Current State of Operation and Improvement Plan for Corrections Linked to the Curriculum of Hansung University Writing Center

2021 ◽  
Vol 3 ◽  
pp. 175-203
Author(s):  
Sun-Ok Park
Keyword(s):  
Writing Center ◽  
Improvement Plan ◽  
Current State

scholarly journals Analisis Waste dalam Aliran Material Internal dengan Value Stream Mapping Pada PT XYZ

2012 ◽  
Vol 3 (1) ◽  
pp. 490
Author(s):  
Gita Ayu ◽  
Jeffry Hanggara ◽  
David Kurniawan ◽  
Gunawan Gunawan
Keyword(s):  
Value Stream Mapping ◽  
Inventory Level ◽  
Safety Stock ◽  
Value Stream ◽  
Traceability System ◽  
Improvement Plan ◽  
Reorder Point ◽  
Current State ◽  
Cycle Efficiency ◽  
System Characteristics

The main focus of the research is excess inventory and motion waste which commonly occur in warehouse and production floor. This research is carried out to minimize the average level and eliminate unnecessary motions, with consideration of electronic pull and traceability system characteristics. Product X, the highest-selling product, is the object of this research. To identify the current condition, the current state Value Stream Mapping (VSM) is developed as the basis to arrange improvement plan to minimize the wastes. Safety stock is determined through average and maximum consumption difference; and reorder point is determined to comply with pull approach. Average inventory level is calculated using continuous review method. The simulation was conducted and it was shown that 8.29 minutes is the maximum lateness. Thus, safety stock and reorder point are adjusted accordingly to anticipate stockout due to lateness. The improvement of process cycle efficiency is shown to increase from 4.1 % to 5.1 % as projected in future state VSM.

scholarly journals Survey of the current state of food labeling and examination of the improvement plan

2020 ◽  
Vol 56 (Supplement) ◽  
pp. 2E1-06-2E1-06
Author(s):  
Kayo TOYAMA ◽  
Nami IBUCHI ◽  
Ryoji YOSHITAKE
Keyword(s):  
Food Labeling ◽  
Improvement Plan ◽  
Current State

An Analysis of the Safety Education for Foreign Laborer in Construction Site

2013 ◽  
Vol 671-674 ◽  
pp. 3083-3086 ◽  
Author(s):  
Yoon Seok Shin ◽  
Seok Hoon Nam ◽  
Tae Yong Kim ◽  
Gwang Hee Kim
Keyword(s):  
Social Issue ◽  
Construction Workers ◽  
Current Status ◽  
Foreign Workers ◽  
Construction Site ◽  
Safety Education ◽  
Industrial Accidents ◽  
Construction Sites ◽  
Improvement Plan ◽  
Current State

In recent years, the number of foreign workers employed on construction sites in Korea has been on the rise, and industrial accidents involving foreign workers have become a social issue. Yet despite this fact, the interest in safety education for foreign workers has still been relatively low. For this reason, the purpose of this study is to analyze the current state of safety education for foreign construction workers. To conduct an analysis of the current status, we surveyed foreign construction workers currently working at construction sites. Based on the results of this survey, we have derived an outline for an improvement plan founded on an awareness of and problems in safety education for foreign workers.

ESEM - A multipurpose surface Electron Microscope

1986 ◽  
Vol 44 ◽  
pp. 632-633 ◽  
Author(s):  
G.D. Danilatos
Keyword(s):  
Electron Microscope ◽  
Room Temperature ◽  
Environmental Scanning ◽  
Gas Composition ◽  
Saturated Water Vapor ◽  
Surface Electron ◽  
Current State ◽  
Saturated Water ◽  
New Type ◽  
Temperature And Pressure

Over recent years a new type of electron microscope - the environmental scanning electron microscope (ESEM) - has been developed for the examination of specimen surfaces in the presence of gases. A detailed series of reports on the system has appeared elsewhere. A review summary of the current state and potential of the system is presented here.The gas composition, temperature and pressure can be varied in the specimen chamber of the ESEM. With air, the pressure can be up to one atmosphere (about 1000 mbar). Environments with fully saturated water vapor only at room temperature (20-30 mbar) can be easily maintained whilst liquid water or other solutions, together with uncoated specimens, can be imaged routinely during various applications.

