scholarly journals Potential Correlation between Spontaneous Emulsification and the Plait Point in the System Water/Benzene/Ethanol: A Phase Diagram Approach

Soft ◽  
2013 ◽  
Vol 02 (01) ◽  
pp. 1-6 ◽  
Author(s):  
Stig E. Friberg
Keyword(s):  
Phase Diagram ◽  
Spontaneous Emulsification ◽  
Plait Point ◽  
Diagram Approach ◽  
System Water

Calculation of physical properties of glass via the phase diagram approach

2017 ◽  
Vol 457 ◽  
pp. 36-43 ◽  
Author(s):  
Q.Y. Zhang ◽  
W.J. Zhang ◽  
W.C. Wang ◽  
Z.H. Jiang
Keyword(s):  
Phase Diagram ◽  
Physical Properties ◽  
Diagram Approach

scholarly journals Thermodynamic reassessment of the Mn-Ni-Si system

2015 ◽  
Vol 51 (2) ◽  
pp. 125-132 ◽  
Author(s):  
B. Hu ◽  
Y. Du ◽  
J.J. Yuan ◽  
Z.F. Liu ◽  
Q.P. Wang
Keyword(s):  
Experimental Data ◽  
Phase Diagram ◽  
Phase Diagrams ◽  
Thermodynamic Parameters ◽  
Ternary Phase ◽  
Sublattice Model ◽  
Diagram Approach ◽  
Measured Phase

Iased on the new experimental data available in the literature, the Mn-Ni-Si system has been reassessed using the CALPHAD (CALculation of PHAse Diagram) approach. Compared with the previous modeling, the ?8 and ?12 ternary phases were treated as the same phase according to the new experimental data. The Mn3Si phase was described with two sublattice model (Mn, Ni)3(Si)1. The reported new ternary phase ? was not considered in the present work. Comprehensive comparisons between the calculated and measured phase diagrams showed that a set of thermodynamic parameters of the Mn-Ni-Si system obtained in this work was more accurate than the previous one.

A phase diagram approach to study liquation cracking in alloy 718

1991 ◽  
Vol 22 (4) ◽  
pp. 887-902 ◽  
Author(s):  
B. Radhakrishnan ◽  
R. G. Thompson
Keyword(s):  
Phase Diagram ◽  
Alloy 718 ◽  
Liquation Cracking ◽  
Diagram Approach

Quantitative Prediction of Structure and Luminescent Properties of (Mg1-x-yBaxSry)1.95SiO4∶0.05Eu via Phase Diagram Approach

2019 ◽  
Vol 40 (12) ◽  
pp. 1494-1504
Author(s):  
汪 雨 WANG Yu ◽  
罗 岚 LUO Lan ◽  
郭 锐 GUO Rui ◽  
孙传耀 SUN Chuan-yao ◽  
高明远 GAO Ming-yuan
Keyword(s):  
Phase Diagram ◽  
Luminescent Properties ◽  
Quantitative Prediction ◽  
Diagram Approach

Phase diagram of the system water-glycerol-triton TX 100

1994 ◽  
Vol 98 (4) ◽  
pp. 603-609 ◽  
Author(s):  
Giuseppe A. Ranieri ◽  
Luigi Coppola ◽  
Mario Terenzi ◽  
Camillo La Mesa
Keyword(s):  
Phase Diagram ◽  
Water Glycerol ◽  
System Water

Weldability Approach to Duplex Stainless Steels Using Multicomponent Phase Diagrams

2005 ◽  
Vol 475-479 ◽  
pp. 2765-2768 ◽  
Author(s):  
Antonio J. Ramirez ◽  
Sérgio Duarte Brandi
Keyword(s):  
Phase Diagram ◽  
Phase Transformations ◽  
Phase Diagrams ◽  
Stainless Steels ◽  
Equilibrium Phase ◽  
Duplex Stainless Steels ◽  
Pseudobinary Phase Diagram ◽  
Equilibrium Process ◽  
Diagram Approach ◽  
Joint Microstructures

Welding is a non-equilibrium process. However, some weldability issues, as the extension of the heat-affected zone (HAZ) can be addressed using equilibrium phase diagrams. The 70 wt% Fe-Cr-Ni pseudo-binary phase diagram is commonly used to establish the phase transformations during welding of duplex stainless steels. The predicted results are assumed to be reasonably good for most of the duplex stainless steels. Thermodynamic calculations were used to determine multicomponent phase diagrams and volumetric fraction of phases present as a function of temperature several commercial duplex stainless steels. Results showed that simplified pseudobinary phase diagram approach is valid to estimate welded joint microstructures only for the low alloy duplex stainless steels as UNS S32304, but phase transformations and mainly solidification paths of high alloy duplex stainless steels should predicted only using a multi-component phase diagram.

scholarly journals The self assembly of proteins; probing patchy protein interactions

2015 ◽  
Vol 17 (7) ◽  
pp. 5413-5420 ◽  
Author(s):  
Susan James ◽  
Michelle K. Quinn ◽  
Jennifer J. McManus
Keyword(s):  
Phase Diagram ◽  
Thermodynamic Properties ◽  
Protein Interactions ◽  
Self Assembly ◽  
The Self ◽  
Protein Surface ◽  
Competing Interactions ◽  
Diagram Approach

Anisotropy is central to protein self-assembly. The kinetic and thermodynamic properties of proteins in which competing interactions exist due to the anisotropic or patchy nature of the protein surface have been explored using a phase diagram approach.

Sign in / Sign up

Export Citation Format

Share Document