scholarly journals Observations on the origin of corrosion-fatigue cracks in a 34-inch diameter crude-oil pipeline

1974 ◽  
Author(s):  
R J Cooke
Keyword(s):  
Crude Oil ◽  
Corrosion Fatigue ◽  
Fatigue Cracks ◽  
Oil Pipeline

Crude Oil Corrosion Fatigue of L485MB Pipeline Steel

2015 ◽  
Vol 137 (5) ◽  
Author(s):  
Ľ. Gajdoš ◽  
M. Šperl ◽  
J. Bystrianský
Keyword(s):  
Crude Oil ◽  
Strain Rate ◽  
Corrosion Fatigue ◽  
Pipeline Steel ◽  
Fatigue Tests ◽  
Fatigue Properties ◽  
Oil Pipeline ◽  
Oil Processing ◽  
Tension Loading ◽  
Aggressive Effect

An investigation was made into the fatigue properties of L485MB (X70) pipeline steel after 13 yr of exploitation as a crude oil pipeline material. Fatigue tests in zero-to-tension loading were carried out (i) in air, (ii) in crude oil, (iii) in a mixture of crude oil with rainwater, and (iv) in water separated from the crude oil phase. The aim of the investigation was to assess the degree of degradation of the fatigue properties of this steel due to the action of environments typical for crude oil processing and transport. The results are not directly comparable to any corrosion fatigue experienced by the crude oil pipeline, since the strain rate for the tests was higher by an order of five than the strain rate observed in typical loading cycles. The results showed that crude oil and a mixture of crude oil with rainwater had no aggressive effect on the steel in the sense of reducing its fatigue characteristics, while the separated water had an aggressive effect.

scholarly journals Geophysical investigations for stability and safety mitigation of regional crude-oil pipeline near abandoned coal mines

2021 ◽  
Vol 18 (1) ◽  
pp. 145-162
Author(s):  
B Butchibabu ◽  
Prosanta Kumar Khan ◽  
P C Jha
Keyword(s):  
High Resolution ◽  
Crude Oil ◽  
Seismic Refraction ◽  
High Resolution Imaging ◽  
Weak Zone ◽  
Near Surface ◽  
Oil Pipeline ◽  
Refraction Tomography ◽  
Geophysical Investigations ◽  
Resolution Imaging

Abstract This study aims for the protection of a crude-oil pipeline, buried at a shallow depth, against a probable environmental hazard and pilferage. Both surface and borehole geophysical techniques such as electrical resistivity tomography (ERT), ground penetrating radar (GPR), surface seismic refraction tomography (SRT), cross-hole seismic tomography (CST) and cross-hole seismic profiling (CSP) were used to map the vulnerable zones. Data were acquired using ERT, GPR and SRT along the pipeline for a length of 750 m, and across the pipeline for a length of 4096 m (over 16 profiles of ERT and SRT with a separation of 50 m) for high-resolution imaging of the near-surface features. Borehole techniques, based on six CSP and three CST, were carried out at potentially vulnerable locations up to a depth of 30 m to complement the surface mapping with high-resolution imaging of deeper features. The ERT results revealed the presence of voids or cavities below the pipeline. A major weak zone was identified at the central part of the study area extending significantly deep into the subsurface. CSP and CST results also confirmed the presence of weak zones below the pipeline. The integrated geophysical investigations helped to detect the old workings and a deformation zone in the overburden. These features near the pipeline produced instability leading to deformation in the overburden, and led to subsidence in close vicinity of the concerned area. The area for imminent subsidence, proposed based on the results of the present comprehensive geophysical investigations, was found critical for the pipeline.

scholarly journals Data Analysis and Discussion on the Reliability of the Control Principle of a Sealed Crude Oil Pipeline

2021 ◽  
Vol 1927 (1) ◽  
pp. 012021
Author(s):  
Junjiang Liu ◽  
Liang Feng ◽  
Dake Yang ◽  
Xianghui Li
Keyword(s):  
Data Analysis ◽  
Crude Oil ◽  
Oil Pipeline ◽  
Control Principle

Experimental study on the wax removal physics of foam pig in crude oil pipeline pigging

