scholarly journals Analysis of the Limit Support Pressure of a Shallow Shield Tunnel in Sandy Soil Considering the Influence of Seepage

Symmetry ◽  
2020 ◽  
Vol 12 (6) ◽  
pp. 1023 ◽  
Author(s):  
Bo Mi ◽  
Yanyong Xiang
Keyword(s):  
Numerical Simulation ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Limit Equilibrium ◽  
Water Pressure ◽  
Three Dimensional ◽  
Support Pressure ◽  
Tunnel Face ◽  
Dimensional Solution ◽  
Physical Model Tests

The objective was to optimize the existing solution for the limit support pressure of a tunnel face. Firstly, based on the numerical simulation results, the existing three-dimensional analytical solution for pore water pressure distribution is expanded to a three-dimensional solution considering the pore water pressure distribution in the upper formation behind the tunnel face. Then, according to the results of physical model tests, a failure model considering the failure range in the upper formation behind the tunnel face is established, and the newly established three-dimensional solution for pore water pressure is introduced into the model, and then the limit effective support pressure of the tunnel face considering seepage is obtained by the method of soil–water joint calculation. Finally, the calculation results in this paper are compared with the experimental results, numerical simulation results and existing theoretical solutions. The major findings are as follows. The distribution of pore water pressure in the front and back strata above the tunnel face is basically symmetrical. The limit effective support pressure of the tunnel face will increase linearly with an increase in the hydraulic head difference between the tunnel face and the ground surface. The calculated results of the new limit equilibrium theory are obviously larger than those of the existing theory and numerical simulation and closer to the results of the physical model tests. Therefore, the new limit equilibrium model can better predict the limit effective support pressure of the tunnel face considering seepage and provide a reference for actual projects.

scholarly journals Three-Dimensional Upper Bound Limit Analysis on the Collapse of Shallow Soil Tunnels considering Roof Stratification and Pore Water Pressure

2019 ◽  
Vol 2019 ◽  
pp. 1-15 ◽  
Author(s):  
Hong-Tao Wang ◽  
Ping Liu ◽  
Chi Liu ◽  
Xin Zhang ◽  
Yong Yang ◽  
...  
Keyword(s):  
Pore Water ◽  
Upper Bound ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Nonlinear Coefficient ◽  
Soil Layer ◽  
Three Dimensional ◽  
Support Pressure ◽  
Flow Rule ◽  
Soil Cohesion

Based on the plastic upper bound theorem, a three-dimensional kinematically admissible velocity field is constructed for the collapse of the soil masses above a shallow tunnel. In this field, this paper considers the influences of the roof stratification, pore water pressure, ground overload, and support pressure. This study deduced the upper bound solutions of the weight of the collapsed soil masses and the corresponding collapse surfaces by utilizing the nonlinear failure criterion, associated flow rule, and variation principle. Furthermore, we verified the validity of the proposed method in this paper by comparing this research with the existing work and numerical simulation results. This study obtains the influence laws of varying parameters on the area and weight of the collapsed soil masses. The results reveal that the area and weight of the collapsed soil masses increase with increasing support pressure and soil cohesion, but decrease with increasing thickness of the upper soil layer, nonlinear coefficient, pore water pressure, and ground overload. Among them, the roof stratification, pore water pressure, soil cohesion, and nonlinear coefficient have a significant influence on tunnel collapse, which should be given special consideration in engineering design.

scholarly journals The Hydromechanical Interplay in the Simplified Three-Dimensional Limit Equilibrium Analyses of Unsaturated Slope Stability

Geosciences ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 73
Author(s):  
Panagiotis Sitarenios ◽  
Francesca Casini
Keyword(s):  
Analytical Solution ◽  
Slope Stability ◽  
Slope Failure ◽  
Failure Modes ◽  
Pore Water Pressure ◽  
Limit Equilibrium ◽  
Water Pressure ◽  
Three Dimensional ◽  
Stability Limit ◽  
Smooth Transition

