Experimental Study of the Gasoline Engine Operated in Spark Ignition and Controlled Auto-Ignition Combustion Modes

2009 ◽  
Author(s):  
Jacek Hunicz ◽  
Pawel Kordos
Keyword(s):  
Experimental Study ◽  
Gasoline Engine ◽  
Spark Ignition ◽  
Combustion Modes ◽  
Auto Ignition

scholarly journals Investigation of transition between spark ignition and controlled auto-ignition combustion in a V6 direct-injection engine with cam profile switching

2008 ◽  
Vol 222 (10) ◽  
pp. 1911-1926 ◽  
Author(s):  
N Kalian ◽  
H Zhao ◽  
J Qiao
Keyword(s):  
Gasoline Engine ◽  
Fuel Injection ◽  
Direct Injection ◽  
Spark Ignition ◽  
High Lift ◽  
Auto Ignition ◽  
Operating Region ◽  
Low Load ◽  
Cam Profile ◽  
Direct Fuel Injection

Controlled auto-ignition (CAI) combustion, also known as homogeneous charge compression ignition (HCCI), can be achieved by trapping residuals with early exhaust valve closure in a direct-fuel-injection in-cylinder four-stroke gasoline engine (through the employment of low-lift cam profiles). Because the operating region is limited to low-load and midload operation for CAI combustion with a low-lift cam profile, it is important to be able to operate spark ignition (SI) combustion at high loads with a normal cam profile. A 3.0l prototype engine was modified to achieve CAI combustion, using a cam profile switching mechanism that has the capability to switch between high- and low-lift cam profiles. A strategy was used where a high-lift profile could be used for SI combustion and a low-lift profile was used for CAI combustion. Initial analysis showed that for a transition from SI to CAI combustion, misfire occurred in the first CAI transitional cycle. Subsequent experiments showed that the throttle opening position and switching time could be controlled to avoid misfire. Further work investigated transitions at different loads and from CAI to SI combustion.

scholarly journals Effects of Flame Propagation Velocity and Turbulence Intensity on End-Gas Auto-Ignition in a Spark Ignition Gasoline Engine

Energies ◽  
2020 ◽  
Vol 13 (19) ◽  
pp. 5039
Author(s):  
Lei Zhou ◽  
Xiaojun Zhang ◽  
Lijia Zhong ◽  
Jie Yu
Keyword(s):  
Flame Propagation ◽  
Turbulence Intensity ◽  
Propagation Velocity ◽  
Gasoline Engine ◽  
Pressure Oscillation ◽  
Spark Ignition ◽  
Flame Propagation Velocity ◽  
Eddy Simulation ◽  
Auto Ignition ◽  
Large Eddy

Knocking is a destructive and abnormal combustion phenomenon that hinders modern spark ignition (SI) engine technologies. However, the in-depth mechanism of a single-factor influence on knocking has not been well studied. Thus, the major aim of the present study is to study the effects of flame propagation velocity and turbulence intensity on end-gas auto-ignition through a large eddy simulation (LES) and a decoupling methodology in a downsized gasoline engine. The mechanisms of end-gas auto-ignition as well as strong pressure oscillation are qualitatively analyzed. It is observed that both flame propagation velocity and turbulence have a non-monotonic effect on knocking intensity. The competitive relationship between flame propagation velocity and ignition delay of the end gas is the primary reason responding to this phenomenon. A higher flame speed leads to an increase in the heat release rate in the cylinder, and consequently, quicker increases in the temperature and pressure of the unburned end-gas mixture are obtained, leading to end-gas auto-ignition. Further, the coupling of a pressure wave and an auto-ignition flame front results in super-knocking with a maximum peak of pressure of 31 MPa. Although the turbulence indirectly influences the end-gas auto-ignition by affecting the flame propagation velocity, it can accelerate the dissipation of radicals and heat in the end gas, which significantly influences knocking intensity. Moreover, it is found that the effect of turbulence is more pronounced than that of flame propagation velocity in inhibiting knocking. It can be concluded that the intensity of the pressure oscillation depends on the unburned mixture mass as well as the local thermodynamic state induced by flame propagation and turbulence, with mutual interactions. The present work is expected to provide valuable perspective for inhibiting super-knocking of an SI gasoline engine.

scholarly journals An experimental study of the performance and emissions of spark ignition gasoline engine

2016 ◽  
Vol 13 (3) ◽  
pp. 3540-3554 ◽  
Author(s):  
Adnan Kadhim Rashid ◽  
◽  
Mohd Radzi Abu Mansor ◽  
Wan Aizon Wan Ghopa ◽  
Zambri Harun ◽  
...  
Keyword(s):  
Experimental Study ◽  
Gasoline Engine ◽  
Spark Ignition ◽  
Performance And Emissions

scholarly journals Numerical Analysis of End-Gas Autoignition and Pressure Oscillation in a Downsized SI Engine Using Large Eddy Simulation

