Pinch point analysis of heat pump air-heating electroplating wastewater treatment system based on thermodynamics

2018 ◽  
Vol 107 ◽  
pp. 49-61
Author(s):  
Jing Yu ◽  
Sumin Jin ◽  
Liang Che
Keyword(s):  
Wastewater Treatment ◽  
Heat Pump ◽  
Treatment System ◽  
Pinch Point ◽  
Electroplating Wastewater ◽  
Wastewater Treatment System ◽  
Air Heating ◽  
Point Analysis

Performance of hybrid small wastewater treatment system consisting of jet mixed separator and rotating biological contactor

1997 ◽  
Vol 35 (6) ◽  
pp. 63-70 ◽  
Author(s):  
Yoshimasa Watanabe ◽  
Yoshihiko Iwasaki
Keyword(s):  
Wastewater Treatment ◽  
Electric Power ◽  
Hybrid System ◽  
Municipal Wastewater ◽  
Treatment Plant ◽  
Treatment System ◽  
Municipal Wastewater Treatment ◽  
Wastewater Treatment System ◽  
Pre Treatment ◽  
Organic Particles

This paper describes a pilot plant study on the performance of a hybrid small municipal wastewater treatment system consisting of a jet mixed separator(JMS) and upgraded RBC. The JMS was used as a pre-treatment of the RBC instead of the primary clarifier. The treatment capacity of the system was fixed at 100 m3/d, corresponding to the hydraulic loading to the RBC of 117 L/m2/d. The effluent from the grid chamber at a municipal wastewater treatment plant was fed into the hybrid system. The RBC was operated using the electric power produced by a solar electric generation panel with a surface area of 8 m2 under enough sunlight. In order to reduce the organic loading to the RBC, polyaluminium chloride(PAC) was added to the JMS influent to remove the colloidal and suspended organic particles. At the operational condition where the A1 dosage and hydraulic retention time of the JMS were fixed at 5 g/m3 and 45 min., respectively, the average effluent water quality of hybrid system was as follows: TOC=8 g/m3, Total BOD=8 g/m3, SS=8 g/m3, Turbidity=6 TU, NH4-N=7 g/m3, T-P=0.5 g/m3. In this operating condition, electric power consumption of the RBC for treating unit volume of wastewater is only 0.07 KWH/m3.

scholarly journals New Protocol and Architecture for a Wastewater Treatment System Intended for Irrigation

2021 ◽  
Vol 11 (8) ◽  
pp. 3648
Author(s):  
Jose M. Jimenez ◽  
Lorena Parra ◽  
Laura García ◽  
Jaime Lloret ◽  
Pedro V. Mauri ◽  
...  
Keyword(s):  
Wastewater Treatment ◽  
Energy Consumption ◽  
Oil Spills ◽  
Treatment System ◽  
Wastewater Treatment System ◽  
Biosorption Process ◽  
Daily Data ◽  
Salinity Levels ◽  
Main Canal ◽  
Sd Card

Water quality may be affected by aspects such as pollution from industries, agricultural fertilizers and pesticides, and waste produced by humans. This contamination can affect the produce of the fields irrigated by untreated water. Therefore, it is necessary to add a treatment process in irrigation systems. In this paper, an architecture, communication protocol, and a data analysis algorithm for a wastewater treatment system intended for irrigation are presented. Our system includes a smart group-based wireless sensor network that is able to detect high salinity levels and pollution stains, such as oil spills. When contamination is detected, the water is led into auxiliary canals that perform the biosorption process to treat the water and dump it back into the main canal. Simulations were performed to assess the amount of data stored on the secure digital (SD) card, the consumed bandwidth, and the energy consumption of our proposal. The results show the system has a low bandwidth consumption with a maximum of 2.58 kbps for the setting of two daily data transmissions of the node in the last auxiliary canal. Furthermore, it can sustain the energy consumption in adverse conditions, where the node with the highest energy consumption reaches the lowest energy value of 12,320 mW/h.

Sign in / Sign up

Export Citation Format

Share Document