scholarly journals Ecological Zonation of Phytoplankton and Biomass Based on Bio-Optical Parameters off Baja California during Three Summer Seasons

2019 ◽  
Vol 09 (03) ◽  
pp. 121-136
Author(s):  
Sánchez-Pérez Elvia Denisse ◽  
Millán-Núñez Eduardo
Keyword(s):  
Baja California ◽  
Optical Parameters ◽  
Ecological Zonation

Correlation analysis of radiation damage

1978 ◽  
Vol 36 (1) ◽  
pp. 214-215
Author(s):  
R. Hegerl ◽  
A. Feltynowski ◽  
B. Grill
Keyword(s):  
Electron Microscopy ◽  
Independent Random Variables ◽  
Optical Parameters ◽  
Bright Field Image ◽  
Bright Field ◽  
Expectation Value ◽  
All Optical ◽  
Image Element ◽  
Stochastic Series ◽  
The Common

Till now correlation functions have been used in electron microscopy for two purposes: a) to find the common origin of two micrographs representing the same object, b) to check the optical parameters e. g. the focus. There is a third possibility of application, if all optical parameters are constant during a series of exposures. In this case all differences between the micrographs can only be caused by different noise distributions and by modifications of the object induced by radiation.Because of the electron noise, a discrete bright field image can be considered as a stochastic series Pm,where i denotes the number of the image and m (m = 1,.., M) the image element. Assuming a stable object, the expectation value of Pm would be Ηm for all images. The electron noise can be introduced by addition of stationary, mutual independent random variables nm with zero expectation and the variance. It is possible to treat the modifications of the object as a noise, too.

Experimental study on the restoration from a tilt-azimuth series for improvement in resolution

1995 ◽  
Vol 53 ◽  
pp. 636-637
Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe
Keyword(s):  
Experimental Study ◽  
Spherical Aberration ◽  
Incident Beam ◽  
Optical Parameters ◽  
Beam Tilting ◽  
Illumination Method ◽  
Restoration Method ◽  
Illumination Mode

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.

Computer-Assisted High-Re Solution TEM

1990 ◽  
Vol 48 (1) ◽  
pp. 162-163
Author(s):  
F.A. Ponce ◽  
H. Hikashi
Keyword(s):  
Signal To Noise Ratio ◽  
Accurate Determination ◽  
Computer Software ◽  
Video Camera ◽  
Image Contrast ◽  
Objective Lens ◽  
Computer Assisted ◽  
Optical Parameters ◽  
Astigmatism Correction

The determination of the atomic positions from HRTEM micrographs is only possible if the optical parameters are known to a certain accuracy, and reliable through-focus series are available to match the experimental images with calculated images of possible atomic models. The main limitation in interpreting images at the atomic level is the knowledge of the optical parameters such as beam alignment, astigmatism correction and defocus value. Under ordinary conditions, the uncertainty in these values is sufficiently large to prevent the accurate determination of the atomic positions. Therefore, in order to achieve the resolution power of the microscope (under 0.2nm) it is necessary to take extraordinary measures. The use of on line computers has been proposed [e.g.: 2-5] and used with certain amount of success.We have built a system that can perform operations in the range of one frame stored and analyzed per second. A schematic diagram of the system is shown in figure 1. A JEOL 4000EX microscope equipped with an external computer interface is directly linked to a SUN-3 computer. All electrical parameters in the microscope can be changed via this interface by the use of a set of commands. The image is received from a video camera. A commercial image processor improves the signal-to-noise ratio by recursively averaging with a time constant, usually set at 0.25 sec. The computer software is based on a multi-window system and is entirely mouse-driven. All operations can be performed by clicking the mouse on the appropiate windows and buttons. This capability leads to extreme friendliness, ease of operation, and high operator speeds. Image analysis can be done in various ways. Here, we have measured the image contrast and used it to optimize certain parameters. The system is designed to have instant access to: (a) x- and y- alignment coils, (b) x- and y- astigmatism correction coils, and (c) objective lens current. The algorithm is shown in figure 2. Figure 3 shows an example taken from a thin CdTe crystal. The image contrast is displayed for changing objective lens current (defocus value). The display is calibrated in angstroms. Images are stored on the disk and are accessible by clicking the data points in the graph. Some of the frame-store images are displayed in Fig. 4.

Health and Health Care Problems Among the Kumiai of San Antonio Necua and Their Indigenous Relatives in Baja California

2003 ◽  
Vol 1 (1) ◽  
pp. 140-157 ◽  
Author(s):  
K. Jill Fleuriet
Keyword(s):  
Health Care ◽  
Baja California ◽  
San Antonio ◽  
Rural Poverty ◽  
Indigenous Communities ◽  
Traditional Healers ◽  
Medical Pluralism ◽  
Indigenous Groups ◽  
Health And Illness ◽  
Care Problems

The rural Kumiai community of San Antonio Necua is one of the few remaining indigenous communities in Baja California, Mexico. Necuan health and health care problems are best understood through a consideration of the effects of colonialism and marginalization on indigenous groups in northern Baja California as well as a tradition of medical pluralism in Mexico. The lack of traditional healers and biomedical providers in the community, high rates of preventable or manageable illnesses, and a blend of biomedical, folk mestizo, and traditional indigenous beliefs about health and illness reflect current conditions of rural poverty and economic isolation. Descriptions of health and health care problems are based on ethnographic fieldwork among the Kumiai, their Paipai relatives, and their primary nongovernmental aid organization.

Sign in / Sign up

Export Citation Format

Share Document