scholarly journals Characteristics of Selected Waste-To-Energy Technologies and Suitability for Oman

Author(s):  
Wajeeha A. Qazi ◽  
Mohammed F.M. Abushammala

The fast economic development and urbanization caused rapid increase of waste generation worldwide. Oman produced 1.5 million tons of municipal solid waste (MSW) in 2012 which is expected to elevate to 1.89 million tons in 2030. This rapid increase needs to be tackled to reduce the generation rates along with the environmental impacts it imposes. Currently in Oman other than recycling there are no treatment facilities, and therefore dumping waste into the landfill is the only and ultimate way to dispose solid waste. Thus this research aims present the process and specific aspects of Waste-To-Energy (WTE) technologies and determine the suitable technology for Oman depending on its waste composition and characteristics. In conclusion, the waste characteristics shows the potential to set up a WTE technology in Oman which will help to reduce the amount of waste, greenhouse gas emissions, developing and maintaining costs of landfills, and tackle the issue of portable water by using the produced energy for seawater desalination.

2019 ◽  
Vol 45 (4) ◽  
pp. 441-449
Author(s):  
Riham A. Mohsen ◽  
Bassim Abbassi ◽  
Animesh Dutta ◽  
David Gordon

More light is being shed continually on the environmental impacts of municipal solid waste due to the increasing amounts of waste generated and the related greenhouse gas emissions. Emissions from MSW account for 20% of Canadian greenhouse gas (GHG) emissions and accordingly, waste legislation in Ontario demands high waste recovery and a moving towards a circular economy. This study evaluates the current municipal solid waste management in the City of Guelph and assesses possible alternative scenarios based on the associated GHG emissions. Waste Reduction Model (WARM) that was developed by the US-EPA has been used to quantify the GHG emissions produced over the entire life cycle of the MSW management scenario. Sensitivity analysis was also conducted to investigate the influence of some scenarios on the overall GHG emissions. It has been found that one ton of landfilled waste generates approximately 0.39 ton of carbon dioxide equivalent (CO2Eq). It was also found that the current solid waste scenario has a saving of 36086 million ton of CO2Eq (MCO2Eq). However, the results showed that the scenario with enhanced waste-to-energy, reduction at source and recycling has resulted in a high avoided emissions (0.74 kg CO2Eq/kg MSW). The anaerobic Digestion scenario caused the lowest avoided emissions of 0.39 kg CO2Eq/kg MSW. The net avoided emissions for reduction at source scenario were found to be the same as that found by the current scenario (0.4 kg CO2Eq/kg MSW). The sensitivity analysis of both reduction at source and recycling rates show a linear inverse proportional relationship with total GHG emissions reduction.


2011 ◽  
Vol 30 (2) ◽  
pp. 155-160 ◽  
Author(s):  
Evgheni Ermolaev ◽  
Mikael Pell ◽  
Sven Smårs ◽  
Cecilia Sundberg ◽  
Håkan Jönsson

Data on greenhouse gas (GHG) emissions from full-scale composting of municipal solid waste, investigating the effects of process temperature and aeration combinations, is scarce. Oxygen availability affects the composition of gases emitted during composting. In the present study, two experiments with three covered windrows were set up, treating a mixture of source separated biodegradable municipal solid waste (MSW) fractions from Uppsala, Sweden, and structural amendment (woodchips, garden waste and re-used compost) in the volume proportion 1:2. The effects of different aeration and temperature settings on the emission of methane (CH4), nitrous oxide (N2O) and carbon dioxide (CO2) during windrow composting with forced aeration following three different control schemes were studied. For one windrow, the controller was set to keep the temperature below 40 °C until the pH increased, another windrow had minimal aeration at the beginning of the process and the third one had constant aeration. In the first experiment, CH4 concentrations (CH4:CO2 ratio) increased, from around 0.1% initially to between 1 and 2% in all windrows. In the second experiment, the initial concentrations of CH4 displayed similar patterns of increase between windrows until day 12, when concentration peaked at 3 and 6%, respectively, in two of the windrows. In general, the N2O fluxes remained low (0.46 ± 0.02 ppm) in the experiments and were two to three times the ambient concentrations. In conclusion, the emissions of CH4 and N2O were low regardless of the amount of ventilation. The data indicates a need to perform longer experiments in order to observe further emission dynamics.


