scholarly journals Three-Dimensional Computational Fluid Dynamic Analysis of a Large-Scale Vertical Axis Wind Turbine

2021 ◽  
Vol 5 (1) ◽  
Author(s):  
Hand Brian
Keyword(s):  
Dynamic Analysis ◽  
Wind Turbine ◽  
Computational Fluid Dynamic ◽  
Large Scale ◽  
Fluid Dynamic ◽  
Three Dimensional ◽  
Vertical Axis ◽  
Vertical Axis Wind Turbine ◽  
Computational Fluid Dynamic Analysis

Aerodynamic Measurements on a Vertical Axis Wind Turbine in a Large Scale Wind Tunnel

2010 ◽  
Author(s):  
L. Battisti ◽  
L. Zanne ◽  
S. Dell’Anna ◽  
V. Dossena ◽  
B. Paradiso ◽  
...  
Keyword(s):  
Wind Tunnel ◽  
Flow Field ◽  
Wind Turbine ◽  
Wind Turbines ◽  
Large Scale ◽  
Fluid Dynamic ◽  
Vertical Axis ◽  
Vertical Axis Wind Turbine ◽  
Aerodynamic Optimization ◽  
Vertical Axis Wind Turbines

This paper presents the first results of a wide experimental investigation on the aerodynamics of a vertical axis wind turbine. Vertical axis wind turbines have recently received particular attention, as interesting alternative for small and micro generation applications. However, the complex fluid dynamic mechanisms occurring in these machines make the aerodynamic optimization of the rotors still an open issue and detailed experimental analyses are now highly recommended to convert improved flow field comprehensions into novel design techniques. The experiments were performed in the large-scale wind tunnel of the Politecnico di Milano (Italy), where real-scale wind turbines for micro generation can be tested in full similarity conditions. Open and closed wind tunnel configurations are considered in such a way to quantify the influence of model blockage for several operational conditions. Integral torque and thrust measurements, as well as detailed aerodynamic measurements were applied to characterize the 3D flow field downstream of the turbine. The local unsteady flow field and the streamwise turbulent component, both resolved in phase with the rotor position, were derived by hot wire measurements. The paper critically analyses the models and the correlations usually applied to correct the wind tunnel blockage effects. Results evidence that the presently available theoretical correction models does not provide accurate estimates of the blockage effect in the case of vertical axis wind turbines. The tip aerodynamic phenomena, in particular, seem to play a key role for the prediction of the turbine performance; large-scale unsteadiness is observed in that region and a simple flow model is used to explain the different flow features with respect to horizontal axis wind turbines.

Numerical Study to Quantify the Effects of Struts and Central Hub on the Performance of a Three Dimensional Vertical Axis Wind Turbine Using Sliding Mesh

2013 ◽  
Author(s):  
M. Salman Siddiqui ◽  
Naveed Durrani ◽  
Imran Akhtar
Keyword(s):  
Wind Turbine ◽  
Numerical Study ◽  
Fluid Dynamic ◽  
Unit Length ◽  
Three Dimensional ◽  
Vertical Axis ◽  
Torque Ripple ◽  
Outer Diameter ◽  
Vertical Axis Wind Turbine ◽  
Sliding Mesh

A computational fluid dynamic (CFD) analysis is carried out to investigate the effects of struts and central hub in 3D on the overall performance prediction of a three dimensional vertical axis wind turbine (VAWT) with three Darrieus H-type blades. The VAWT has the outer diameter of 2.5m and finite unit length height with expected output of 2KVA. This type of small VAWT are expected to perform better on roof tops of the built-up urban area. The analysis is carried out using sliding mesh concept in commercial CFD software ‘Ansys Fluent 13’. It is observed that the struts and central hub assembly induce additional drag and generate strong vortices which caused a substantial decrease in the performance parameters of the turbine. The numerical simulation are carried out over a three dimensional VAWT with and without struts and central hub. It is found that both the cases show a similar trend of the torque ripple for any one blade while for the upstream path, on the contrary the blades experience a drop in performance from 220° to 360° due to the struts and central hub assembly. A detailed comparative analysis between both the cases is made over the TSR values range from 1.5 to 4.5. At TSR = 1.5, the performance coefficient of the cases with and without struts and central hub are same. However, for the case of struts and central hub, TSR 4 and above show negative values of power coefficients.

