scholarly journals The push-out bond strength of BIOfactor mineral trioxide aggregate, a novel root repair material

2019 ◽  
Vol 44 (1) ◽  
Author(s):  
Makbule Bilge Akbulut ◽  
Durmus Alperen Bozkurt ◽  
Arslan Terlemez ◽  
Melek Akman
Keyword(s):  
Bond Strength ◽  
Mineral Trioxide Aggregate ◽  
Repair Material ◽  
Root Repair ◽  
Push Out

Comparison of the Osteogenic Potential of Mineral Trioxide Aggregate and Endosequence Root Repair Material in a 3-dimensional Culture System

2016 ◽  
Vol 42 (5) ◽  
pp. 760-765 ◽  
Author(s):  
Hisham S. Rifaey ◽  
Max Villa ◽  
Qiang Zhu ◽  
Yu-Hsiung Wang ◽  
Kamran Safavi ◽  
...  
Keyword(s):  
Culture System ◽  
Mineral Trioxide Aggregate ◽  
Osteogenic Potential ◽  
Repair Material ◽  
3 Dimensional ◽  
Root Repair

scholarly journals Improvement of the Bonding Properties of Mineral Trioxide Aggregate by Elastin-Like Polypeptide Supplementation

Scanning ◽  
2019 ◽  
Vol 2019 ◽  
pp. 1-8 ◽  
Author(s):  
Hyun-Jung Kim ◽  
Donghyun Lee ◽  
Seungryong Cho ◽  
Ji-Hyun Jang ◽  
Sahng Gyoon Kim ◽  
...  
Keyword(s):  
Contact Angle ◽  
Bond Strength ◽  
Flow Rate ◽  
Mineral Trioxide Aggregate ◽  
Strength Test ◽  
Research Data ◽  
Intimate Contact ◽  
Tooth Structure ◽  
Bonding Properties ◽  
Push Out

Introduction. Elastin-like polypeptide (ELP) supplementation was previously reported to enhance the physical properties of mineral trioxide aggregate (MTA). The aim of this study was to investigate the effect of ELP supplementation on the bonding properties of MTA to dentin. Methods. Two types of ELPs were synthesized and mixed with MTA in a 0.3 liquid/powder ratio. The push-out bond strength test and interfacial observation with scanning electron microscopy were performed for ELP-supplemented MTA. The porosity of MTA fillings in the cavity was observed with microcomputed tomography. The stickiness, flow rate, and contact angle were additionally measured for potential increased bonding properties. Results. ELP supplementation improved the bond strength of MTA to dentin. MTA supplemented by a specific ELP exhibited a less porous structure, higher stickiness, and higher flow rate. ELPs also decreased the contact angle to dentin. Conclusions. This research data verifies that ELP improves the bonding properties of MTA to a tooth structure. The sticky and highly flowable characteristics of ELP-supplemented MTA may provide intimate contact with dentin and supply a less porous cement structure, which might improve the bonding properties of MTA.

scholarly journals Comparison of Medicaments Used in Regenerative Endodontics in Terms of Dentin Microhardness and Adhesion of Mineral in Terms of Dentin Microhardness and Adhesion of Mineral Trioxide Aggregate Trioxide Aggregat

2020 ◽  
Vol 27 (3) ◽  
Author(s):  
Esma Saricam ◽  
◽  
Neslihan Bulak ◽  
Esra Özyurt ◽  
Suat Özcan ◽  
...  
Keyword(s):  
Bond Strength ◽  
Clavulanic Acid ◽  
Root Canal ◽  
Mineral Trioxide Aggregate ◽  
Significance Level ◽  
Regenerative Endodontics ◽  
Significant Difference ◽  
Amoxicillin Clavulanic Acid ◽  
Root Canal Dentin ◽  
Push Out

