scholarly journals The Investigation of Organic Binder Effect on Morphological Structure of Ceramic Membrane Support

Symmetry ◽  
2020 ◽  
Vol 12 (5) ◽  
pp. 770 ◽  
Author(s):  
Mohamed Boussemghoune ◽  
Mustapha Chikhi ◽  
Yasin Ozay ◽  
Pelin Guler ◽  
Bahar Ozbey Unal ◽  
...  
Keyword(s):  
Ceramic Membrane ◽  
Thermo Gravimetric Analysis ◽  
Chemical Properties ◽  
Morphological Structure ◽  
Clay Material ◽  
Gravimetric Analysis ◽  
X Ray Diffraction ◽  
X Ray ◽  
Physical And Chemical ◽  
And Chemical Properties

In this study, we investigated the effect of different organic binders on the morphologic structure of ceramic membrane support. Natural raw clay material (kaolin) was used as the main mineral for ceramic membrane support. The physical and chemical properties of kaolin powder and the supports were identified by X-ray fluorescence (XRF), X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), Brunauer–Emmett–Teller (BET), thermo gravimetric analysis (TGA), scanning electron microscopy (SEM), particle size and zeta potential distribution. Based on the XRF test, the main composition of kaolin powder was SiO2 (47.41%) and Al2O3 (38.91%), while the rest were impurities. The FTIR spectra showed the functional groups of Si-O and Al-O. The XRD diffractogram of natural raw clay powder identified kaolinite and nacrite were the main mineral phase whereas muscovite and quartz were detected in small quantities in the sample. After prepared the ceramic membrane supports, XRD diffractogram showed that anorthite and gehlenite were detected as the main mineral phases for ethylene glycol (EG), gelatin, methocel and for polyethylene glycol (PEG), respectively. According to BET analyses, the maximum and the minimum pore width were obtained for PEG and gelatin organic binders.

Physical and Chemical Properties of Mineral in Soils of Cassava Cropping Area: A Case Study in Chonburi Province

2014 ◽  
Vol 979 ◽  
pp. 440-443
Author(s):  
W. Siriprom ◽  
K. Teanchai ◽  
S. Kongsriprapan ◽  
J. Kaewkhao ◽  
N. Sangwaranatee
Keyword(s):  
Thermo Gravimetric Analysis ◽  
Chemical Properties ◽  
Gravimetric Analysis ◽  
X Ray Diffraction ◽  
Xrd Pattern ◽  
X Ray ◽  
Physical And Chemical ◽  
And Chemical Properties

The chemical and physical properties of topsoil and subsoil which collected from the cassava cropping area in Chonburi Province have been investigated. The characterization of both soil sample were used X-Ray Diffraction (XRD), Energy Dispersive X-Ray Fluorescence (EDXRF) while FTIR used to confirmed the formation of intermolecular bonding and Thermo-Gravimetric Analysis (TGA) used for investigated the crystalline. It was found that, the XRD pattern indicated quartz phase. The chemical composition by XRF reported that the soils samples consist of Si, Al, Ca, Fe, K, Mn, Ti, Cr, Zn, Ag and Cu. and TGA results, noticed that the removal of moisture and organics material.

Physical and Chemical Properties of Mineral in Soils of Paddy Rice Fields from Chonburi Province, Thailand

2014 ◽  
Vol 979 ◽  
pp. 444-447
Author(s):  
W. Siriprom ◽  
K. Teanchai ◽  
M. Juntaropakorn ◽  
J. Kaewkhao ◽  
N. Sangwaranatee
Keyword(s):  
Thermo Gravimetric Analysis ◽  
Chemical Properties ◽  
Soil Samples ◽  
Paddy Rice ◽  
Rice Fields ◽  
Gravimetric Analysis ◽  
X Rays ◽  
X Ray Diffraction ◽  
Physical And Chemical ◽  
And Chemical Properties

The aim of this study is to investigate the some chemical and physical properties in the soils collected from the paddy rice fields in Chonburi Province. The chemical analysis of soil samples was performed on an Energy Dispersive X-rays spectrometer (EDXRF). It was found that the soils samples consist of Si, Al, Ca, Fe, K, Mn, Ti, Cr, Zn, Ag and Cu. Another that, the structural in whole soil samples were carried out by X-ray Diffraction (XRD) technique. It was found that Silica (SiO2) is the major minerals in all soil layers. In this study, we also used Thermo-Gravimetric Analysis (TGA) investigated the removal of moisture from the paddy rice fields.

