scholarly journals Performance Evaluation of OFDM System for Different Modulation Techniques on the basis of Bit Error Rate and Peak to Average Power Ratio

2015 ◽  
Vol 1 (2) ◽  
pp. 32-36 ◽  
Author(s):  
Gagandeep Kaur ◽  
Shelly Garg
Keyword(s):  
Performance Evaluation ◽  
Bit Error Rate ◽  
Error Rate ◽  
Average Power ◽  
Power Ratio ◽  
Ofdm System ◽  
Modulation Techniques

Design and Simulation of OFDM System Based on Matlab

2014 ◽  
Vol 635-637 ◽  
pp. 1081-1085
Author(s):  
Xin Xin Sha ◽  
Jian Zhou ◽  
Yuan Xue Song
Keyword(s):  
Bit Error Rate ◽  
Error Rate ◽  
Channel Coding ◽  
Signal To Noise Ratio ◽  
Average Power ◽  
System Structure ◽  
Power Ratio ◽  
Basic System ◽  
Ofdm System ◽  
Signal To Noise

OFDM is a key modulation and multiplexing technique. The basic system structure of OFDM is introduced firstly. This paper chose appropriate implementation schemes for channel coding, PAPR(Peak To Average Power Ratio) reducing and synchronization of the OFDM system based on the minimum BER(Bit Error Rate). Finally, the paper realized the simulation and got the BER in different SNR(Signal To Noise Ratio) in the matlab environment .

scholarly journals THE REDUCTION OF PAPR IN OFDM BY USING NEW COMPANDING TRANSFORM

2014 ◽  
pp. 1-3
Author(s):  
T. NAGARAJU ◽  
K. RAMANAIDU
Keyword(s):  
Numerical Simulation ◽  
Theoretical Analysis ◽  
Bit Error Rate ◽  
Error Rate ◽  
Average Power ◽  
High Peak ◽  
Papr Reduction ◽  
Power Ratio ◽  
Main Drawback ◽  
Reduction Techniques

The main drawback of the OFDM is its high peak to average power ratio(PAPR).There are several PAPR reduction techniques. Among the various PAPR reduction techniques, companding transform is attractive for its simplicity and effectiveness. This paper proposes a new companding algorithm. The proposed algorithm offers an improved bit error rate and minimized out-of-band interference while reducing PAPR effectively, compared with the others. Theoretical analysis and numerical simulation are presented.

scholarly journals Analysis of the PAPR Behavior of the OFDM Passband Signal

2019 ◽  
Author(s):  
Frank Andrés Eras ◽  
Italo Alexander Carreño ◽  
Thomás Borja ◽  
Diego Javier Reinoso ◽  
Luis Urquiza-Aguiar ◽  
...  
Keyword(s):  
Bit Error Rate ◽  
Communication Systems ◽  
Orthogonal Frequency Division Multiplexing ◽  
Average Power ◽  
Wireless Communication Systems ◽  
Frequency Division Multiplexing ◽  
Power Ratio ◽  
Frequency Division ◽  
Ofdm System ◽  
High Power Amplifier

Orthogonal Frequency Division Multiplexing (OFDM) is a technique widely used in today's wireless communication systems due to its ability to combat the effects of multi-path in the signal. However, one of the main limitations of the use of OFDM is its high Peak-to-Average Power Ratio (PAPR), which reduces the efficiency of the OFDM system. The effects of PAPR can produce both out-of-band and in-band radiation, which degrades the signal by increasing the bit error rate (BER), this occurs in both baseband and bandpass sginals. In this document the effect of the PAPR in a OFDM passband signal is analyzed considering the implementation of a High Power Amplifier (HPA) and the Simple Amplitude Predistortion-Orthogonal Pilot Sequences (OPS-SAP) scheme to reduce the PAPR.

scholarly journals A New SLM-UFMC Model for Universal Filtered Multi-Carrier to Reduce Cubic Metric and Peak to Average Power Ratio in 5G Technology

Symmetry ◽  
2020 ◽  
Vol 12 (6) ◽  
pp. 909
Author(s):  
Farooq Sijal Shawqi ◽  
Lukman Audah ◽  
Salama A. Mostafa ◽  
Saraswathy Shamini Gunasekaran ◽  
Abdullah Baz ◽  
...  
Keyword(s):  
Bit Error Rate ◽  
Error Rate ◽  
Communication Systems ◽  
Average Power ◽  
Wireless Communication Systems ◽  
Power Ratio ◽  
Band Emission ◽  
Phase Rotation ◽  
Rotation Vectors ◽  
New Generation