Eliminating microorganisms in the root canal system is important for the success of regenerative endodontics. Objective: This study evaluated the effects of different antibiotic pastes used for regenerative endodontic procedures on dentin microhardness and the push-out bond strength of mineral trioxide aggregate (MTA) to root canal dentin. Methods: Sixty-four maxillary central incisors were instrumented and randomly divided into the following four groups (n = 16) for medicament treatment: triple antibiotic paste, amoxicillin+clavulanic acid, cefaclor, and control (no dressing). After 21 days, two root segments were obtained by sectioning the roots horizontally for push-out and microhardness evaluations. MTA was placed into the root canal of the sectioned segment for the push-out test. In the microhardness evaluation, three indentations were made at 500 and 1,000 μm from the canal lumen. The arithmetic mean was then calculated for each distance. ANOVA with post hoc Scheffe test and t test were used for the statistical analyses. The significance level was set at p < 0.05. Results: No significant difference was found between the groups in terms of push-out bond strength (p > 0.05). Cefaclor and amoxicillin+clavulanic acid reduced the microhardness values of the dentin at 500 μm (p < 0.05) while cefaclor had the lowest value at 1,000 μm (p < 0.05). Conclusion: Cefaclor reduced the microhardness value more than the other medicaments did at a depth of 1,000 μm. The pastes provided similar adhesion of MTA.

Antifungal Activity of Endosequence Root Repair Material and Mineral Trioxide Aggregate

2014 ◽  
Vol 40 (11) ◽  
pp. 1815-1819 ◽  
Author(s):  
Fahd Alsalleeh ◽  
Nicole Chung ◽  
Lane Stephenson
Keyword(s):  
Antifungal Activity ◽  
Mineral Trioxide Aggregate ◽  
Repair Material ◽  
Root Repair

scholarly journals The Effect of Altered pH on Push-Out Bond Strength of Biodentin, Glass Ionomer Cement, Mineral Trioxide Aggregate and Theracal

2015 ◽  
Vol 62 (1) ◽  
pp. 7-13 ◽  
Author(s):  
Sameer Makkar ◽  
Ruchi Vashisht ◽  
Anita Kalsi ◽  
Pranav Gupta
Keyword(s):  
Bond Strength ◽  
Alkaline Medium ◽  
Gold Foil ◽  
Testing Machine ◽  
Glass Ionomer Cement ◽  
Mineral Trioxide Aggregate ◽  
Glass Ionomer ◽  
Human Teeth ◽  
Push Out ◽  
Ionomer Cement

Summary Introduction Throughout the history of dentistry, a wide variety of materials such as gold-foil, silver posts, amalgam, zinc oxide eugenol, glass ionomer cements, mineral trioxide aggregate have been used as retrograde fillings. Altered pH in periapical lesions can affect push-out bond strength of these materials. The aim of this study was to evaluate the effect of altered pH on push-out bond strength of Biodentin, Glass ionomer cement (GIC), Mineral trioxide aggregate (MTA) and Theracal. Material and Methods Forty-eight dentin slices of extracted single-rooted human teeth were sectioned and their canal portion instrumented to achieve a diameter of 1.4 mm. The specimens were then assigned into the four groups (one group for each material) with 12 samples in each group. All groups were further divided into 3 subgroups (with 4 specimens in each subgroup): acidic (butyric acid buffered at pH 6.4), neutral (phosphate buffer saline solution at pH 7.4) and alkaline (buffered potassium hydroxide at pH 8.4). Samples were incubated for 4 days at 37°C in acidic, neutral or alkaline medium. Push-out bond strength was measured using a Universal Testing Machine. The slices were examined under a stereomicroscope to determine the nature of bond failure. Results GIC showed the highest bond strength (33.33MPa) in neutral and acidic medium (26.75MPa) compared to other materials. Biodentin showed the best result in alkaline medium. Conclusion Altered pH level affected push-out bond strength of root end materials. GIC demonstrated good push-out bond strength that increased with decrease of pH whereas newer materials Biodentin and Theracal showed satisfying results in altered pH.

Sign in / Sign up

Export Citation Format

Share Document