Monitoring of Fluctuations in the Physical and Chemical Properties of a High-Calcium Fly Ash

1987 ◽  
Vol 113 ◽  
Author(s):  
Scott Schlorholtz ◽  
Ken Bergeson ◽  
Turgut Demirel
Keyword(s):  
Fly Ash ◽  
Chemical Properties ◽  
Operating Conditions ◽  
Physical And Chemical Properties ◽  
X Ray Diffraction ◽  
X Ray ◽  
Morphological Studies ◽  
High Calcium ◽  
Physical And Chemical ◽  
And Chemical Properties

ABSTRACTThe physical and chemical properties of fly ash produced at Ottumwa Generating Station have been monitored since April, 1985. The fly ash is produced from burning a low sulfur, sub-bituminous coal obtained from the Powder River Basin near Gillette, Wyoming. One-hundred and sixty samples of fly ash were obtained during the two year period. All of the samples were subjected to physical testing as specified by ASTM C 311. About one-hundred of the samples were also subjected to a series of tests designed to monitor the self-cementing properties of the fly ash. Many of the fly ash samples were subjected to x-ray diffraction and fluorescence analysis to define the mineralogical and chemical composition of the bulk fly ash as a function of sampling date. Hydration products in selected hardened fly ash pastes, were studied by x-ray diffraction and scanning electron microscopy. The studies indicated that power plant operating conditions influenced the compressive strength of the fly ash paste specimens. Mineralogical and morphological studies of the fly ash pastes indicated that stratlingite formation occurred in the highstrength specimens, while ettringite was the major hydration product evident in the low-strength specimens.

Characterization of Shivirtui Zeolite Modified with Aluminum Oxyhydroxide Nanofibers

2019 ◽  
Vol 942 ◽  
pp. 40-49
Author(s):  
Yulia Murashkina ◽  
Olga B. Nazarenko
Keyword(s):  
Chemical Properties ◽  
Nitrogen Adsorption ◽  
X Ray Diffraction ◽  
Scanning Electronic Microscopy ◽  
Electronic Microscopy ◽  
X Ray ◽  
Physical And Chemical ◽  
And Chemical Properties ◽  
Aluminum Oxyhydroxide

Natural zeolite of Shivirtui deposit (Russia) was modified with nanofibers of aluminum oxyhydroxide AlOOH. Aluminum oxyhydroxide nanofibers were produced at the heating and oxidation of aluminum powder with water. The properties of modified zeolite were investigated by means of X-ray diffraction, transmission electronic microscopy, scanning electronic microscopy, low-temperature nitrogen adsorption, thermal analysis, and Fourier transform infrared spectroscopy. It was found that water content in the modified sample of zeolite was about 15 %. Based on the study of the physical and chemical properties, shivirtui zeolite modified with nanofibers of aluminum oxyhydroxide can be proposed for use as a flame-retardant additive to polymers.

Preparation and Evaluation of Nano-Hydroxyapatite/β-Tricalcium Phosphate/Chitosan Composite Scaffolds for Bone Tissue Engineering

2007 ◽  
Vol 361-363 ◽  
pp. 463-466
Author(s):  
T. Lin ◽  
S.M. Zhang ◽  
J. Li ◽  
L. Zhang ◽  
Y.H. Liu ◽  
...  
Keyword(s):  
Chemical Properties ◽  
Physical And Chemical Properties ◽  
X Ray Diffraction ◽  
Composite Scaffolds ◽  
X Ray ◽  
Viable Cells ◽  
Physical And Chemical ◽  
Chitosan Composite ◽  
Preparation And Evaluation ◽  
And Chemical Properties

The composite scaffolds with nine different ratios of nano-HA and ß-TCP content were fabricated by using lyophilization method. Their microscopy, physical and chemical properties were investigated by using scanning electron microscopy (SEM), X-ray diffraction (XRD), and fourier transformed infrared (FTIR) spectroscopy. MTT test was applied to quantitatively assess the number of viable cells attached and grown on the scaffolds. And the result showed that the amount of cells on the scaffold containing 30% by mass of nano-HA was significantly higher than the other samples.

scholarly journals Change of physical and chemical properties clinoptilolite after mechanical activation

2015 ◽  
Vol 11 (2) ◽  
pp. 58-61
Author(s):  
Anastasiya G Bebiya ◽  
Pavel Y Gulyaev ◽  
Irina V Milyukova
Keyword(s):  
Mechanical Activation ◽  
Chemical Properties ◽  
Optimal Time ◽  
X Ray Diffraction ◽  
X Ray ◽  
Sorption Ability ◽  
Maximum Sorption ◽  
Activation Times ◽  
Physical And Chemical ◽  
And Chemical Properties

Presents experimental data depending on the specific surface area and sorption properties of the clinoptilolite powder mechanical activation times. Carried out X-ray diffraction and spec-troscopic analysis of mechanically activated zeolite. Find the optimal time and mechanical activation modes which relate the maximum sorption ability.

