Waste of pine seeds as bio-removal agent for methylene blue from aqueous solution: regeneration and single-stage batch design

2020 ◽  
Vol 204 ◽  
pp. 144-154
Author(s):  
Ahmed Mohmoud ◽  
Fethi Kooli ◽  
Yan Liu
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Single Stage

Using of modified-bentonite as low-cost sorbent for removal of methylene blue dye from aqueous solution

2020 ◽  
Vol 27 (2) ◽  
pp. 45-54
Author(s):  
Saraa Muwafaq Ibrahim ◽  
Ziad T. Abd Ali
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Silanol Group ◽  
Infrared Spectrometry ◽  
Blue Dye ◽  
Ammonium Bromide ◽  
Vibration Band ◽  
Order Kinetic ◽  
Methylene Blue Dye ◽  
Modified Bentonite

Batch experiments have been studied to remove methylene blue dye (MB) from aqueous solution using modified bentonite. The modified bentonite was synthesized by replacing exchangeable calcium cations in natural bentonite with cationic surfactant cetyl trimethyl ammonium bromide (CTAB). The characteristics of modified bentonite were studied using different analysis such as Scanning electronic microscopy (SEM), Fourier transform infrared spectrometry (FTIR) and surface area. Where SEM shows the natural bentonite has a porous structure, a rough and uneven appearance with scattered and different block structure sizes, while the modified bentonite surface morphology was smooth and supplemented by a limited number of holes. On other hand, (FTIR) analysis that proved NH group aliphatic and aromatic group of MB and silanol group are responsible for the sorption of contaminate. The organic matter peaks at 2848 and 2930 cm-1 in the spectra of modified bentonite which are sharper than those of the natural bentonite were assigned to the CH2 scissor vibration band and the symmetrical CH3 stretching absorption band, respectively, also the 2930 cm-1 peak is assigned to CH stretching band. The batch study was provided the maximum removal efficiency (99.99 % MB) with a sorption capacity of 129.87 mg/g at specified conditions (100 mg/L, 25℃, pH 11 and 250rpm). The sorption isotherm data fitted well with the Freundlich isotherm model. The kinetic studies were revealed that the sorption follows a pseudo-second-order kinetic model which indicates chemisorption between sorbent and sorbate molecules.

Pattern Formation in the Methylene Blue-Fructose-Oxygen System in Aqueous Solution and in Gel Systems

2000 ◽  
Vol 65 (9) ◽  
pp. 1394-1402 ◽  
Author(s):  
Ľubica Adamčíková ◽  
Mária Hupková ◽  
Peter Ševčík
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Pattern Formation ◽  
Alkaline Ph ◽  
Initial Reactant ◽  
Nonlinear Reaction ◽  
Oxygen System ◽  
Hydrodynamic Processes ◽  
Liquid Layer Thickness ◽  
Catalyzed Oxidation

Spatial patterns in methylene blue-catalyzed oxidation of fructose at alkaline pH were found in aqueous solution and in gel systems. In a thin liquid layer (thickness >2.4 mm) a mixture of spots and stripes was formed by interaction of a nonlinear reaction and the Rayleigh or Maragoni instabilities. The pattern formation was affected by initial reactant concentrations and by the thickness of the reaction mixture layer. Long-lasting structures were formed in gel systems (polyacrylamide, agar, gelatin). These patterns also arise primarily from hydrodynamic processes.

scholarly journals Sulfobetaine Cryogels for Preferential Adsorption of Methyl Orange from Mixed Dye Solutions

Polymers ◽  
2021 ◽  
Vol 13 (2) ◽  
pp. 208
Author(s):  
Ramona B. J. Ihlenburg ◽  
Anne-Catherine Lehnen ◽  
Joachim Koetz ◽  
Andreas Taubert
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Methyl Orange ◽  
Dye Removal ◽  
Selective Adsorption ◽  
Water Soluble ◽  
Organic Substances ◽  
Preferential Adsorption ◽  
Dimethyl Ammonium ◽  
Dye Solutions