This paper presents a three-dimensional slope stability limit equilibrium solution for translational planar failure modes. The proposed solution uses Bishop’s average skeleton stress combined with the Mohr–Coulomb failure criterion to describe soil strength evolution under unsaturated conditions while its formulation ensures a natural and smooth transition from the unsaturated to the saturated regime and vice versa. The proposed analytical solution is evaluated by comparing its predictions with the results of the Ruedlingen slope failure experiment. The comparison suggests that, despite its relative simplicity, the analytical solution can capture the experimentally observed behaviour well and highlights the importance of considering lateral resistance together with a realistic interplay between mechanical parameters (cohesion) and hydraulic (pore water pressure) conditions.

Three‐Dimensional Numerical Investigation of Pore Water Pressure and Deformation of Pumped Aquifer Systems

Ground Water ◽  
2019 ◽  
Vol 58 (2) ◽  
pp. 278-290 ◽  
Author(s):  
Yun Zhang ◽  
Xuexin Yan ◽  
Tianliang Yang ◽  
Jichun Wu ◽  
Jianzhong Wu
Keyword(s):  
Numerical Investigation ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Three Dimensional ◽  
Aquifer Systems

Downslope movements at shallow depths related to cyclic pore-pressure changes

1993 ◽  
Vol 30 (3) ◽  
pp. 464-475 ◽  
Author(s):  
K.D. Eigenbrod
Keyword(s):  
Pore Water ◽  
Slip Surface ◽  
Pore Water Pressure ◽  
Limit Equilibrium ◽  
Water Pressure ◽  
Ground Surface ◽  
Soil Mass ◽  
Passive Resistance ◽  
Pressure Changes ◽  
Timber Piles

Slow, shallow ground movements in a slope near Yellowknife caused excessive tilting of timber piles that supported an engineering structure. To avoid damage to the structure, the pile foundations had to be replaced by rigid concrete piers that were designed to resist the forces of the moving soil mass. Downhill movements were rather slow and, during an initial inspection, were indicated only by soil that was pushed up against a series of piles on their uphill sides, while gaps had formed on their downhill sides. No open cracks or bulging was observed on the slope. A stability analysis indicated that the slope was not in a state of limit equilibrium. To obtain a better understanding of the creep movements in the slope and their effect on the rigid concrete piers, extensive instrumentation was carried out after the construction of the piers. This included slope indicators, piezometers, thermistors, and total-pressure cells against one of the concrete piers. In addition, a triaxial testing program was undertaken in which the effect of cyclic pore-water pressure changes on the long-term deformations of the shallow clay layer was investigated. From the data collected in the field and laboratory, it could be concluded that (i) tilting of the original timber piles was caused by downslope movements related to cyclic pore-water increases; (ii) the lateral soil movements increased almost linearly with depth from 2 m below the ground surface, with no indication of a slip surface; and (iii) the pressures exerted by the moving soil mass against the rigid concrete piers within the soil mass were equal to the passive resistance activated within the moving soil mass. Key words : soil creep, slope movements, soil pressures, pore-water pressures, freezing pressures, permafrost, cyclic loading.

scholarly journals Numerical Study on Effects of the Embedded Monopile Foundation on Local Wave-Induced Porous Seabed Response

2015 ◽  
Vol 2015 ◽  
pp. 1-13 ◽  
Author(s):  
Chi Zhang ◽  
Qingyang Zhang ◽  
Zaitian Wu ◽  
Jisheng Zhang ◽  
Titi Sui ◽  
...  
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Numerical Study ◽  
Water Pressure ◽  
Three Dimensional ◽  
Navier Stokes ◽  
Stokes Wave ◽  
Local Concentration ◽  
Soil Stress ◽  
Local Wave