Comparison of Experimental and Numerically Predicted Three-Dimensional Wake Behaviour of a Vertical Axis Wind Turbine

2017 ◽  
Author(s):  
Joseph Saverin ◽  
David Marten ◽  
David Holst ◽  
George Pechlivanoglou ◽  
Christian Oliver Paschereit ◽  
...  
Keyword(s):  
Wind Turbine ◽  
Large Scale ◽  
Computational Cost ◽  
Three Dimensional ◽  
Vertical Axis ◽  
Tip Vortex ◽  
Vertical Axis Wind Turbine ◽  
Design And Optimization ◽  
Aerodynamic Model ◽  
Lift And Drag

The evolution of the wake of a wind turbine contributes significantly to its operation and performance, as well as to those of machines installed in the vicinity. The inherent unsteady and three-dimensional aerodynamics of Vertical Axis Wind Turbines (VAWT) have hitherto limited the research on wake evolution. In this paper the wakes of both a troposkien and a H-type VAWT rotor are investigated by comparing experiments and calculations. Experiments were carried out in the large-scale wind tunnel of the Politecnico di Milano, where unsteady velocity measurements in the wake were performed by means of hot wire anemometry. The geometry of the rotors was reconstructed in the open-source wind-turbine software QBlade, developed at the TU Berlin. The aerodynamic model makes use of a lifting line free-vortex wake (LLFVW) formulation, including an adapted Beddoes-Leishman unsteady aerodynamic model; airfoil polars are introduced to assign sectional lift and drag coefficients. A wake sensitivity analysis was carried out to maximize the reliability of wake predictions. The calculations are shown to reproduce several wake features observed in the experiments, including blade-tip vortex, dominant and submissive vortical structures, and periodic unsteadiness caused by sectional dynamic stall. The experimental assessment of the simulations illustrates that the LLFVW model is capable of predicting the unsteady wake development with very limited computational cost, thus making the model ideal for the design and optimization of VAWTs.

Three-dimensional computational fluid dynamic analysis of a large-scale vertical axis wind turbine

2021 ◽  
pp. 0309524X2110379
Author(s):  
Brian Hand
Keyword(s):  
Wind Turbine ◽  
Large Scale ◽  
Three Dimensional ◽  
Vertical Axis ◽  
Offshore Wind ◽  
Speed Ratio ◽  
Offshore Wind Turbine ◽  
Vertical Axis Wind Turbine ◽  
Computational Fluid Dynamics Analysis ◽  
Torque Coefficient

The vertical axis wind turbine (VAWT) configuration has many advantages for an offshore wind turbine Installation. In this paper, the three dimensional (3D) computational fluid dynamics analysis of a large-scale 5 MW VAWT is conducted. At the optimum tip-speed ratio (TSR), the VAWT maximum inline force was 75% larger than the maximum lateral force. It was found the dynamic stall effects cause the VAWT flow field to become increasingly asymmetrical at the mid-span plane, when the TSR is reduced. The attachment of end plates to the blade tips, resulted in a performance improvement during the upwind phase with the average blade torque coefficient in this range being increased by 4.71%. Conversely, during the blade downwind phase a reduction in performance was found due to the increase in drag from the end plates and the average blade torque coefficient in this phase was reduced by 23.1%.

scholarly journals Three-Dimensional CFD Simulation and Experimental Assessment of the Performance of a H-Shape Vertical-Axis Wind Turbine at Design and Off-Design Conditions

2019 ◽  
Vol 4 (3) ◽  
pp. 30 ◽  
Author(s):  
Nicoletta Franchina ◽  
Otman Kouaissah ◽  
Giacomo Persico ◽  
Marco Savini
Keyword(s):  
Wind Turbine ◽  
Large Scale ◽  
Computational Cost ◽  
Three Dimensional ◽  
Vertical Axis ◽  
Operating Conditions ◽  
Speed Ratio ◽  
Small Scale ◽  
Vertical Axis Wind Turbine ◽  
Numerical Predictions

The paper presents the results of a computational study on the aerodynamics and the performance of a small-scale Vertical-Axis Wind Turbine (VAWT) for distributed micro-generation. The complexity of VAWT aerodynamics, which are inherently unsteady and three-dimensional, makes high-fidelity flow models extremely demanding in terms of computational cost, limiting the analysis to mainly 2D or 2.5D Computational Fluid-Dynamics (CFD) approaches. This paper discusses how a proper setting of the computational model opens the way for carrying out fully 3D unsteady CFD simulations of a VAWT. Key aspects of the flow model and of the numerical solution are discussed, in view of limiting the computational cost while maintaining the reliability of the predictions. A set of operating conditions is considered, in terms of tip-speed-ratio (TSR), covering both peak efficiency condition as well as off-design operation. The fidelity of the numerical predictions is assessed via a systematic comparison with the experimental benchmark data available for this turbine, consisting of both performance and wake measurements carried out in the large-scale wind tunnel of the Politecnico di Milano. The analysis of the flow field on the equatorial plane allows highlighting its time-dependent evolution, with the aim of identifying both the periodic flow structures and the onset of dynamic stall. The full three-dimensional character of the computations allows investigating the aerodynamics of the struts and the evolution of the trailing vorticity at the tip of the blades, eventually resulting in periodic large-scale vortices.

Sign in / Sign up

Export Citation Format

Share Document