Development of Ice Crystal Facilities for Engine Testing

2007 ◽  
Author(s):  
J.D. MacLeod
Keyword(s):  
Ice Crystal ◽  
Engine Testing

High-pressure freezing of cells in suspension for low-voltage scanning electron microscopy (LVSEM)

1991 ◽  
Vol 49 ◽  
pp. 64-65
Author(s):  
Marek Malecki ◽  
James Pawley ◽  
Hans Ris
Keyword(s):  
Electron Microscopy ◽  
High Pressure ◽  
Low Voltage ◽  
Culture Media ◽  
Cell Structure ◽  
Freeze Substitution ◽  
Ice Crystal ◽  
High Pressure Freezing ◽  
Cell Culture Media ◽  
Voltage Scanning

The ultrastructure of cells suspended in physiological fluids or cell culture media can only be studied if the living processes are stopped while the cells remain in suspension. Attachment of living cells to carrier surfaces to facilitate further processing for electron microscopy produces a rapid reorganization of cell structure eradicating most traces of the structures present when the cells were in suspension. The structure of cells in suspension can be immobilized by either chemical fixation or, much faster, by rapid freezing (cryo-immobilization). The fixation speed is particularly important in studies of cell surface reorganization over time. High pressure freezing provides conditions where specimens up to 500μm thick can be frozen in milliseconds without ice crystal damage. This volume is sufficient for cells to remain in suspension until frozen. However, special procedures are needed to assure that the unattached cells are not lost during subsequent processing for LVSEM or HVEM using freeze-substitution or freeze drying. We recently developed such a procedure.

Cryosectioning plant roots prepared by high-pressure freezing

1987 ◽  
Vol 45 ◽  
pp. 662-663
Author(s):  
R.E. Crang ◽  
M. Mueller ◽  
K. Zierold
Keyword(s):  
High Pressure ◽  
Cell Walls ◽  
Plant Tissues ◽  
Ice Crystal ◽  
High Pressure Freezing ◽  
Vitreous State ◽  
Radial Depth ◽  
Irregular Topography ◽  
Considerable Depth ◽  
Conventional Freezing

Obtaining frozen-hydrated sections of plant tissues for electron microscopy and microanalysis has been considered difficult, if not impossible, due primarily to the considerable depth of effective freezing in the tissues which would be required. The greatest depth of vitreous freezing is generally considered to be only 15-20 μm in animal specimens. Plant cells are often much larger in diameter and, if several cells are required to be intact, ice crystal damage can be expected to be so severe as to prevent successful cryoultramicrotomy. The very nature of cell walls, intercellular air spaces, irregular topography, and large vacuoles often make it impractical to use immersion, metal-mirror, or jet freezing techniques for botanical material.However, it has been proposed that high-pressure freezing (HPF) may offer an alternative to the more conventional freezing techniques, inasmuch as non-cryoprotected specimens may be frozen in a vitreous, or near-vitreous state, to a radial depth of at least 0.5 mm.

High-pressure freezing and freeze substitution of plant tissue

1992 ◽  
Vol 50 (1) ◽  
pp. 748-749
Author(s):  
William P. Sharp ◽  
Robert W. Roberson
Keyword(s):  
High Pressure ◽  
Cell Structure ◽  
Leaf Tissue ◽  
Freeze Substitution ◽  
Crystal Formation ◽  
Ice Crystal ◽  
High Pressure Freezing ◽  
Cell Components ◽  
Cold Metal ◽  
Brome Grass

The aim of ultrastructural investigation is to analyze cell architecture and relate a functional role(s) to cell components. It is known that aqueous chemical fixation requires seconds to minutes to penetrate and stabilize cell structure which may result in structural artifacts. The use of ultralow temperatures to fix and prepare specimens, however, leads to a much improved preservation of the cell’s living state. A critical limitation of conventional cryofixation methods (i.e., propane-jet freezing, cold-metal slamming, plunge-freezing) is that only a 10 to 40 μm thick surface layer of cells can be frozen without distorting ice crystal formation. This problem can be allayed by freezing samples under about 2100 bar of hydrostatic pressure which suppresses the formation of ice nuclei and their rate of growth. Thus, 0.6 mm thick samples with a total volume of 1 mm3 can be frozen without ice crystal damage. The purpose of this study is to describe the cellular details and identify potential artifacts in root tissue of barley (Hordeum vulgari L.) and leaf tissue of brome grass (Bromus mollis L.) fixed and prepared by high-pressure freezing (HPF) and freeze substitution (FS) techniques.