Recent applications of TEM to the study of interfaces

1990 ◽  
Vol 48 (4) ◽  
pp. 308-309
Author(s):  
C. Barry Carter
Keyword(s):  
High Resolution ◽  
Sample Preparation ◽  
Grain Boundaries ◽  
Diffuse Scattering ◽  
Imaging Techniques ◽  
Amorphous Material ◽  
Contrast Imaging ◽  
Current State ◽  
Actual Nature ◽  
High Resolution Images

This paper will review the current state of understanding of interface structure and highlight some of the future needs and problems which must be overcome. The study of this subject can be separated into three different topics: 1) the fundamental electron microscopy aspects, 2) material-specific features of the study and 3) the characteristics of the particular interfaces. The two topics which are relevant to most studies are the choice of imaging techniques and sample preparation. The techniques used to study interfaces in the TEM include high-resolution imaging, conventional diffraction-contrast imaging, and phase-contrast imaging (Fresnel fringe images, diffuse scattering). The material studied affects not only the characteristics of the interfaces (through changes in bonding, etc.) but also the method used for sample preparation which may in turn have a significant affect on the resulting image. Finally, the actual nature and geometry of the interface must be considered. For example, it has become increasingly clear that the plane of the interface is particularly important whenever at least one of the adjoining grains is crystalline.A particularly productive approach to the study of interfaces is to combine different imaging techniques as illustrated in the study of grain boundaries in alumina. In this case, the conventional imaging approach showed that most grain boundaries in ion-thinned samples are grooved at the grain boundary although the extent of this grooving clearly depends on the crystallography of the surface. The use of diffuse scattering (from amorphous regions) gives invaluable information here since it can be used to confirm directly that surface grooving does occur and that the grooves can fill with amorphous material during sample preparation (see Fig. 1). Extensive use of image simulation has shown that, although information concerning the interface can be obtained from Fresnel-fringe images, the introduction of artifacts through sample preparation cannot be lightly ignored. The Fresnel-fringe simulation has been carried out using a commercial multislice program (TEMPAS) which was intended for simulation of high-resolution images.

Proteasome inhibitors as therapeutics

2005 ◽  
Vol 41 ◽  
pp. 205-218
Author(s):  
Constantine S. Mitsiades ◽  
Nicholas Mitsiades ◽  
Teru Hideshima ◽  
Paul G. Richardson ◽  
Kenneth C. Anderson
Keyword(s):  
Multiple Myeloma ◽  
Drug Class ◽  
Proteasome Inhibitors ◽  
Cell Cycle Regulators ◽  
Current State ◽  
Intracellular Mechanism ◽  
Ubiquitin Proteasome ◽  
Proteasome Pathway ◽  
Hodgkin's Lymphomas ◽  
Clinical Research Data

The ubiquitin–proteasome pathway is a principle intracellular mechanism for controlled protein degradation and has recently emerged as an attractive target for anticancer therapies, because of the pleiotropic cell-cycle regulators and modulators of apoptosis that are controlled by proteasome function. In this chapter, we review the current state of the field of proteasome inhibitors and their prototypic member, bortezomib, which was recently approved by the U.S. Food and Drug Administration for the treatment of advanced multiple myeloma. Particular emphasis is placed on the pre-clinical research data that became the basis for eventual clinical applications of proteasome inhibitors, an overview of the clinical development of this exciting drug class in multiple myeloma, and a appraisal of possible uses in other haematological malignancies, such non-Hodgkin's lymphomas.

Behavioral Genetics: Concepts for Research and Practice in Language Development and Disorders

1995 ◽  
Vol 38 (5) ◽  
pp. 1126-1142 ◽  
Author(s):  
Jeffrey W. Gilger
Keyword(s):  
Language Development ◽  
Behavioral Genetics ◽  
State Of The Art ◽  
Genetic Research ◽  
Great Promise ◽  
Behavioral Genetic ◽  
Fine Grained ◽  
Future Goals ◽  
Current State ◽  
Research Designs

This paper is an introduction to behavioral genetics for researchers and practioners in language development and disorders. The specific aims are to illustrate some essential concepts and to show how behavioral genetic research can be applied to the language sciences. Past genetic research on language-related traits has tended to focus on simple etiology (i.e., the heritability or familiality of language skills). The current state of the art, however, suggests that great promise lies in addressing more complex questions through behavioral genetic paradigms. In terms of future goals it is suggested that: (a) more behavioral genetic work of all types should be done—including replications and expansions of preliminary studies already in print; (b) work should focus on fine-grained, theory-based phenotypes with research designs that can address complex questions in language development; and (c) work in this area should utilize a variety of samples and methods (e.g., twin and family samples, heritability and segregation analyses, linkage and association tests, etc.).

Sign in / Sign up

Export Citation Format

Share Document