2019 ◽  
Vol 27 (4) ◽  
pp. 435-446
Author(s):  
Obadia Kyetuza Bishoge ◽  
Xinmei Huang ◽  
Lingling Zhang ◽  
Hongzhi Ma ◽  
Charity Danyo

Currently, there are an estimated 1.3 billion tonnes of municipal solid waste (MSW) generated per year globally, and this quantity is predicted to increase to 2.2 billion tonnes annually by 2025. If not well treated, this rapid growth of waste products can lead to socio-economic and environmental problems. Waste is potentially a misplaced valuable resource that can be converted and utilized in different ways such as renewable energy resources for the realization of sustainable development. Presently, waste-to-energy technologies (WtETs) are considered to be an encouraging advanced technology that is applied to convert MSW into a renewable energy resource (methane, biogas, biofuels or biodiesel, ethanol, syngas, or alcohol). WtETs can be biochemical (fermentation, anaerobic digestion, landfill with gas capture, and microbial fuel cell), thermochemical (incineration, thermal gasification, and pyrolysis), or chemical (esterification). This review mainly aims to provide an overview of the applications of these technologies by focusing on anaerobic digestion as biological (nonthermal) treatment technologies, and incineration, pyrolysis, and gasification processes as thermal treatment processes. Landfill gas utilization technologies, biological hydrogen production processes, and microbial fuel cells also are assessed. In addition, the contemporary risks and challenges of WtETs are reviewed.


2021 ◽  
Vol 13 (1) ◽  
pp. 54-60
Author(s):  
Saumya Singh ◽  
Jeeoot Singh

In India, rate of waste generation varies from 0.12-0.60 kg/capita/day. This paper lists established solid waste management practices in India by providing the latest factual data from various reports and surveys being conducted in India in the period 2016 and beyond. This paper also gives an insight into some of the recent studies that have been in India related to solid waste and waste to energy technologies by describing their study area along with mentioning their critical observations.


Processes ◽  
2019 ◽  
Vol 7 (10) ◽  
pp. 676 ◽  
Author(s):  
Yong ◽  
Bashir ◽  
Ng ◽  
Sethupathi ◽  
Lim ◽  
...  

As Malaysia is a fast-developing country, its prospects of sustainable energy generation are at the center of debate. Malaysian municipal solid waste (MSW) is projected to have a 3.3% increase in annual generation rate at the same time an increase of 3.3% for electricity demand. In Malaysia, most of the landfills are open dumpsite and 89% of the collected MSW end up in landfills. Furthermore, huge attention is being focused on converting MSW into energy due to the enormous amount of daily MSW being generated. Sanitary landfill to capture methane from waste landfill gas (LFG) and incineration in a combined heat and power plant (CHP) are common MSW-to-energy technologies in Malaysia. MSW in Malaysia contains 45% organic fraction thus landfill contributes as a potential LFG source. Waste-to-energy (WTE) technologies in treating MSW potentially provide an attractive economic investment since its feedstock (MSW) is collected almost for free. At present, there are considerable issues in WTE technologies although the technology employing MSW as feedstock are well established, for instance the fluctuation of MSW composition and the complexity in treatment facilities with its pollutant emissions. Thus, this study discusses various WTE technologies in Malaysia by considering the energy potentials from all existing incineration plants and landfill sites as an effective MSW management in Malaysia. Furthermore, to promote local innovation and technology development and to ensure successful long-term sustainable economic viability, social inclusiveness, and environmental sustainability in Malaysia, the four faculties of sustainable development namely technical, economic, environmental, and social issues affiliated with MSW-to-Energy technologies were compared and evaluated.


Sign in / Sign up

Export Citation Format

Share Document