were determined. The three-dimensional structures of these α-l-fucosidases were predicted and the transcript levels were analyzed, thus providing new insights into fundamental PWN biology and the possible role of these proteins as cell wall degrading enzymes.

The effect of crown position and tree age on resin-canal density in Scots pine (Pinus sylvestris L.) needles

2001 ◽  
Vol 79 (11) ◽  
pp. 1257-1261 ◽  
Author(s):  
Jinxing Lin ◽  
D A Sampson ◽  
R Ceulemans
Keyword(s):  
Pinus Sylvestris ◽  
Scots Pine ◽  
Cross Sections ◽  
Resin Canal ◽  
Tree Age ◽  
Needle Length ◽  
Cross Sectional ◽  
Crown Position ◽  
The Cross ◽  
Resin Canals

Resin canals are an important taxonomic characteristic in conifers. In this paper we examined within- and between-needle variation of the cross-sectional number of resin canals in Scots pine (Pinus sylvestris L.). Variation within needles was determined from 12 free-hand sections taken along the whole length of foliage collected from a common crown position. The effect of crown location and tree age on resin-canal density was also examined from the midpoint cross sections of 450 Scots pine needles collected from interior and exterior locations from the top, middle, and bottom of 25 crowns of trees ranging in age from 8 to 70 years. Within-needle resin-canal density varied with needle length. Two resin canals were typical for the basal and the terminal needle cross sections. There were 3.2 and 8.6 resin canals for cross sections taken from 10 and 30% of the needle length from the basal sheath, respectively. Resin-canal density was largest, and relatively constant, between 30 and 80% of the needle length. We found significant differences in the cross-sectional number of needle resin canals, as influenced by crown positions and tree age. Resin-canal density increased with foliage height. Foliage from the top one-third of crowns had significantly more resin canals than foliage from the bottom. Foliage collected from the crown interior (proximal to the stem) had fewer resin canals than samples from the crown edge. Resin-canal density increased from 7.1 to 10.3 as tree age increased from 8 to 70 years. These results suggest that crown position and tree age need to be incorporated into the sampling protocols used to establish species standards in resin-canal density, at least for Scots pine, if meaningful comparisons are to be made.Key words: resin canal, needle age, crown position, needle anatomy, Pinus sylvestris.

Wood anatomy of Tetraclinis articulata from its natural distribution area in southeast Spain

IAWA Journal ◽  
2015 ◽  
Vol 36 (1) ◽  
pp. 22-35 ◽  
Author(s):  
Luis G. Esteban ◽  
Paloma de Palacios ◽  
Alberto García-Iruela ◽  
Elena Román-Jordán ◽  
Francisco G. Fernández ◽  
...  
Keyword(s):  
Wood Anatomy ◽  
Forest Stand ◽  
Distribution Area ◽  
Natural Distribution ◽  
Tetraclinis Articulata ◽  
Characteristic Features ◽  
Helical Thickenings ◽  
Resin Canals ◽  
First Time ◽  
Representative Samples

For the first time, the wood anatomy of Tetraclinis articulata (Vahl) Masters has been studied using representative samples from its natural distribution area in Spain, in Sierra de Cartagena (Region of Murcia). Mature wood was collected from five individuals representative of the forest stand and their anatomy was compared with other genera of the Cupressaceae. Axial tracheids without helical thickenings, low homogeneous rays, cupressoid pits and the absence of normal axial resin canals are characteristic features of this monotypic genus, as they are of most other Cupressaceae genera. An obvious warty layer separates this wood from the genera sharing its territory (Cupressus and Juniperus) and its semi-spherical, slightly anastomosed warts distinguish it from other, geographically distant genera (Actinostrobus and Callitris). The presence of traumatic axial resin canals is reported for the first time and supports the occurrence of this feature outside the Pinaceae. The wood anatomical diversity within the clade comprising Tetraclinis, Microbiota and Platycladus, as reconstructed by molecular analysis, is discussed.

Detection and mapping of resin canals by image analysis in transverse sections of mechanically perturbed, young Pinus radiata trees

IAWA Journal ◽  
2017 ◽  
Vol 38 (2) ◽  
pp. 170-181 ◽  
Author(s):  
Jimmy Thomas ◽  
David A. Collings
Keyword(s):  
Pinus Radiata ◽  
Cell Walls ◽  
Compression Wood ◽  
Radiata Pine ◽  
Automated Detection ◽  
Flatbed Scanner ◽  
Pine Trees ◽  
Old Trees ◽  
Imagej Software ◽  
Resin Canals

We describe a novel, semi-automatic method for the detection, visualisation and quantification of axially oriented resin canals in transverse sections of Pinus radiata D. Don (radiata pine) trees. Sections were imaged with a flatbed scanner using circularly polarised transmitted light, with the resin canals that contained only primary cell walls appearing dark against a bright background of highly-birefringent tracheids. These images were analysed using ImageJ software and allowed for a non-biased, automated detection of resin canals and their spatial distribution across the entire stem. We analysed 8-month-old trees that had been subjected to tilting to induce compression wood and rocking to simulate the effects of wind. These experiments showed that both rocking and tilting promoted the formation of wood and confirmed that resin canals were most common adjacent to the pith. Both the rocking and tilting treatments caused a decrease in the number of resin canals per unit area when compared to vertical controls, but this change was due to the increased formation of wood by these treatments. In tilted samples, however, analysis of resin canal distribution showed that canals were more common on the lower sides of stems but these canals were excluded from regions that formed compression wood.

Sign in / Sign up

Export Citation Format

Share Document