scholarly journals Effect of Compression Ratio on Energy and Emission Performance of Single Cylinder Diesel Engine Fueled with Jatropha and Karanja Biodiesel

2013 ◽  
Vol 16 (3) ◽  
Author(s):  
Eknath R Deore ◽  
Ramchandra S Jahagirdar
Keyword(s):  
Diesel Engine ◽  
Compression Ratio ◽  
Emission Performance ◽  
Single Cylinder

scholarly journals Effect of Combustion Parameters on Performance, Combustion and Emission Characteristics of a Modified Small Single-Cylinder Diesel Engine

2020 ◽  
Vol 8 (5) ◽  
pp. 622-630 ◽  
Keyword(s):  
Diesel Engine ◽  
Compression Ratio ◽  
Injection Pressure ◽  
Injection System ◽  
Combustion Characteristic ◽  
Experimental Investigations ◽  
Exhaust Emission ◽  
Injection Timing ◽  
Emission Characteristics ◽  
Single Cylinder

This paper represents the relative performance of a small single-cylinder diesel engine having capacity 3.5 kW. This paper covers experimental investigations of most influencing combustion parameters such as compression ratio, injection pressure and start of injection timing and their values on performance, emission and combustion characteristic of the small single-cylinder CRDI diesel engine for which the mechanical fuel injection system retrofitted with a simple version of the CRDI system. CRDI has yielded good results for large diesel and petrol engines but still not incorporate for cheaper small single-cylinder engines, typically used in the agricultural sector and decentralized power sector for a country like India. It is observed that starts of injection timing and injection pressure are the key parameters for improving the combustion characteristics and therefore engine performance while compression ratio mainly affects the emission characteristics of the engine. Retrofitted CRDI system yielded improved exhaust emission and performance of the engine.

Effects of Fuel Supply Advance Angle on Engine Thermal Efficiency and Emission Performance Fueled with Bio-Diesel

2013 ◽  
Vol 724-725 ◽  
pp. 1122-1126
Author(s):  
Qi Zeng
Keyword(s):  
Diesel Engine ◽  
Thermal Efficiency ◽  
Emission Characteristics ◽  
Nox Emissions ◽  
Variation Trend ◽  
Emission Performance ◽  
Single Cylinder ◽  
Fuel Supply ◽  
Comparison Test ◽  
Complex Variation

Having comparison test research of economy and emission characteristics of biodiesel under different fuel supply advance angle on L16-type single cylinder diesel engine. The results show that the diesel engine has good effective thermal efficiency and economy with the fuel supply advance angle at 17°CA-BTDC; CO emissions basically increases with the decrease of fuel supply advance angle; NOx emissions increases with the fuel supply advance angle; THC emissions show not obvious and complex variation trend with the change of fuel supply advance angle, but the magnitude of the overall change is not obvious; with the decrease of fuel supply advance angle, Soot emissions increase first and then decreases.

Low NOx and Low Smoke Operation of a Diesel Engine Using Gasolinelike Fuels

2010 ◽  
Vol 132 (9) ◽  
Author(s):  
Gautam Kalghatgi ◽  
Leif Hildingsson ◽  
Bengt Johansson
Keyword(s):  
Diesel Engine ◽  
Heat Release ◽  
Compression Ratio ◽  
Diesel Fuel ◽  
Ignition Delay ◽  
Cetane Number ◽  
Pressure Rise ◽  
Maximum Pressure ◽  
Single Cylinder ◽  
Intake Pressure

Much of the technology in advanced diesel engines, such as high injection pressures, is aimed at overcoming the short ignition delay of conventional diesel fuels to promote premixed combustion in order to reduce NOx and smoke. Previous work in a 2 l single-cylinder diesel engine with a compression ratio of 14 has demonstrated that gasoline fuel, because of its high ignition delay, is very beneficial for premixed compression-ignition compared with a conventional diesel fuel. We have now done similar studies in a smaller—0.537 l—single-cylinder diesel engine with a compression ratio of 15.8. The engine was run on three fuels of very different auto-ignition quality—a typical European diesel fuel with a cetane number (CN) of 56, a typical European gasoline of 95 RON and 85 MON with an estimated CN of 16 and another gasoline of 84 RON and 78 MON (estimated CN of 21). The previous results with gasoline were obtained only at 1200 rpm—here we compare the fuels also at 2000 rpm and 3000 rpm. At 1200 rpm, at low loads (∼4 bars indicated mean effective pressure (IMEP)) when smoke is negligible, NOx levels below 0.4 g/kWh can be easily attained with gasoline without using exhaust gas recirculation (EGR), while this is not possible with the 56 CN European diesel. At these loads, the maximum pressure-rise rate is also significantly lower for gasoline. At 2000 rpm, with 2 bars absolute intake pressure, NOx can be reduced below 0.4 g/kW h with negligible smoke (FSN<0.1) with gasoline between 10 bars and 12 bars IMEP using sufficient EGR, while this is not possible with the diesel fuel. At 3000 rpm, with the intake pressure at 2.4 bars absolute, NOx of 0.4 g/kW h with negligible smoke was attainable with gasoline at 13 bars IMEP. Hydrocarbon and CO emissions are higher for gasoline and will require after-treatment. High peak heat release rates can be alleviated using multiple injections. Large amounts of gasoline, unlike diesel, can be injected very early in the cycle without causing heat release during the compression stroke and this enables the heat release profile to be shaped.

Sign in / Sign up

Export Citation Format

Share Document