Indoor environmental input parameters for design and assessment of energy performance of buildings addressing indoor air quality, thermal environment, lighting and acoustics

2019 ◽  
Vol 24 (1) ◽  
pp. 7-16 ◽  
Author(s):  
Kalle Kuusk ◽  
Ahmed Kaiser ◽  
Nicola Lolli ◽  
Jan Johansson ◽  
Tero Hasu ◽  
...  

The European energy policy pushes the member states to transform building stock into nearly Zero-Energy Buildings (nZEB). This paper is focused on data collected from existing nZEB day-care centres,in order to be able to assess possible differences between predicted and actual energy and indoorenvironmental performance. Building structures, service systems and the indoor climate and energyperformance of five day-care centres were investigated in Estonia, Finland and Norway.Indoor climate condition measurements showed that in general, the thermal environment and indoor airquality corresponded to the highest indoor climate categories I and II (EN 15251). Building heating andventilation systems in studied buildings are working without major problems. Good indoor climate conditions were also reflected in the occupant satisfaction questionnaires. For most of the studied buildings, over 80%of the people marked all indoor environment condition parameters (thermal comfort, indoor air quality,acoustics, odour and illuminance) acceptable. The thermal environment in the cooling season was reportedproblematic because it was lower than the minimum temperature for indoor climate category II.Energy consumption analysis showed that measured real energy use was higher, or even significantlyhigher, than the energy use calculated during the design phase. Potential causes of the higher actualenergy consumption are caused by differences of measured and designed solutions, methodology of theenergy calculations, and the differences in user behaviour.Lessons learnt from previously constructed day-care centres can be utilised in the planning and designof new nZEBs.


2016 ◽  
Vol 96 ◽  
pp. 277-284 ◽  
Author(s):  
V. Vasile ◽  
H. Petran ◽  
A. Dima ◽  
C. Petcu

2014 ◽  
Vol 1065-1069 ◽  
pp. 1656-1660
Author(s):  
Wen Jie Li ◽  
Xin Xue Liao ◽  
Zhe Meng ◽  
Gao Yang Miao

An investigation study on built environment was carried out for ground shopping malls and underground shopping malls, in search of similarities and differences between them. Four representative shopping malls were investigated from 2012 to 2014 by means of testing and questionnaires. It analyzed the current situation of indoor thermal environment, light environment, acoustic environment as well as indoor air quality. The study found that no significant differences in indoor environmental parameters (including air temperature, relative humidity and air velocity) and people’s sensation vote to them, apart from draft sensation vote for the two types of shopping malls. Besides, both the average indoor illumination was far below the national standard especially for underground shopping malls. Moreover, Noise levels were basically the same and the satisfaction rate of acoustic environment of underground shopping malls was apparently inferior to that of ground shopping malls. Eventually, indoor air quality was not as undesirable as it was expected even measured in the two types. On the basis of studying, some practicable improvement measures were proposed.


2021 ◽  
Vol 21 (1) ◽  
pp. 1-7
Author(s):  
Abdulhadi Salman ◽  
Ali A. Monem ◽  
Emad A. Khazal

A proper ventilation offered warranty for a perfect indoor environment. Indoor air environment includes indoor thermal environment and indoor air quality (IAQ). In this paper a numerical investigation of the indoor environment in different ventilations was accomplished. The Cardiac Care Unit (CCU) in Al-Rifai hospital in Thi-Qar governorate was chosen to be investigated, and its thermal achievement and indoor air quality in the hot summer weather were simulated. For the numerical study, the fluent technique used to set up the physical and numerical model of CCU. An attention has been paid carefully to considerate the distributions of the temperature and the velocity fields, followed by an argument of two different ventilation patterns; up-in and up-out ventilation (UV) and displacement ventilation (DV). After making the comparison, it was noticed that the displacement ventilation (DV) is clearly super than that of the up-in and up-out ventilation (UV) due to improvement in the indoor air quality.


2012 ◽  
Vol 518-523 ◽  
pp. 4435-4438
Author(s):  
Da Hua Jiang ◽  
Zhi Hua Wang ◽  
Fa En Shi ◽  
Ru Shan Ren

It is of great importance to study the impact of the cooking generated contaminants on the indoor air quality in the kitchen since cooking is regarded as the main source of indoor contaminants. This study aims investigate and analysis the indoor air quality of kitchen with using CFD numerical analysis method via the velocity, temperature, humidity CO2 concentration .It is concluded that The temperature distribution are large difference in the kitchen and the maximum value is up to 324K on the work area which near the cooking ,and the CO2 concentration which is close to the stove is 1420ppm,1370ppm, 1470ppm respectively, and it is more than the acceptance criteria (CO2<1000ppm) 42%,37% and 47% respectively. It is serious impact on the staff's physical health.


2021 ◽  
Vol 203 ◽  
pp. 70-92
Author(s):  
Douaa K. Al Assaad ◽  
Mohamad S. Orabi ◽  
Nesreen K. Ghaddar ◽  
Kamel F. Ghali ◽  
Darine A. Salam ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document