scholarly journals Optimal Control of Wind Farm Energy Extraction and Beyond

2018 ◽  
Vol 43 (3) ◽  
pp. 266-272
Author(s):  
Jay Prakash GOIT
2015 ◽  
Vol 768 ◽  
pp. 5-50 ◽  
Author(s):  
Jay P. Goit ◽  
Johan Meyers

In very large wind farms, the vertical interaction with the atmospheric boundary layer plays an important role, i.e. the total energy extraction is governed by the vertical transport of kinetic energy from higher regions in the boundary layer towards the turbine level. In the current study, we investigate optimal control of wind-farm boundary layers, considering the individual wind turbines as flow actuators, whose energy extraction can be dynamically regulated in time so as to optimally influence the flow field and the vertical energy transport. To this end, we use large-eddy simulations of a fully developed pressure-driven wind-farm boundary layer in a receding-horizon optimal control framework. For the optimization of the wind-turbine controls, a conjugate-gradient optimization method is used in combination with adjoint large-eddy simulations for the determination of the gradients of the cost functional. In a first control study, wind-farm energy extraction is optimized in an aligned wind farm. Results are accumulated over one hour of operation. We find that the energy extraction is increased by 16 % compared to the uncontrolled reference. This is directly related to an increase of the vertical fluxes of energy towards the wind turbines, and vertical shear stresses increase considerably. A further analysis, decomposing the total stresses into dispersive and Reynolds stresses, shows that the dispersive stresses increase drastically, and that the Reynolds stresses decrease on average, but increase in the wake region, leading to better wake recovery. We further observe also that turbulent dissipation levels in the boundary layer increase, and overall the outer layer of the boundary layer enters into a transient decelerating regime, while the inner layer and the turbine region attain a new statistically steady equilibrium within approximately one wind-farm through-flow time. Two additional optimal control cases study penalization of turbulent dissipation. For the current wind-farm geometry, it is found that the ratio between wind-farm energy extraction and turbulent boundary-layer dissipation remains roughly around 70 %, but can be slightly increased by a few per cent by penalizing the dissipation in the optimization objective. For a pressure-driven boundary layer in equilibrium, we estimate that such a shift can lead to an increase in wind-farm energy extraction of 6 %.


2021 ◽  
Author(s):  
Sajad Esmaeili ◽  
Mohammad Amini ◽  
Amir Khorsandi ◽  
Seyed Hamid Fathi ◽  
Seyed Hossein Hosseinian ◽  
...  

Author(s):  
Daniel R. Herber ◽  
James T. Allison

Energy extraction from ocean waves and conversion to electrical energy is a promising form of renewable energy, yet achieving economic viability of wave energy converters (WECs) has proven challenging. In this article, the design of a heaving cylinder WEC will be explored. The optimal plant (i.e. draft and radius) design space with respect to the design’s optimal control (i.e. power take-off trajectory) for maximum energy production is characterized. Irregular waves based on the Bretschneider wave spectrum are considered. The optimization problem was solved using a pseudospectral method, a direct optimal control approach that can incorporate practical design constraints, such as power flow, actuation force, and slamming. The results provide early-stage guidelines for WEC design. Results show the resonance frequency required for optimal energy production with a regular wave is quite different than the resonance frequency found for irregular waves; specifically, it is much higher.


2018 ◽  
Author(s):  
Wim Munters ◽  
Johan Meyers

Abstract. Wake interactions between wind turbines in wind farms lead to reduced energy extraction in downstream rows. In recent work, optimization and large-eddy simulation were combined with optimal dynamic induction control of wind farms to study the mitigation of these effects, showing potential power gains of up to 20 % (Munters & Meyers 2017 Phil Trans R Soc A 375, 20160100, doi:10.1098/rsta.2016.0100). However, the computational cost associated with these optimal control simulations impedes practical implementation of this approach. Furthermore, the resulting control signals optimally react to the specific instantaneous turbulent flow realizations in the simulations, so that they cannot be simply used in general. The current work focuses on the detailed analysis of the optimization results of Munters & Meyers, with the aim to identify simplified control strategies that mimic the optimal control results and can be used in practice. The analysis shows that wind-farm controls are optimized in a parabolic manner with little upstream propagation of information. Moreover, turbines can be classified into first-row, intermediate-row, and last-row turbines based on their optimal control dynamics. At the moment, the control mechanisms for intermediate-row turbines remain unclear, but for first-row turbines we find that the optimal controls increase wake mixing by periodic shedding of vortex rings. This behavior can be mimicked with a simple sinusoidal thrust control strategy for first-row turbines, resulting in robust power gains for turbines in the entrance region of the farm.


Author(s):  
James T. Allison ◽  
Allen Kaitharath ◽  
Daniel R. Herber

Wave energy converters (WECs) extract energy from the motion of ocean waves. A variety of different WEC devices have been studied over the past several decades, with emphasis on cost-effective energy extraction. Active control has been shown to improve energy production significantly. Here we investigate energy extraction potential of a tethered heaving cylinder WEC using direct transcription (DT), an open-loop optimal control strategy. This enables direct inclusion of asymmetric constraints on power and tether force, practical considerations not considered in previous studies, and opens the door to WEC optimal control problems with more realistic nonlinear models and integration of control design with physical system design.


Sign in / Sign up

Export Citation Format

Share Document