Specification for manufacture of glued-laminated timber structural members

This paper presents a pilot study on bending and shear strength of glued laminated (glulam) timber using selected tropical timber namely, Kekatong (Cynometra spp.) and Melagangai (Potoxylon melagangai) as an alternative for timber railway sleepers. Selected timbers were manufactured in accordance with MS758:2001 and the bending test was conducted according to ASTM D198:2013. The shear test for glue line integrity was performed to observe the bond performance in glulam accordance to MS758:2001.The results showed both species can be used as structural members since the bending strength obtained from the laboratory work is greater than the allowable bending strength. In terms of the percentage of wood failure, the bonding characteristics of both glulam satisfied the bonding requirement stipulated in the standard and have the potential to be used as glulam timber railway sleepers.

Download Full-text

Specification for glued-laminated timber structural members

10.3403/00104513 ◽

1970 ◽

Keyword(s):

Structural Members ◽

Glued Laminated Timber

Download Full-text

Specification for manufacture of glued-laminated timber structural members

10.3403/00179186u ◽

2015 ◽

Keyword(s):

Structural Members ◽

Glued Laminated Timber

Download Full-text

Review on Experimental Study on Effect of Corrosion In Reinforced Concrete Fly-Ash Beam

International Journal of Scientific Research in Science and Technology ◽

10.32628/ijsrst207318 ◽

2020 ◽

pp. 92-96

Author(s):

Shubham N. Dadgal ◽

Shrikant Solanke

Keyword(s):

Fly Ash ◽

Bond Strength ◽

Structural Damage ◽

Pullout Test ◽

Partial Replacement ◽

Structural Members ◽

Accelerated Corrosion ◽

Resistivity Method ◽

Electrical Resistivity Method ◽

Structural Failures

In modern days for structures in coastal areas it has been observed that the premature structural failures are occurs due to corrosion of the reinforcements of the designed structural member. The corrosion causes the structural damage which in turn leads to reduction in the bearing capacity of the concerned structural members. The aim of this study was to study the effect of partial replacement of fly ash to minimize the corrosion effect. Beams were designed and corroded by using artificial method known accelerated corrosion method. The beams were then tested for flexural and bond strength. Also the weight loss of the reinforced bars was been determined using electrical resistivity method. The fly ash will replace by 10% and 15%.The strength will calculate at varying percentage of corrosion at 10% and 15%. Beams will cast at M25 grade concrete. The flexural strength will test by using UTM and the bond strength will calculate using pullout test.

Download Full-text