Effects of the embedded monopile foundation on the local distributions of pore water pressure, soil stresses, and liquefaction are investigated in this study using a three-dimensional integrated numerical model. The model is based on a Reynolds-Averaged Navier-Stokes wave module and a fully dynamic poroelastic seabed module and has been validated with the analytical solution and experimental data. Results show that, compared to the situation without an embedded foundation, the embedded monopile foundation increases and decreases the maximum pore water pressure in the seabed around and below the foundation, respectively. The embedded monopile foundation also significantly modifies the distributions of the maximum effective soil stress around the foundation and causes a local concentration of soil stress below the two lower corners of foundation. A parametric study reveals that the effects of embedded monopile foundation on pore water pressure increase as the degrees of saturation and soil permeability decrease. The embedded monopile foundation tends to decrease the liquefaction depth around the structure, and this effect is relatively more obvious for greater degrees of saturation, greater soil permeabilities, and smaller wave heights.

In Situ Study on Soil Disturbance Induced by Shield Tunneling in Tianjin

2013 ◽  
Vol 368-370 ◽  
pp. 1674-1677
Author(s):  
Yong Hua Cao ◽  
Xiao Qiang Kou
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Soil Disturbance ◽  
Ground Settlement ◽  
Soil Pressure ◽  
Shield Tunneling ◽  
Tunnel Face ◽  
Tunneling Process

In urban environment, the soil disturbance induced by shield tunneling can be sensitive because it can cause deformation of the ground and damage the near structure. To study this disturbance in the construction process of Tianjin metro line No.3, in-situ monitoring of pore water pressure, soil pressure and ground settlement were conducted. The pore water pressure was monitored for the soil around the tunnel. The soil pressure was monitored for the soil around the tunnel and on the tunnel face. It was revealed that the pore water pressure and soil pressure changed twice in the tunneling process and these changes were induced by cutting face and grouting at the shield tail. The soil pressure on the tunnel face reached its maximal value when the distance between the cutting face and the sensor elements was around the diameter of the tunnel. Ground settlement developed in the tunneling process. The shape of ultimate settlement trough is closed to the one obtained by Pecks method.

Analyses for the stability of potash tailings piles

1993 ◽  
Vol 30 (3) ◽  
pp. 491-505 ◽  
Author(s):  
Delwyn G. Fredlund ◽  
Zai Ming Zhang ◽  
Karen Macdonald
Keyword(s):  
Slope Stability ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Limit Equilibrium ◽  
Water Pressure ◽  
Field Studies ◽  
Equilibrium Analysis ◽  
Limit Equilibrium Analysis ◽  
Dissipation Model ◽  
The Stability

The stability of potash tailings piles is investigated using a pore-water pressure generation and dissipation model together with a limit equilibrium analysis. It is found that a shallow toe failure mode is generally the most applicable and that the stability may be influenced by pore-water pressure migration below the pile. It is suggested that field studies would be useful in evaluating stability in the toe region of the pile. Key words : potash tailings, slope stability, pore pressure dissipation, solutioning.

Limit equilibrium analysis for the design of backfilled stope barricades made of waste rock

2011 ◽  
Vol 48 (11) ◽  
pp. 1713-1728 ◽  
Author(s):  
Li Li ◽  
Michel Aubertin
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Limit Equilibrium ◽  
Water Pressure ◽  
Waste Rock ◽  
Equilibrium Analysis ◽  
Mining Operations ◽  
Limit Equilibrium Analysis ◽  
Fill Material

Backfilling of underground stopes is commonly applied in mining operations. Barricades are required to hold the fill material in the stope during and after placement. As such barricades may be constructed with waste rock, there is a need to develop solutions to analyse their response. This paper presents a limit equilibrium analysis solution for defining the dimensions of waste rock barricades. The proposed solution applies to drained (without pore-water pressure) and submerged (with pore-water pressure) conditions. The solutions are presented and applied to sample cases.

Sign in / Sign up

Export Citation Format

Share Document