Energies ◽  
2019 ◽  
Vol 12 (20) ◽  
pp. 3909 ◽  
Author(s):  
Zhong ◽  
Liu
Keyword(s):  
Large Eddy Simulation ◽  
Gasoline Engine ◽  
Numerical Models ◽  
Pressure Oscillation ◽  
Spark Ignition ◽  
Gasoline Engines ◽  
Eddy Simulation ◽  
Auto Ignition ◽  
Large Eddy ◽  
Primary Reference

Knock and super-knock are abnormal combustion phenomena in engines, however, they are hard to study comprehensively through optical experimental methods due to their inherent destructive nature. In present work, the methodology of large eddy simulation (LES) coupled with G equations and a detailed mechanism of primary reference fuel (PRF) combustion is utilized to address the mechanisms of knock and super-knock phenomena in a downsized spark ignition gasoline engine. The knock and super-knock with pressure oscillation are qualitatively duplicated through present numerical models. As a result, the combustion and onset of autoignition is more likely to occur at top dead center (TDC), which causes end gas at a higher temperature and pressure. It is reasonable to conclude that the intensity of knock is not only proportional to the mass fraction of mixtures burned by the autoignition flame but the thermodynamics of the unburned end-gas mixture, and the effect of thermodynamics is more important. It also turns out that two auto-ignitions occur in conventional knock conditions, while only one auto-ignition takes place in super-knock conditions. However, the single autoignition couples with the pressure wave and they reinforce each other, which eventually evolves into detonation combustion. This work gives the valuable insights into knock phenomena in spark ignition gasoline engines.

scholarly journals Thermodynamic efficiency assessment of gasoline spark ignition and compression ignition operating strategies using a new multi-mode combustion model for engine system simulations

2018 ◽  
Vol 20 (3) ◽  
pp. 304-326 ◽  
Author(s):  
Elliott A Ortiz-Soto ◽  
George A Lavoie ◽  
Margaret S Wooldridge ◽  
Dennis N Assanis
Keyword(s):  
Homogeneous Charge Compression Ignition ◽  
Spark Ignition ◽  
Compression Ignition ◽  
Advanced Combustion ◽  
Combustion Modes ◽  
Auto Ignition ◽  
Operating Strategies ◽  
Compression Ignition Combustion ◽  
Multi Mode ◽  
Homogeneous Charge

Advanced combustion strategies for gasoline engines employing highly dilute and low-temperature combustion modes, such as homogeneous charge compression ignition and spark-assisted compression ignition, promise significant improvements in efficiency and emissions. This article presents a novel, reduced-order, physics-based model to capture advanced multi-mode combustion involving spark ignition, homogeneous charge compression ignition and spark-assisted compression ignition operating strategies. The purpose of such a model, which until now was unavailable, was to enhance existing capabilities of engine system simulations and facilitate large-scale parametric studies related to these advanced combustion modes. The model assumes two distinct thermodynamic zones divided by an infinitely thin flame interface, where turbulent flame propagation is captured using a new zero-dimensional formulation of the coherent flame model, and end-gas auto-ignition is simulated using a hybrid approach employing chemical kinetics and a semi-empirical burn rate model. The integrated model was calibrated using three distinct experimental data sets for spark ignition, homogeneous charge compression ignition and spark-assisted compression ignition combustion. The results demonstrated overall good trend-wise agreement with the experimental data, including the ability to replicate heat release characteristics related to flame propagation and auto-ignition during spark-assisted compression ignition combustion. The calibrated model was assessed using a large parametric study, where the predicted homogeneous charge compression ignition and spark-assisted compression ignition operating regions at naturally aspirated conditions were representative of those determined during engine testing. Practical advanced combustion strategies were assessed relative to idealized engine simulations, which showed that efficiency improvements up to 30% compared with conventional spark-ignition operation are possible. The study revealed that poor combustion efficiency and pumping work are the primary mechanisms for efficiency losses for the advanced combustion strategies evaluated.

Analysis of the potential of a new automotive two-stroke gasoline engine able to operate in spark ignition and controlled autoignition combustion modes

2017 ◽  
Vol 126 ◽  
pp. 834-847 ◽  
Author(s):  
J. Javier López ◽  
Santiago Molina ◽  
Antonio García ◽  
Jorge Valero-Marco ◽  
Frédéric Justet
Keyword(s):  
Gasoline Engine ◽  
Spark Ignition ◽  
Combustion Modes ◽  
Controlled Autoignition
Sign in / Sign up

Export Citation Format

Share Document