scholarly journals Sequential adsorption - photocatalytic oxidation process for wastewater treatment using a composite material TiO2/activated carbon

2015 ◽  
Vol 20 (2) ◽  
pp. 181-189 ◽  
Author(s):  
Caroline Andriantsiferana ◽  
Elham Farouk Mohamed ◽  
Henri Delmas
Keyword(s):  
Composite Material ◽  
Wastewater Treatment ◽  
Activated Carbon ◽  
Photocatalytic Oxidation ◽  
Oxidation Process ◽  
Sequential Adsorption

EFFICIENT DEGRADATION OF CLOFIBRIC ACID BY HETEROGENEOUS PHOTOCATALYTIC OXIDATION PROCESS

2019 ◽  
Vol 18 (8) ◽  
pp. 1683-1692 ◽  
Author(s):  
Lidia Favier ◽  
Lacramioara Rusu ◽  
Andrei Ionut Simion ◽  
Raluca Maria Hlihor ◽  
Mariana Liliana Pacala ◽  
...  
Keyword(s):  
Photocatalytic Oxidation ◽  
Oxidation Process ◽  
Clofibric Acid

New Biology for Advanced Wastewater Treatment

1999 ◽  
Vol 40 (4-5) ◽  
pp. 137-144 ◽  
Author(s):  
K. Miserez ◽  
S. Philips ◽  
W. Verstraete
Keyword(s):  
Wastewater Treatment ◽  
Activated Carbon ◽  
Organic Carbon ◽  
Genetically Modified Organisms ◽  
New Technologies ◽  
Chemical Oxidation ◽  
Advanced Treatment ◽  
Biological Activated Carbon ◽  
Catabolic Potential ◽  
New Biology

A number of new technologies for the advanced treatment of wastewater have recently been developed. The oxidative cometabolic transformation by methanotrophs and by nitrifiers represent new approaches in relation to organic carbon. The Biological Activated Carbon Oxidative Filters characterized by thin biofilms are also promising in that respect. Moreover, implementing genetically modified organisms with improved catabolic potential in advanced water treatment comes into perspective. For very refractory effluents chemical support techniques, like e.g. strong chemical oxidation, can be lined up with advanced biology.

scholarly journals Performance of Iron-Functionalized Activated Carbon Catalysts (Fe/AC-f) on CWPO Wastewater Treatment

Catalysts ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 337
Author(s):  
Sara Mesa Medina ◽  
Ana Rey ◽  
Carlos Durán-Valle ◽  
Ana Bahamonde ◽  
Marisol Faraldos
Keyword(s):  
Wastewater Treatment ◽  
Activated Carbon ◽  
Landfill Leachate ◽  
Surface Composition ◽  
Treatment Plant ◽  
Reaction Medium ◽  
Pollutant Removal ◽  
Operating Conditions ◽  
Water Matrix ◽  
The Stability

Two commercial activated carbon were functionalized with nitric acid, sulfuric acid, and ethylenediamine to induce the modification of their surface functional groups and facilitate the stability of corresponding AC-supported iron catalysts (Fe/AC-f). Synthetized Fe/AC-f catalysts were characterized to determine bulk and surface composition (elemental analysis, emission spectroscopy, XPS), textural (N2 isotherms), and structural characteristics (XRD). All the Fe/AC-f catalysts were evaluated in the degradation of phenol in ultrapure water matrix by catalytic wet peroxide oxidation (CWPO). Complete pollutant removal at short reaction times (30–60 min) and high TOC reduction (XTOC = 80 % at ≤ 120 min) were always achieved at the conditions tested (500 mg·L−1 catalyst loading, 100 mg·L−1 phenol concentration, stoichiometric H2O2 dose, pH 3, 50 °C and 200 rpm), improving the results found with bare activated carbon supports. The lability of the interactions of iron with functionalized carbon support jeopardizes the stability of some catalysts. This fact could be associated to modifications of the induced surface chemistry after functionalization as a consequence of the iron immobilization procedure. The reusability was demonstrated by four consecutive CWPO cycles where the activity decreased from 1st to 3rd, to become recovered in the 4th run. Fe/AC-f catalysts were applied to treat two real water matrices: the effluent of a wastewater treatment plant with a membrane biological reactor (WWTP-MBR) and a landfill leachate, opening the opportunity to extend the use of these Fe/AC-f catalysts for complex wastewater matrices remediation. The degradation of phenol spiked WWTP-MBR effluent by CWPO using Fe/AC-f catalysts revealed pH of the reaction medium as a critical parameter to obtain complete elimination of the pollutant, only reached at pH 3. On the contrary, significant TOC removal, naturally found in complex landfill leachate, was obtained at natural pH 9 and half stoichiometric H2O2 dose. This highlights the importance of the water matrix in the optimization of the CWPO operating conditions.

A review on TiO2-based composites for superior photocatalytic activity

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Wail Al Zoubi ◽  
Abbas Ali Salih Al-Hamdani ◽  
Baek Sunghun ◽  
Young Gun Ko
Keyword(s):  
Photocatalytic Activity ◽  
Organic Pollutants ◽  
Cost Efficiency ◽  
High Stability ◽  
Photocatalytic Oxidation ◽  
Oxidation Process ◽  
Ambient Conditions ◽  
Photoelectrochemical Activity ◽  
As Doping ◽  
Degradation Of Pollutants

Abstract Heterogeneous photocatalysts was a promising material for removing organic pollutants. Titanium dioxide (TiO2) was a suitable photocatalyst for its cost efficiency and high stability to reduce various pollutants. Enhancing TiO2 photocatalyst performance by doping with changed metals or non-metal ions and organic compounds have been reviewed. These methods could enhance photoelectrochemical activity via: (i) by a donor of electrons via electron-donor agents that would produce particular defects in TiO2 structure and capture transporters of charge; (ii) by reducing recombination rate of the charge transporters and increasing degradation of pollutants. This study investigates the modification approaches of TiO2 that comprise methods for overcoming the essential TiO2 restrictions and enhancing the photocatalytic degradation of organic pollutants. Consequently, it emphasized on the current progress of modified-TiO2 used for different pollutants in ambient conditions. Amendment techniques, such as inorganic and organic parts as doping, are studied. The reported experimental results obtained with the photocatalytic oxidation process for degrading organic pollutants were also collected and assessed.

Sign in / Sign up

Export Citation Format

Share Document