scholarly journals Construction of Ground Subtracks for Aircraft Noise Calculations Using an Estimate of Lateral Flight Dispersion

2019 ◽  
Vol 105 (5) ◽  
pp. 779-783
Author(s):  
Olivier Schwab

In the absence of position data such as radar data, aircraft noise calculations usually rely on the definition of flight geometries in terms of flight track and flight profile data. Typically, the ground track is constructed as a backbone track with a number of subtracks accounting for the lateral flight dispersion. Depending on the nature of the tracks, for instance when considering diverging tracks compared to very narrow tracks, the number of subtracks needs to be such that smooth noise contours and footprints are computed, putting a requirement on the minimum number of subtracks needed. In practice however, as the tracks need to be digitized by expert hand, the number of available subtracks is often limited. Furthermore, the location of the subtracks is often unknown, requiring corridor boundaries to be estimated and to be translated into subtrack locations.<br/> This paper presents a method for the construction of the required number of subtracks based on an estimate of lateral flight dispersion. Two cases are envisioned: the first being an estimate of the lateral flight dispersion using a set of three pre-existing subtracks (one backbone track and left/right subtracks), the second being an estimate using a backbone track and corridor boundaries. The method uses geometric matching of the original tracks, followed by an estimation of the local lateral track dispersion. The lateral distribution function is then used for the construction of new subtracks. A series of aircraft noise calculations using diff erent numbers of subtracks are shown, showcasing the influence of the number of subtracks on the noise contours, depending on the nature of the tracks (e.g.situations with tight turns).

Noise Mapping ◽  
2020 ◽  
Vol 7 (1) ◽  
pp. 146-153
Author(s):  
Olivier Schwab

AbstractFor aircraft noise calculations, lateral flight dispersion is commonly represented by means of subtracks – a backbone track and side-tracks to each side of the backbone track – where each subtrack is assigned a movement percentage. Aircraft noise calculations impose quality demands on these subtracks, while the latter are often created based on limited information.This paper presents a method to increase flexibility when designing subtracks. The method allows to redistribute subtracks geometrically, allowing for the design of simplified track representations, for instance through a lower number of subtracks and very basic indications of movement allocations. The method is based on the geometric matching of the initial subtracks and on the estimation of the lateral movement distributions for both input and final output subtracks. No restrictions on the number of sub-tracks or on the shape of the distributions are needed, neither for the input nor for the output. A number of examples of the redistribution and its effect on aircraft noise calculations are discussed.


2005 ◽  
Vol 20 (29) ◽  
pp. 6878-6880 ◽  
Author(s):  
V. P. EGOROVA ◽  
A. V. GLUSHKOV ◽  
A. A. IVANOV ◽  
S. P. KNURENKO ◽  
V. A. KOLOSOV ◽  
...  

The energy spectrum of primary cosmic rays with ultra-high energies based on the Yakutsk EAS Array data is presented. For the largest events values of S600 and axis coordinates have been obtained using revised lateral distribution function. The effect of the arrival time distribution at several axis distance on estimated density for Yakutsk and AGASA is considered.


2019 ◽  
Vol 30 (10) ◽  
pp. 1941007 ◽  
Author(s):  
M. Reza Parsa ◽  
Aleksandra Pachalieva ◽  
Alexander J. Wagner

The molecular-dynamics-lattice-gas (MDLG) method establishes a direct link between a lattice-gas method and the coarse-graining of a molecular dynamics (MD) approach. Due to its connection to MD, the MDLG rigorously recovers the hydrodynamics and allows to validate the behavior of the lattice-gas or lattice-Boltzmann methods directly without using the standard kinetic theory approach. In this paper, we show that the analytical definition of the equilibrium distribution function remains valid even for very high volume fractions.


2011 ◽  
Vol 75 (3) ◽  
pp. 357-359 ◽  
Author(s):  
D. D. Dzhappuev ◽  
N. F. Klimenko ◽  
A. U. Kudzhaev ◽  
A. S. Lidvansky ◽  
V. B. Petkov ◽  
...  

