Experimental Validation and Optimization of Computational Methods for High Pressure Fuel Pipe Brazed Joints

2018 ◽  
Author(s):  
Issam Mashal ◽  
Boyang Zhang ◽  
Xiangning Zhu ◽  
Guobiao Yang ◽  
Lianxiang Yang
Keyword(s):  
High Pressure ◽  
Computational Methods ◽  
Experimental Validation ◽  
Brazed Joints

Design and Analysis of a High Pressure Turbine Using Computational Methods for Small Gas Turbine Application

2013 ◽  
Author(s):  
Kishor Kumar ◽  
R. Prathapanayaka ◽  
S. V. Ramana Murthy ◽  
S. Kishore Kumar ◽  
T. M. Ajay Krishna
Keyword(s):  
High Pressure ◽  
Gas Turbine ◽  
Computational Methods ◽  
Gas Turbine Engine ◽  
Flow Coefficient ◽  
Design Parameters ◽  
Convergence Criterion ◽  
Turbine Engine ◽  
Design Point ◽  
Ansys Cfx

This paper describes the aerodynamic design and analysis of a high-pressure, single-stage axial flow turbine suitable for small gas turbine engine application using computational methods. The specifications of turbine were based on the need of a typical high-pressure compressor and geometric restrictions of small gas turbine engine. Baseline design parameters such as flow coefficient, stage loading coefficient are close to 0.23 and 1.22 respectively with maximum flow expansion in the NGV rows. In the preliminary design mode, the meanline approach is used to generate the turbine flow path and the design point performance is achieved by considering three blade sections at hub, mean and tip using the AMDC+KO+MK+BSM loss models to meet the design constraints. An average exit swirl angle of less than 5 degrees is achieved leading to minimum losses in the stage. Also, NGV and rotor blade numbers were chosen based on the optimum blade solidity. Blade profile is redesigned using the results from blade-to-blade analysis and through-flow analysis based on an enhanced Dawes BTOB3D flow solver. Using PbCFD (Pushbutton CFD) and commercially available CFD software ANSYS-CFX, aero-thermodynamic parameters like pressure ratios, aerodynamic power, and efficiencies are computed and these results are compared with one another. The boundary conditions, convergence criterion, and turbulence model used in CFD computations are set uniform for comparison with 8 per cent turbulence intensity. Grid independence study is performed at design point to optimize the grid density for off-design performance predictions. ANSYS-CFX and PbCFD have predicted higher efficiency of 3.4% and 1.2% respectively with respect to targeted efficiency of 89 per cent.

700 bar type IV high pressure hydrogen storage vessel burst – Simulation and experimental validation

2015 ◽  
Vol 40 (38) ◽  
pp. 13183-13192 ◽  
Author(s):  
Juan Pedro Berro Ramirez ◽  
Damien Halm ◽  
Jean-Claude Grandidier ◽  
Stéphane Villalonga ◽  
Fabien Nony
Keyword(s):  
High Pressure ◽  
Hydrogen Storage ◽  
Experimental Validation ◽  
Storage Vessel ◽  
Type Iv ◽  
Hydrogen Storage Vessel ◽  
Pressure Hydrogen

PRESSURE-INDUCED STRUCTURAL EFFECTS IN SEMICONDUCTORS

1993 ◽  
Vol 07 (27) ◽  
pp. 4555-4593 ◽  
Author(s):  
J. CRAIN
Keyword(s):  
High Pressure ◽  
Computational Methods ◽  
Short Range ◽  
Short Range Order ◽  
Computational Physics ◽  
Range Order ◽  
Experimental Results ◽  
Structural Effects ◽  
Electronic Effects ◽  
Structural Polymorphism

Recent advances in the understanding of pressure-induced structural and electronic effects in semiconductors have been made possible through developments in both experimental and computational physics. It is shown that the A N B 8−N compounds which include the tetrahedrally coordinated III–V semiconductors exhibit a far richer degree of pressure-induced structural polymorphism than was originally believed. In addition, entirely new factors such as defects, short-range order and irreversibility have been identified as playing potentially important roles in the high pressure behavior of semiconductors. The experimental results are reviewed and discussed in the context of models which are amenable to investigation by modern theoretical and computational methods.

Comparison of gas excess adsorption models and high pressure experimental validation

2012 ◽  
Vol 90 (11) ◽  
pp. 2002-2012 ◽  
Author(s):  
Ch. Chilev ◽  
F. Darkrim Lamari ◽  
E. Kirilova ◽  
I. Pentchev
Keyword(s):  
High Pressure ◽  
Experimental Validation ◽  
Excess Adsorption ◽  
Adsorption Models
Sign in / Sign up

Export Citation Format

Share Document