scholarly journals Passive Detection of Phosphorus in Agricultural Tile Waters Using Reactive Hybrid Anion Exchange Resins

Water ◽  
2020 ◽  
Vol 12 (10) ◽  
pp. 2808
Author(s):  
Zhe Li ◽  
Maria Librada Chu ◽  
Lowell Gentry ◽  
Ying Li ◽  
Corey Mitchell ◽  
...  
Keyword(s):  
Iron Oxide ◽  
Anion Exchange ◽  
Passive Sampling ◽  
Sampling Rate ◽  
Sampling Technique ◽  
Batch Adsorption ◽  
Storm Events ◽  
Passive Detection ◽  
Anion Exchange Resins ◽  
Exchange Resins

Tile drainage waters carry considerable loads of phosphorus (P) from agricultural fields to rivers and streams in the Midwestern U.S. An innovative and economical approach to monitor dissolved reactive P (DRP) flux in tile waters is needed to understand the extent of P loss in field-scale. In this study, a passive sampling technique was developed using iron oxide-coated polyacrylic/polystyrene anion exchange resins (hybrid resins) a P sink. Laboratory batch adsorption isotherm and kinetic experiments indicated that the hybrid resins had high P adsorption capacity (7.69–19.84 mg/g) and high kinetic performance. The passive sampling method with field-calibrated hybrid polyacrylic resin and hybrid polystyrene resins (sampling rate: 0.1351 and 0.0763 L/h, respectively) predicted the average DRP concentrations of 0.006–0.020 mg/L, which did not differ significantly (p > 0.05) from the auto-sampling data. A rapid increase in DRP concentration during storm events and subsequent flooding events was also predicted well. In conclusion, a passive detection method using iron oxide coated hybrid resins can be recommended for monitoring seasonally fluctuating DRP flux in agricultural waters as long as the hybrid resins are well-calibrated under specific field conditions (e.g., flow rate and concentration range).

Anion-exchange resins and iron oxide-impregnated filter paper as plant available phosphorus indicators in soils

2002 ◽  
Vol 33 (7-8) ◽  
pp. 1119-1130 ◽  
Author(s):  
C. A. Bissani ◽  
M. J. Tedesco ◽  
F. A. de O. Camargo ◽  
G. L. Miola ◽  
C. Gianello
Keyword(s):  
Iron Oxide ◽  
Anion Exchange ◽  
Filter Paper ◽  
Available Phosphorus ◽  
Anion Exchange Resins ◽  
Exchange Resins

Removal of Hydrophobic and Hydrophilic Constituents by Anion Exchange Resin

1999 ◽  
Vol 40 (9) ◽  
pp. 207-214 ◽  
Author(s):  
J.-P. Croué ◽  
D. Violleau ◽  
C. Bodaire ◽  
B. Legube
Keyword(s):  
Molecular Weight ◽  
Anion Exchange ◽  
Water Source ◽  
Atomic Ratio ◽  
Size Exclusion ◽  
Salting Out ◽  
Anion Exchange Resins ◽  
Hydrophilic Character ◽  
Exchange Resins

The objective of this work was to compare the affinity of well characterized NOM fractions isolated from two surface waters with strong (gel matrix and macroporous matrix) and weak anion exchange resins (AER) using batch experiment conditions. The structural characterization of the fraction of NOM has shown that the higher the hydrophilic character, the lower the C/O atomic ratio, the lower the SUVA, the lower the aromatic carbon content and the lower the molecular weight. In general (not always), strong AER was more efficient to remove DOC than weak AER. For the same water source (Suwannee River), the higher the molecular weight of the NOM fraction, the lower the affinity with AER. Increasing the ionic strength favored the removal of the hydrophobic NOM fraction (“salting out” effect) while increasing the pH apparently reduced the removal of the hydrophilic NOM fraction. Results were discussed in terms of size exclusion, adsorption, anion exchange and also hydrophobic/hydrophilic repulsion.

scholarly journals Impact of anion exchange adsorbents on regional citrate anticoagulation

2020 ◽  
pp. 039139882094773
Author(s):  
Karin Strobl ◽  
Stephan Harm ◽  
Ute Fichtinger ◽  
Claudia Schildböck ◽  
Jens Hartmann
Keyword(s):  
Anion Exchange ◽  
Regional Citrate Anticoagulation ◽  
Liver Support ◽  
Anion Exchange Resins ◽  
Increased Risk ◽  
Extracorporeal Liver Support ◽  
Target Molecules ◽  
Exchange Resins ◽  
The Impact

Introduction: Heparin and citrate are commonly used anticoagulants in membrane/adsorption based extracorporeal liver support systems. However, anion exchange resins employed for the removal of negatively charged target molecules including bilirubin may also deplete these anticoagulants due to their negative charge. The aim of this study was to evaluate the adsorption of citrate by anion exchange resins and the impact on extracorporeal Ca2+ concentrations. Methods: Liver support treatments were simulated in vitro. Citrate and Ca2+ concentrations were measured pre and post albumin filter as well as pre and post adsorbents. In addition, batch experiments were performed to quantify citrate adsorption. Results: Pre albumin filter target Ca2+ concentrations were reached well with only minor deviations. Citrate was adsorbed by anion exchange resins, resulting in a higher Ca2+ concentration downstream of the adsorbent cartridges during the first hour of treatment. Conclusions: The anion exchange resin depletes citrate, leading to an increased Ca2+ concentration in the extracorporeal circuit, which may cause an increased risk of clotting during the first hour of treatment. An increase of citrate infusion during the first hour of treatment should therefore be considered to compensate for the adsorption of citrate.

scholarly journals Mg/Al double-metal hydroxide regeneration of anion exchange resin by electric field intensification

2016 ◽  
Vol 75 (6) ◽  
pp. 1309-1318 ◽  
Author(s):  
Ying Wang ◽  
Zhun Li ◽  
Yansheng Li ◽  
Zhigang Liu
Keyword(s):  
Electric Field ◽  
Anion Exchange ◽  
Exchange Resin ◽  
Ph Value ◽  
Anion Exchange Resin ◽  
Cost Effective ◽  
Regenerative Capacity ◽  
Metal Hydroxides ◽  
Anion Exchange Resins ◽  
Exchange Resins

Fouled anion exchange resins were regenerated by electric field intensification of Mg/Al double-metal hydroxides. Regenerative experiments were performed with varying voltages (10–30 V) and dosages of Mg/Al hydroxides (0.045–0.135 mol and 0.015–0.045 mol, respectively) for 1–5 h. Optimal results were obtained under the following regenerative conditions: 20 V, 4 h, and 0.09/0.03 mol of Mg/Al hydroxides. The maximum regenerative capacity of resins was increased to 41.07%. The regenerative mechanism was presented by Fourier-transform infrared spectrum of resins and Mg/Al hydroxides, and the regenerative degree was analyzed with respect to conductivity, pH value, and electric current. Mg/Al hydroxides were also recycled after the regeneration. This method was proven to be cost-effective and environmentally friendly.

Sign in / Sign up

Export Citation Format

Share Document