1968 ◽  
Vol 46 (10) ◽  
pp. S197-S200 ◽  
Author(s):  
S. N. Vernov ◽  
G. B. Khristiansen ◽  
A. T. Abrosimov ◽  
V. B. Atrashkevitch ◽  
I. F. Beljaeva ◽  
...  

Experimental EAS spectra of sizes and muon numbers and results on the fluctuations of the electron–photon and muon EAS components at sea level are presented. In constructing size spectra the sizes of showers were determined by use of the individual lateral distribution function. Experimental data were obtained with considerably better statistics than in our previous works.


2020 ◽  
Author(s):  
Fabrizio Piana ◽  
Chiara Avataneo ◽  
Luca Barale ◽  
Serena Botta ◽  
Roberto Compagnoni ◽  
...  

&lt;p&gt;For a reliable evaluation of the geo-environmental risk related to the presence of naturally occurring asbestos (NOA) in rocks excavated for large infrastructural projects, a proper procedure has to be followed in order to achieve:&lt;/p&gt;&lt;p&gt;1) the definition of a detailed geological model, tailored on NOA-related issues;&lt;/p&gt;&lt;p&gt;2) a representative sampling;&lt;/p&gt;&lt;p&gt;3) a reliable quantitative determination of asbestos content in rock samples.&lt;/p&gt;&lt;p&gt;Here we describe the approach followed for the evaluation of the NOA content for the excavation of a complex highway tunnel system (&amp;#8220;Gronda di Genova&amp;#8221; NW Italy), in NOA-bearing meta-ophiolite rocks. The NOA-oriented geological model has been constrained by the individuation of the main &amp;#8220;NOA-related petrofacies&amp;#8221; &amp;#8212;i.e., classes of rocks with common lithological, structural and NOA content features&amp;#8212;, and by the identification of &amp;#8220;homogeneous zones&amp;#8221; &amp;#8211; i.e. geological units into which the NOA petrofacies are distributed. Implementation of Gy&amp;#8217;s theory on sampling was used and here described to maintain statistical validity during sample processing from the primary rock sample to the analytical sample. SEM-EDS procedure for the quantitative determination of NOA content was improved with an error analysis delivering the minimum number of fibers to be measured to achieve the best analytical results.&lt;/p&gt;&lt;p&gt;The obtained results allowed the prediction of the NOA hazard in terms of risk zonation along the tunnel section and for the evaluation of the amount of asbestos-bearing spoil to be excavated and managed.&lt;/p&gt;


Blood ◽  
2012 ◽  
Vol 120 (21) ◽  
pp. 4415-4415
Author(s):  
Massimiliano Postorino ◽  
Alessandro Lanti ◽  
Eleonora Fiorelli ◽  
Angelo Salvatore Ferraro ◽  
Oana Marilena Chiru ◽  
...  

