A Two-Component Fiber-Optic LDV System for Automotive Aerodynamics Research

1988 ◽  
Author(s):  
Antonello Cogotti
Keyword(s):  
Fiber Optic ◽  
Two Component ◽  
Automotive Aerodynamics

Laser-Doppler Measurements of Velocities Just Downstream of a Collapsible Tube During Flow-Induced Oscillations

2001 ◽  
Vol 123 (5) ◽  
pp. 493-499 ◽  
Author(s):  
C. D. Bertram ◽  
G. Diaz de Tuesta ◽  
A. H. Nugent
Keyword(s):  
Cross Section ◽  
Fiber Optic ◽  
Reverse Flow ◽  
Laser Doppler Anemometer ◽  
Laser Doppler ◽  
Axial Component ◽  
Collapsible Tube ◽  
Two Component ◽  
Flow Through ◽  
The Cross

The flow field less than one diameter downstream of the end of a collapsible tube executing self-excited oscillations was examined using a two-component fiber-optic laser-Doppler anemometer. The time-averaged Reynolds number of the flow was 11,000. With the tube oscillating periodically, results obtained during many cycles of oscillation were combined to yield surface plots of the axial component over the cross section at 16 phases of the cycle. By combining measurements obtained with the laser probe in two different orientations, secondary flow vectors over the cross section were likewise constructed for 16 phases. The measurements showed strongly phasic turbulence intensity, with the phase of high intensity coinciding with the time of maximal tube collapse. Reverse flow occurred during much of the cycle, at places in the cross section that agree with our previous observations of laminar and turbulent steady flow through a rigid simulated collapsed tube.

Spectroscopic Observations of Visual Double Stars

1965 ◽  
Vol 5 ◽  
pp. 109-111
Author(s):  
Frederick R. West
Keyword(s):  
Radial Velocity ◽  
High Dispersion ◽  
Velocity Difference ◽  
Spectrograph Slit ◽  
Spectroscopic Observations ◽  
Double Stars ◽  
Visual Double Stars ◽  
Relative Orbit ◽  
Two Component ◽  
Star Images

There are certain visual double stars which, when close to a node of their relative orbit, should have enough radial velocity difference (10-20 km/s) that the spectra of the two component stars will appear resolved on high-dispersion spectrograms (5 Å/mm or less) obtainable by use of modern coudé and solar spectrographs on bright stars. Both star images are then recorded simultaneously on the spectrograph slit, so that two stellar components will appear on each spectrogram.

Imaging and diffraction modes in Scanning Transmission Electron Microscopy

1986 ◽  
Vol 44 ◽  
pp. 684-687
Author(s):  
J. M. Cowley ◽  
R. Glaisher ◽  
J. A. Lin ◽  
H.-J. Ou
Keyword(s):  
Scanning Transmission Electron Microscopy ◽  
High Efficiency ◽  
Fiber Optic ◽  
Image Intensifier ◽  
Detector System ◽  
Detector Plane ◽  
Secondary Electrons ◽  
Transmission Electron ◽  
Scanning Transmission ◽  
Special Detector

Some of the most important applications of STEM depend on the variety of imaging and diffraction made possible by the versatility of the detector system and the serial nature, of the image acquisition. A special detector system, previously described, has been added to our STEM instrument to allow us to take full advantage of this versatility. In this, the diffraction pattern in the detector plane may be formed on either of two phosphor screens, one with P47 (very fast) phosphor and the other with P20 (high efficiency) phosphor. The light from the phosphor is conveyed through a fiber-optic rod to an image intensifier and TV system and may be photographed, recorded on videotape, or stored digitally on a frame store. The P47 screen has a hole through it to allow electrons to enter a Gatan EELS spectrometer. Recently a modified SEM detector has been added so that high resolution (10Å) imaging with secondary electrons may be used in conjunction with other modes.

A technique for protecting delicate specimens during processing

1989 ◽  
Vol 47 ◽  
pp. 982-983
Author(s):  
R.J. Mount ◽  
R.V. Harrison
Keyword(s):  
Basilar Membrane ◽  
Low Cost ◽  
Organ Of Corti ◽  
Region Of Interest ◽  
Sensory Epithelium ◽  
Physical Damage ◽  
Air Drying ◽  
Specimen Handling ◽  
Two Component

