Magnetoresistance due to the Plane Current Effect through the Gap Layer Between the High-Tc Superconductor Film and the Giant Magnetoresistance-Spin Valve Multilayer

2018 ◽  
Vol 68 (9) ◽  
pp. 950-956
Author(s):  
Woo-Il YANG ◽  
Jong-Gu CHOI ◽  
Sang-Suk LEE*
Keyword(s):  
Giant Magnetoresistance ◽  
Spin Valve ◽  
Current Effect ◽  
High Tc ◽  
High Tc Superconductor ◽  
Superconductor Film

Current Transfer Effect by the Gap Layer between High-Tc Superconductor and Giant Magnetoresistance-Spin Valve

2018 ◽  
Vol 28 (5) ◽  
pp. 180-187
Author(s):  
Woo-Il Yang ◽  
Byeong-Uk Kang ◽  
Jong-Gu Choi ◽  
Purevdorj Khajidmaa ◽  
Sang-Suk Lee
Keyword(s):  
Giant Magnetoresistance ◽  
Spin Valve ◽  
Transfer Effect ◽  
Current Transfer ◽  
High Tc ◽  
High Tc Superconductor

scholarly journals Microwave transmittance of a high-Tc superconductor film in a magnetic field

1999 ◽  
Vol 25 (5) ◽  
pp. 384-385
Author(s):  
V. V. Eremenko ◽  
V. A. Novosad ◽  
V. V. Pishko ◽  
C. Falco ◽  
V. M. Rashkovan
Keyword(s):  
Magnetic Field ◽  
High Tc ◽  
High Tc Superconductor ◽  
Superconductor Film

High resolution STEM imaging study on high Tc superconductor YBa2CuaO7-x

1988 ◽  
Vol 46 ◽  
pp. 882-883
Author(s):  
H.-J. Ou ◽  
J. M. Cowley
Keyword(s):  
Crystal Structure ◽  
High Resolution ◽  
Grain Boundary ◽  
Strong Field ◽  
Imaging Study ◽  
Structure Defects ◽  
High Tc ◽  
High Tc Superconductor ◽  
Diffraction Patterns ◽  
Lattice Planes

Using the dedicate VG-HB5 STEM microscope, the crystal structure of high Tc superconductor of YBa2Cu3O7-x has been studied via high resolution STEM (HRSTEM) imaging and nanobeam (∽3A) diffraction patterns. Figure 1(a) and 2(a) illustrate the HRSTEM image taken at 10' times magnification along [001] direction and [100] direction, respectively. In figure 1(a), a grain boundary with strong field contrast is seen between two crystal regions A and B. The grain boundary appears to be parallel to a (110) plane, although it is not possible to determine [100] and [001] axes as it is in other regions which contain twin planes [3]. Following the horizontal lattice lines, from left to right across the grain boundary, a lattice bending of ∽4° is noticed. Three extra lattice planes, indicated by arrows, were found to terminate at the grain boundary and form dislocations. It is believed that due to different chemical composition, such structure defects occur during crystal growth. No bending is observed along the vertical lattice lines.

Electron-Probe Quantitative Energy-Dispersive Analysis of Trace Magnesium Concentrations in Ag-Mg Alloys

1996 ◽  
Vol 54 ◽  
pp. 510-511
Author(s):  
R. B. Marinenko
Keyword(s):  
Electron Probe ◽  
Energy Dispersive Spectrometry ◽  
Mg Alloys ◽  
Energy Dispersive ◽  
Energy Dispersive Analysis ◽  
High Tc ◽  
Alloy Wire ◽  
High Tc Superconductor ◽  
Eds Analysis ◽  
Superior Mechanical Properties

Internally oxidized Ag-Mg alloys are used as sheaths for high Tc superconductor wires because of their superior mechanical properties. The preparation and characteristics of these materials have been reported. Performance of the sheaths depends on the concentration of the magnesium which generally is less than 0.5 wt. percent. The purpose of this work was to determine whether electron probe microanalysis using energy dispersive spectrometry (EDS) could be used to quantitate three different Ag-Mg alloys. Quantitative EDS analysis can be difficult because the AgL escape peak occurs at the same energy (1.25 keV) as the Mg Kα peak. An EDS spectrum of a Ag-Mg alloy wire is compared to a pure Ag spectrum in Fig. 1.

Evidence for magnetic organization of high Tc superconductor YBa 2 Cu8O7 observed by neutron diffraction

1987 ◽  
Vol 48 (10) ◽  
pp. 1623-1625 ◽  
Author(s):  
B. Farnoux ◽  
R. Kahn ◽  
A. Brulet ◽  
G. Collin ◽  
J.P. Pouget
Keyword(s):  
Neutron Diffraction ◽  
High Tc ◽  
High Tc Superconductor
Sign in / Sign up

Export Citation Format

Share Document