Abstract Abstract 4415 BACKGROUND. Autologous stem cell transplantation (ASCT) of PBSCs has become a widely applied treatment for Multiple Mieloma (MM), non- Hodgking's lymphoma (NHL) and Hodgking's lymphoma (HL). Successful engraftment correlates with the number of CD34 hemopoietic progenitors cells infused. However, a part of MM or lymphoma patients (5% to 40%) fail to mobilize adequate numbers of PBSCs and thus cannot undergo to ASCT. The success of PBSCs mobilization is usually assessed by the total number of CD34+ stem cells collected, with a cutoff of 2.0–2.5 ×106 CD34+ cells/kg recipient body weight being considered as a minimum requirement for transplant. Poor mobilization of PBSCs is a major limitation to ASCT. Recently GITMO Working Group worked to define operational criteria for the identification/prediction of the poor mobilizer (PM) patients (Olivieri et al. 2011). Plerixafor, a CXCR4 chemochine antagonist, has been showed to improve significantly PBSC mobilization in PM patients. We present our experience using Plerixafor in PM patients classified according to GITMO criteria. METHODS. Between September 2009 and June 2012, a total of 17 patients (9F-8M) were enrolled. The diagnosis were: 10 MM (5F-5M), 1HL (1M), 6 NHL (4F-2M). The median age was 57 (range 15–66). 7 patients (3MM, 4NHL) were defined “Proven PM” and 10 patients (7MM, 2NHL, 1HL) “Predicted PM” according to GITMO criteria. The mobilization protocol included G-CSF, administered at a dose of 10μg/kg daily on 4 consecutive days. In the evening of the fourth day, patients received subcutaneous plerixafor at a dose of 0,24 mg/kg. Apheresis was initiated on the fifth day, 10–12 h after plerixafor and 1 h after G-CSF administration. Apheresis and daily administration of G-CSF and plerixafor continued until the patient collected enough CD34+ cells for auto- HSCT (> 2 ×106/kg; max 7 plerixafor injections if required). PBSC collection was initiated if peripheral CD34+ cells count was >10μl. A successful mobilization was defined as a total yeld of > 2×106/kg. RESULTS. 13 patients (76,5%) collected the minimum number of CD34 cells > 2×106/kg. The diagnosis were: 8MM, 1HL,1 NHL. 7 patients (2NHL; 4 MM; 1 LH; 7 predicted) were able to collect > 5×106/Kg. Only 4 patients (3 MM; 1 LNH; 4 proven) failed the mobilization because the numbers of cells CD34 were < 10μL and these patients did not undergo to apheresis procedures. The collection target of 2×106/Kg was reached in a median of 2 apheresis session (range 1–3). The technical characteristics of the procedures were (median value): blood volume processed 12 L (range 9–14), total CD34+/Kg collected 3,06 × 106(range 2,21-8,62), procedure efficiency 47,5% (range 35,3–79), duration of the procedure 261 minutes (range 210–309). Plerixafor was well tolerated and mild side effects were: reactions in the injection site, gastrointestinal disturbs, muscle pain. During administration of plerixafor we did not observe any significant laboratory abnormalities of liver or renal function. CONCLUSION. Unsuccessful mobilization represents an important limitation to ASCT in lymphoma and MM. In our experience plerixafor allowed to collect an appropriate amount of CD34 also in patients defined “proven PM” significantly reducing the percentage of patients that could not undergo ASCT (target value obtained in 43% of “proven PM”). Confirming the recent literature plerixafor is well tolerated with minimal side effects. We retrospectively applied GITMO criteria for PM patients and our experience, although limited, confirm that the use of a correct definition of PM allows the appropriate use of new mobilizing agents like plerixafor increasing significantly the therapeutic options also in patients who had no possibilities to receive an ASCT with the traditional mobilizing therapy. Disclosures: No relevant conflicts of interest to declare.


10.12737/5011 ◽  
2014 ◽  
Vol 21 (2) ◽  
pp. 104-109 ◽  
Author(s):  
Кодяков ◽  
A. Kodyakov ◽  
Груздев ◽  
D. Gruzdev ◽  
Федоров ◽  
...  

This paper is devoted to the actual problem of cosmetology - the procedures of filament rejuvenation of face and neck, which become popular every year. Literature data on the efficacy of these methods are controversial. The authors of most works indicate the minimum number of complications in the practical absence of negative appraisal methodology. The issues of development of the indication for use of some types of filaments and optimal criteria of evaluation of the expected effect in clinical practice are relevant and are discussed in this paper. Taking into account the absence of objective information about long-term consequences, other practical aspects of filament rejuvenation, the authors on the basis of many years of research and experience has specified evaluation criteria and suggested own classification of cosmetic filaments used in the method of filament rejuvenation of face and neck. Installation of filaments with different cosmetic features allows to reaching three different anti-aging effects: lifting, reinforcing and bio-stimulation. The degree of manifestation of these effects depends on the installation method of the thread, but first of all - on the design of conductive filament and needle or cannula. Based on the above data, the authors propose to divide all known cosmetic filaments on the basis of their purpose, proceeding from the achieved effect for three species - lifting, reinforcing and bio-stimulating. The new classification can be used in practice to optimize the selection of filaments for rejuvenation of face and neck and to reduce unintended side effects. The proposed classification of filaments has the purpose of definition of a fundamental criterion for their beauty opportunities. The practical application of this classification contributes to ensure adequate choice of filaments to perform the procedure, reduce side effects and create realistic expectations of doctors and patients from the procedures of the rejuvenation of face and neck.


Sign in / Sign up

Export Citation Format

Share Document