The sensory end organ of the ear, the organ of Corti, rests on a thin basilar membrane which lies between the bone of the central modiolus and the bony wall of the cochlea. In vivo, the organ of Corti is protected by the bony wall which totally surrounds it. In order to examine the sensory epithelium by scanning electron microscopy it is necessary to dissect away the protective bone and expose the region of interest (Fig. 1). This leaves the fragile organ of Corti susceptible to physical damage during subsequent handling. In our laboratory cochlear specimens, after dissection, are routinely prepared by the O-T- O-T-O technique, critical point dried and then lightly sputter coated with gold. This processing involves considerable specimen handling including several hours on a rotator during which the organ of Corti is at risk of being physically damaged. The following procedure uses low cost, readily available materials to hold the specimen during processing ,preventing physical damage while allowing an unhindered exchange of fluids.Following fixation, the cochlea is dehydrated to 70% ethanol then dissected under ethanol to prevent air drying. The holder is prepared by punching a hole in the flexible snap cap of a Wheaton vial with a paper hole punch. A small amount of two component epoxy putty is well mixed then pushed through the hole in the cap. The putty on the inner cap is formed into a “cup” to hold the specimen (Fig. 2), the putty on the outside is smoothed into a “button” to give good attachment even when the cap is flexed during handling (Fig. 3). The cap is submerged in the 70% ethanol, the bone at the base of the cochlea is seated into the cup and the sides of the cup squeezed with forceps to grip it (Fig.4). Several types of epoxy putty have been tried, most are either soluble in ethanol to some degree or do not set in ethanol. The only putty we find successful is “DUROtm MASTERMENDtm Epoxy Extra Strength Ribbon” (Loctite Corp., Cleveland, Ohio), this is a blue and yellow ribbon which is kneaded to form a green putty, it is available at many hardware stores.

Fifth virial coefficient of a two-component mixture of hard discs

1997 ◽  
Vol 90 (4) ◽  
pp. 679-681
Author(s):  
F. SAIJA ◽  
G. FIUMARA ◽  
P.V. GIAQUINTA
Keyword(s):  
Virial Coefficient ◽  
Component Mixture ◽  
Two Component

Phase transitions and shapes of two component membranes and vesicles II : weak segregation limit

1994 ◽  
Vol 4 (8) ◽  
pp. 1333-1362 ◽  
Author(s):  
Takashi Taniguchi ◽  
Kyozi Kawasaki ◽  
David Andelman ◽  
Toshihiro Kawakatsu
Keyword(s):  
Phase Transitions ◽  
Two Component

Strongly coupled nonneutral plasmas : Equilibrium and relaxation in two-component plasmas in Penning-Malmberg trap

2000 ◽  
Vol 10 (PR5) ◽  
pp. Pr5-271-Pr5-274
Author(s):  
H. Totsuji ◽  
K. Tsuruta ◽  
C. Totsuji ◽  
K. Nakano ◽  
T. Kishimoto ◽  
...  
Keyword(s):  
Strongly Coupled ◽  
Nonneutral Plasmas ◽  
Two Component

Synthesis, performance and growth mechanism of silver nanoparticle coated SERS fiber probe

2019 ◽  
Vol 107 (3) ◽  
pp. 305
Author(s):  
Mengmei Geng ◽  
Yuting Long ◽  
Tongqing Liu ◽  
Zijuan Du ◽  
Hong Li ◽  
...  
Keyword(s):  
Silver Nanoparticles ◽  
Absorption Spectrum ◽  
Reaction Time ◽  
Growth Mechanism ◽  
Fiber Optic ◽  
Fiber Optic Probe ◽  
Visible Absorption ◽  
Fiber Probe ◽  
Surface Enhanced Raman ◽  
Optic Probe

Surface-enhanced Raman Scattering (SERS) fiber probe provides abundant interaction area between light and materials, permits detection within limited space and is especially useful for remote or in situ detection. A silver decorated SERS fiber optic probe was prepared by hydrothermal method. This method manages to accomplish the growth of silver nanoparticles and its adherence on fiber optic tip within one step, simplifying the synthetic procedure. The effects of reaction time on phase composition, surface plasmon resonance property and morphology were investigated by X-ray diffraction analysis (XRD), ultraviolet-visible absorption spectrum (UV-VIS absorption spectrum) and scanning electron microscope (SEM). The results showed that when reaction time is prolonged from 4–8 hours at 180 °C, crystals size and size distribution of silver nanoparticles increase. Furthermore, the morphology, crystal size and distribution density of silver nanoparticles evolve along with reaction time. A growth mechanism based on two factors, equilibrium between nucleation and growth, and the existence of PVP, is hypothesized. The SERS fiber probe can detect rhodamin 6G (R6G) at the concentration of 10−6 M. This SERS fiber probe exhibits promising potential in organic dye and pesticide residue detection.

Sign in / Sign up

Export Citation Format

Share Document