2021 ◽  
Vol 205 ◽  
pp. 108881
Author(s):  
Xuedong Gao ◽  
Qiyu Huang ◽  
Xun Zhang ◽  
Yu Zhang ◽  
Xiangrui Zhu ◽  
...  
Keyword(s):  
Experimental Study ◽  
Crude Oil ◽  
Oil Pipeline ◽  
Wax Removal

Simulation of Liquid-Gas Replacement in Commissioning Process for Large-Slope Crude Oil Pipeline

2012 ◽  
Author(s):  
Yuanyuan Chen ◽  
Jing Gong ◽  
Xiaoping Li ◽  
Nan Zhang ◽  
Shaojun He ◽  
...  
Keyword(s):  
Crude Oil ◽  
Flow Rate ◽  
Liquid Flow ◽  
Liquid Flow Rate ◽  
Fluid Model ◽  
Engineering Application ◽  
Computational Procedure ◽  
Control Measures ◽  
Production Operation ◽  
Oil Pipeline

Pipeline commissioning, which is a key link from engineering construction to production operation, is aim to fill an empty pipe by injecting water or oil to push air out of it. For a large-slope crude oil pipeline with great elevation differences, air is fairly easy to entrap at downward inclined parts. The entrapped air, which is also called air pocket, will cause considerable damage on pumps and pipes. The presence of it may also bring difficulties in tracking the location of the liquid head or the interface between oil and water. It is the accumulated air that needed to be exhausted in time during commissioning. This paper focuses on the simulation of liquid-gas replacement in commissioning process that only liquid flow rate exists while gas stays stagnant in the pipe and is demanded to be replaced by liquid. Few previous researches have been found yet in this area. Consequently, the flow in a V-section pipeline consisted of a downhill segment and a subsequent uphill one is used here for studying both the formation and exhaustion behaviors of the intake air. The existing two-fluid model and simplified non-pressure wave model for gas-liquid stratified flow are applied to performance the gas formation and accumulation. The exhausting process is deemed to be a period in which the elongated bubble (Taylor bubble) is fragmented into dispersed small bubbles. A mathematical model to account for gas entrainment into liquid slug is proposed, implemented and incorporated in a computational procedure. By taking into account the comprehensive effects of liquid flow rate, fluid properties, surface tension, and inclination angle, the characteristics of the air section such as the length, pressure and mass can be calculated accurately. The model was found to show satisfactory predictions when tested in a pipeline. The simulation studies can provide theoretical support and guidance for field engineering application, which are meanwhile capable of helping detect changes in parameters of gas section. Thus corresponding control measures can be adopted timely and appropriately in commissioning process.

Permafrost Hazard of MoHe-DaQing Crude Oil Pipeline

2013 ◽  
Vol 734-737 ◽  
pp. 2659-2663
Author(s):  
Yun Bin Ma ◽  
Dong Jie Tan ◽  
Hong Yuan Jing ◽  
Quan Xue ◽  
Cheng Zhi Zhang
Keyword(s):  
Crude Oil ◽  
The Other ◽  
Frost Heave ◽  
Permafrost Soil ◽  
Buried Pipeline ◽  
Soil Frost ◽  
Plastic Deformations ◽  
Oil Pipeline ◽  
Thaw Settlement ◽  
Slope Instabilities

The crude oil pipeline from MoHe to DaQing (hereafter called Mo-Da pipeline) is part of China-Russia oil pipeline. Mo-Da pipeline is the first pipeline that through high latitude cold regions of China. The pipeline is in so complicated geography environment that many kinds of permafrost hazard are easily to happen including frost heave, thaw settlement, slope instabilities, and collapse and so on. The pipeline and the permafrost act and react upon one another. On one hand, soil frost heave and thaw settlement can produce extra stresses on pipe walls, which may result in centralized stresses and plastic deformations under certain conditions, even causes pipeline faults. On the other hand, buried pipeline will disturb ambient environment and then degrade the permafrost soil and finally impact safety of the pipeline. This paper mainly introduces the permafrost hazards of Mo-Da pipeline and demonstrates some methods for monitoring the influence of permafrost.

Sign in / Sign up

Export Citation Format

Share Document