New cryogels for selective dye removal from aqueous solution were prepared by free radical polymerization from the highly water-soluble crosslinker N,N,N’,N’-tetramethyl-N,N’-bis(2-ethylmethacrylate)-propyl-1,3-diammonium dibromide and the sulfobetaine monomer 2-(N-3-sulfopropyl-N,N-dimethyl ammonium)ethyl methacrylate. The resulting white and opaque cryogels have micrometer sized pores with a smaller substructure. They adsorb methyl orange (MO) but not methylene blue (MB) from aqueous solution. Mixtures of MO and MB can be separated through selective adsorption of the MO to the cryogels while the MB remains in solution. The resulting cryogels are thus candidates for the removal of hazardous organic substances, as exemplified by MO and MB, from water. Clearly, it is possible that the cryogels are also potentially interesting for removal of other compounds such as pharmaceuticals or pesticides, but this must be investigated further.

Citric acid modified waste cigarette filters for adsorptive removal of methylene blue dye from aqueous solution

2021 ◽  
pp. 50655
Author(s):  
Aafia Tehrim ◽  
Min Dai ◽  
Xiange Wu ◽  
Malik Muhammad Umair ◽  
Imran Ali ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Citric Acid ◽  
Blue Dye ◽  
Methylene Blue Dye ◽  
Adsorptive Removal

Sorptive Capture and Photo-Catalytic Degradation of Methylene Blue from Aqueous Solution Using Lead-Organic Frameworks

2021 ◽  
Vol 232 (6) ◽  
Author(s):  
Shoomaila Latif ◽  
Shamaila Iram ◽  
Muhammad Imran ◽  
Farah Kanwal ◽  
Zafar Iqbal ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Catalytic Degradation

scholarly journals Effect of pretreatment and temperature on the properties of Pinnularia biosilica frustules

RSC Advances ◽  
2014 ◽  
Vol 4 (99) ◽  
pp. 56200-56206 ◽  
Author(s):  
Erik Van Eynde ◽  
Britt Lenaerts ◽  
Tom Tytgat ◽  
Sammy W. Verbruggen ◽  
Birger Hauchecorne ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Material Characteristics

Material characteristics of cleaned diatom Pinnularia frustules are investigated and evaluated as adsorbents to remove methylene blue from aqueous solution.

Effects of Surface Properties and Solvent PH Values on the Adsorption/Desorption Abilities of Mesoporous SBA-15 to Methylene Blue Molecules

2012 ◽  
Vol 518-523 ◽  
pp. 352-355
Author(s):  
Hui Liu ◽  
Hong Liang Li ◽  
Meng Xue Wang ◽  
Jing Jing Sang ◽  
Xiu Song Zhao
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Pore Size Distribution ◽  
Pore Size ◽  
Surface Properties ◽  
Weak Base ◽  
Adsorption Ability ◽  
Ph Values ◽  
Model Molecule ◽  
Adsorption Desorption

Methylene blue (MB) was used as model molecule to investigate the effects of surface properties and solvent pH values on the adsorption and desorption (or release) behaviors of mesoporous SBA-15 materials. It was found that the treatment of SBA-15 with a pH 7.8 aqueous solution can enhance the adsorption rate and capacity in comparison with the pristine SBA-15. The effect of pH values on MB releasing from the weak base treated SBA-15 and the pristine one have been studied and been compared in pH values range from 0.5 to 7.0. Both of them showed a maximum releasing rate at about pH 2 and all of the treated SBA-15 samples showed a higher releasing quantity than the pristine ones. The influence mechanisms of base treatment on the adsorption ability and that of pH values on the releasing properties of SBA-15 samples have been analyzed and been discussed based on the composition, the morphology, the surface area and pore size distribution and adsorption/desorption measurements.

Sign in / Sign up

Export Citation Format

Share Document