The new generation of wireless communication systems has adopted different waveforms. The universal filtered multicarrier is one of the adopted candidates that has symmetry with various numerology designs. However, the high peak to average power ratio is one of the major limitations faced by universal filter multicarrier (UFMC) designers. Moreover, recent studies utilize cubic metric along with the peak to average power ratio (PAPR) to show the power back-off effect of the signal in which the PAPR metric identifies the maximum peak and the cubic metric (CM) identifies the Out of Band emission and In-Band distortion. Most of the current solutions, such as amplitude clipping, tone reservation, and active constellation extension, decrease the PAPR but cause degradation to the bit error rate. Selected mapping is one of the promising techniques that is recently used to solve the PAPR and CM problems without causing bit error rate (BER) degradation. In this paper, the selected mapping (SLM) is integrated with UFMC to reduce the PAPR and CM without affecting the BER of 5G networks. The SLM-UFMC solution model is simulated by MATLAB and the results show that the SLM-UFMC model presents better PAPR and CM performance without BER degradation. The PAPR has been decreased to 1.5 dB with respect to eight-phase rotation vectors and the CM decreased to 1.25 dB compared to the conventional UFMC.

scholarly journals Reduksi Peak-To-Average Power Ratio Pada Sistem STBC MIMO-OFDM dengan Metode Selected Mapping dan Partial Transmit Sequence

2017 ◽  
Vol 3 (1) ◽  
pp. 85
Author(s):  
Andi Maddanaca
Keyword(s):  
Bit Error Rate ◽  
Error Rate ◽  
High Power ◽  
Side Information ◽  
Average Power ◽  
Multipath Fading ◽  
Power Ratio ◽  
Partial Transmit Sequence ◽  
High Power Amplifier ◽  
Mimo Ofdm

Teknik OFDM merupakan teknik multicarrier yang mengefisienkan bandwidth. Penggunaan teknik OFDM dapat mengatasi multipath fading dan intersymbol interference (ISI). Namun demikian, OFDM mempunyai dua kelemahan, salah satunya adalah peak-to-average power ratio (PAPR) yang tinggi. PAPR yang tinggi akan menyebabkan distorsi nonlinear pada high power amplifier (HPA) karena HPA membatasi keluaran dengan nilai tertentu dan mengurangi efisiensi daya amplifier. Oleh karena itu, PAPR yang tinggi harus direduksi. Metode reduksi PAPR yang diajukan adalah dengan menggunakan metode Selected Mapping (SLM) dan Partial Transmit Sequence (PTS). Kedua metode ini memiliki kekurangan dalam hal kompleksitas multiplikasi dan penjumlahan dan adanya bit side information yang harus dikirimkan ke receiver. Oleh karena itu, penulis mengajukan pengembangan dari metode tersebut dengan memodifikasi faktor rotasi fasa menjadi pattern konversi terdefinisi yang lebih adaptif pada SLM, dan mengurangi iterasi pembangkitan faktor rotasi fasa pada metode PTS dengan pendefinisian faktor rotasi fasa yang terbatas. Hasil simulasi dengan 1000 simbol OFDM menunjukkan bahwa kemampuan reduksi PAPR pada metode m-SLM dan m-PTS mendekati kemampuan reduksi metode konvensional. Bit error rate (BER) yang dihasilkan juga mengalami perbaikan dibandingkan BER tanpa reduksi. m-SLM secara keseluruhan mengungguli kinerja dari m-PTS, baik pada nilai reduksi PAPR maupun pada perbaikan BER.

scholarly journals Blind Selected Mapping with Side Information Estimation Based on the Received Pilot Signal

2018 ◽  
Vol 2018 ◽  
pp. 1-9 ◽  
Author(s):  
Eunchul Yoon ◽  
Duckdong Hwang ◽  
Chanki Jang ◽  
Janghyun Kim ◽  
Unil Yun
Keyword(s):  
Bit Error Rate ◽  
Error Rate ◽  
Side Information ◽  
Average Power ◽  
Power Ratio ◽  
Pilot Symbol ◽  
Symbol Sequence ◽  
Pilot Signal ◽  
New Si ◽  
Ber Performance

Blind selected mapping (BSLM) is a technique to reduce the peak to average power ratio (PAPR) of OFDM by using a set of scrambling sequences. Since the side information (SI) on the scrambling sequence selected by the transmitter is not directly sent to the receiver in BSLM, the SI needs to be estimated by the receiver. In this paper, a BSLM scheme that applies a new SI estimation approach is proposed. The proposed BSLM scheme estimates the SI by selecting the minimum of the candidate metrics that are computed with the received pilot signal, the pilot symbol sequence, and the scrambling sequences. It is shown by simulation that the proposed BSLM scheme yields better SI error rate (SIER) and bit error rate (BER) performance and lower implementation complexity than four traditional BSLM schemes.

Sign in / Sign up

Export Citation Format

Share Document