Synthesis and characterization of a composite organic semiconductor (curcumin-paracetamol/TiO2)

2020 ◽  
pp. 096739112092169
Author(s):  
Asmaa Bouazza ◽  
Salah Bassaid ◽  
Bouabdallah Daho ◽  
Massimo Messori ◽  
Abdelkader Dehbi
Keyword(s):  
Organic Semiconductor ◽  
Chemical Properties ◽  
X Ray Diffraction ◽  
X Ray ◽  
Production Water ◽  
Synthesis Methodology ◽  
Physical And Chemical ◽  
Electronic And Structural Properties ◽  
And Chemical Properties

The aim of this work is to study some physical and chemical properties of an organic semiconductor (OSc)/ x%titanium dioxide (TiO2) heterosystem (with 0 ≤ x ≤ 20%) (OScs/ x%TiO2). The OSc is obtained from pure curcumin and paracetamol as starting molecules. The synthesis methodology of the mixtures of OScs/ x%TiO2 heterosystem involves a microwave-assisted multicomponent reaction using curcumin, paracetamol, and TiO2 as a heterogeneous solution. All mixtures were analyzed by Fourier-transform infrared spectroscopy, Raman spectroscopy, thermogravimetric analysis/differential thermal analysis, X-ray diffraction, ultraviolet–visible spectroscopy, and scanning electron microscopy. The results obtained show a new nanocomposite with interesting pharmaceutical, optical, electronic, and structural properties, which can be used in the fields of energy production, water purification, and air purification, as a biomaterial and for electronic applications.

Preparation of Magnetite-Mg/Al Hydrotalcite through Hydrothermal Process and Subsequent Calcination

2015 ◽  
Vol 1101 ◽  
pp. 336-339 ◽  
Author(s):  
Triastuti Sulistyaningsih ◽  
Sri Juari Santosa ◽  
Dwi Siswanta ◽  
Bambang Rusdiarso
Keyword(s):  
Hydrothermal Process ◽  
Chemical Properties ◽  
Vibrating Sample Magnetometer ◽  
X Ray Diffraction ◽  
X Ray ◽  
Subsequent Calcination ◽  
The Fourier Transform ◽  
Physical And Chemical ◽  
And Chemical Properties

Fe3O4/Mg-Al-NO3-hydrotalcite composite compounds have been synthesized by hydrothermal process followed by calcination to learn the differences in physical and chemical properties of each compound. Hydrothermal was performed at a temperature of 120 °C for 5 h and calcinations was at 450 °C for 3 hours. Characterization of the composite compounds was conducted using the Fourier Transform Infrared Spectroscopy (FTIR), the X-ray diffraction (XRD), Brunauer-Emmett-Teller (BET) and Vibrating Sample Magnetometer (VSM). The characterization results showed that crystallinity, surface area and magnetic properties of hydrothermally treated Mg/Al hydrotalcite-magnetite were higher than those unhydrothermal and calcination products.

Glass-Ceramics Obtained from Sewage Sludge and its Characteristics Affected by Alkalinity

2014 ◽  
Vol 937 ◽  
pp. 70-73
Author(s):  
Di Wu ◽  
Jun Zhang ◽  
Xing Wang Wen ◽  
Hui Ling Liu
Keyword(s):  
Sewage Sludge ◽  
Raw Materials ◽  
Glass Ceramics ◽  
Chemical Properties ◽  
X Ray Diffraction ◽  
Scanning Calorimetry ◽  
X Ray ◽  
Sludge Disposal ◽  
Physical And Chemical ◽  
And Chemical Properties

Sewage sludge was tested as component for producing glass-ceramics with the addition of analytic reagent CaO to solve the sewage sludge disposal problems. The effect of alkalinity (Ak=mCaO/mSiO2) on the characteristics of the glass-ceramics was investigated. Differential scanning calorimetry (DSC) and X-ray diffraction (XRD) were used to investigate thermal behavior and crystalline phase of the samples. It was found that the degree and characteristics of crystals in vitrified sludge significantly correlate to the alkalinity of the raw materials. The glass-ceramics with Ak = 0.36 possessed the best physical and chemical properties.

Sign in / Sign up

Export Citation Format

Share Document