Porous Media Based Phase Separation in Condensing Heat Exchanger for Space Systems

2006 ◽  
Author(s):  
Lutful I. Khan ◽  
Mohammad M. Hasan
Keyword(s):  
Porous Media ◽  
Phase Separation ◽  
Heat Exchanger ◽  
Space Systems ◽  
Condensing Heat Exchanger

Performance of a Condensing Heat Exchanger System at Lake City Army Ammunition Plant, Independence, Missouri

1992 ◽  
Author(s):  
Matthew E. Snyder ◽  
Michael P. Case ◽  
Sharon Jones ◽  
Richard Caron
Keyword(s):  
Heat Exchanger ◽  
Condensing Heat Exchanger ◽  
Lake City

Condensing Heat Exchanger Microbial Growth and Control Study-Phase II

1993 ◽  
Author(s):  
Robert W. Marsh ◽  
Mark E. Caron ◽  
Carol Metselaar ◽  
John Steele
Keyword(s):  
Heat Exchanger ◽  
Phase Ii ◽  
Microbial Growth ◽  
Study Phase ◽  
Condensing Heat Exchanger ◽  
And Control ◽  
Control Study

scholarly journals Energy Recovery from an Industrial Clothes Dryer Using a Condensing Heat Exchanger

2021 ◽  
Author(s):  
Yousuf Farooq
Keyword(s):  
Heat Transfer ◽  
Mass Transfer ◽  
Heat Exchanger ◽  
Heat Recovery ◽  
Cold Water ◽  
Waste Heat ◽  
Interface Temperature ◽  
Sensible Heat ◽  
Clothes Dryer ◽  
Condensing Heat Exchanger

The aim of this project was to design a condensing heat exchanger to recover waste heat from an industrial clothes dryer. Industrial cloth dryers are inefficient in their use of energy because almost all of the energy input in the dryer is wasted in the atmosphere, and thus there is great potential for heat recovery. This energy can be used to preheat the incoming cold water, and the conventional heater can then heat the water to a final temperature. The warm moist air from the dryer carries both sensible and latent heat, and in order to design this heat recovery condensing heat exchanger, the heat transfer by both mass and sensible heat has to be accounted for. The basis of this heat and mass transfer problem was the energy balance at the interface, and separate models for the calculation of latent and sensible heat transfer were used. The mass transfer coefficients were obtained from an analogy with heat transfer, and the unknown interface temperature was solved for iteratively. The data for this design was collected from a 20 kW dryer, and the heat recovery from that dryer was observed to be about 17.3%. This heat recovery condensing heat exchanger efficiency can be enhanced by the addition of more coils to the heat exchanger. An improvement in the overall results can be expected if a practical study is done on the condensation heat exchanger for an industrial cloth dryer.

Sign in / Sign up

Export Citation Format

Share Document