The “KIMWIPE” Effect in Ultra-Thin Cryosections

1985 ◽  
Vol 43 ◽  
pp. 458-459
Author(s):  
I. Taylor ◽  
P. Ingram ◽  
J.R. Sommer
Keyword(s):  
Skeletal Muscle ◽  
Electrical Stimulation ◽  
Muscle Fibers ◽  
Ice Crystals ◽  
Crystal Formation ◽  
Ice Crystal ◽  
Thin Sections ◽  
Skeletal Muscle Fibers ◽  
Freeze Dried ◽  
Ice Crystal Formation

In studying quick-frozen single intact skeletal muscle fibers for structural and microchemical alterations that occur milliseconds, and fractions thereof, after electrical stimulation, we have developed a method to compare, directly, ice crystal formation in freeze-substituted thin sections adjacent to all, and beneath the last, freeze-dried cryosections. We have observed images in the cryosections that to our knowledge have not been published heretofore (Figs.1-4). The main features are that isolated, sometimes large regions of the sections appear hazy and have much less contrast than adjacent regions. Sometimes within the hazy regions there are smaller areas that appear crinkled and have much more contrast. We have also observed that while the hazy areas remain still, the regions of higher contrast visibly contract in the beam, often causing tears in the sections that are clearly not caused by ice crystals (Fig.3, arrows).

Effect of Al2O3 and SiO2 Metal Oxide Nanoparticles Blended with POME on Combustion, Performance and Emissions Characteristics of a Diesel Engine

2019 ◽  
Vol 16 (3) ◽  
pp. 6859-6873 ◽  
Author(s):  
M. A. Adzmi ◽  
A. Abdullah ◽  
Z. Abdullah ◽  
A. G. Mrwan
Keyword(s):  
Diesel Engine ◽  
Metal Oxide Nanoparticles ◽  
Peak Torque ◽  
Combustion Characteristic ◽  
Maximum Pressure ◽  
Single Cylinder ◽  
Engine Testing ◽  
Co Addition ◽  
Carbon Dioxide Co2 ◽  
Test Fuel

Evaluation of combustion characteristic, engine performances and exhaust emissions of nanoparticles blended in palm oil methyl ester (POME) was conducted in this experiment using a single-cylinder diesel engine. Nanoparticles used was aluminium oxide (Al2O3) and silicon dioxide (SiO2) with a portion of 50 ppm and 100 ppm. SiO2 and Al2O3 were blended in POME and labelled as PS50, PS100 and PA50, PA100, respectively. The data results for PS and PA fuel were compared to POME test fuel. Single cylinder diesel engine YANMAR TF120M attached with DEWESoft data acquisition module (DAQ) model SIRIUSi-HS was used in this experiment. Various engine loads of zero, 7 N.m, 14 Nm, 21 N.m and 28 N.m at a constant engine speed of 1800 rpm were applied during engine testing. Results for each fuel were obtained by calculating the average three times repetition of engine testing. Findings show that the highest maximum pressure of nanoparticles fuel increase by 16.3% compared to POME test fuel. Other than that, the engine peak torque and engine power show a significant increase by 43% and 44%, respectively, recorded during the PS50 fuel test. Meanwhile, emissions of nanoparticles fuel show a large decrease by 10% of oxide of nitrogen (NOx), 6.3% reduction of carbon dioxide (CO2) and a slight decrease of 0.02% on carbon monoxide (CO). Addition of nanoparticles in biodiesel show positive improvements when used in diesel engines and further details were discussed.  

scholarly journals Microstructural Characteristics of Frazil Particles and the Physical Properties of Frazil Ice in the Yellow River, China

Crystals ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 617
Author(s):  
Yaodan Zhang ◽  
Zhijun Li ◽  
Yuanren Xiu ◽  
Chunjiang Li ◽  
Baosen Zhang ◽  
...  
Keyword(s):  
Physical Properties ◽  
Yellow River ◽  
The Yellow River ◽  
Ice Crystal ◽  
Microstructural Characteristics ◽  
Air Bubble ◽  
Frazil Ice ◽  
Sediment Content ◽  
Crystal Diameter

Frazil particles, ice crystals or slushy granules that form in turbulent water, change the freezing properties of ice to create “frazil ice”. To understand the microstructural characteristics of these particles and the physical properties of frazil ice in greater depth, an in situ sampler was designed to collect frazil particles in the Yellow River. The ice crystal microstructural characteristics of the frazil particles (morphology, size, air bubble, and sediment) were observed under a microscope, and their nucleation mechanism was analyzed according to its microstructure. The physical properties of frazil ice (ice crystal microstructure, air bubble, ice density, and sediment content) were also observed. The results showed that these microstructures of frazil particles can be divided into four types: granular, dendritic, needle-like, and serrated. The size of the measured frazil particles ranged from 0.1 to 25 mm. Compared with columnar ice, the crystal microstructure of frazil ice is irregular, with a mean crystal diameter less than 5 mm extending in all directions. The crystal grain size and ice density of frazil ice are smaller than columnar ice, but the bubble and sediment content are larger.

A thermodynamic model for ice crystal accretion in aircraft engines: EMM-C

2021 ◽  
Vol 174 ◽  
pp. 121270
Author(s):  
Alexander Bucknell ◽  
Matthew McGilvray ◽  
David R.H. Gillespie ◽  
Geoffrey Jones ◽  
Benjamin Collier
Keyword(s):  
Thermodynamic Model ◽  
Aircraft Engines ◽  
Ice Crystal
Sign in / Sign up

Export Citation Format

Share Document