scholarly journals Seawater Desalination via Waste Heat Recovery from Generator of Wind Turbines: How Economical Is It to Use a Hybrid HDH-RO Unit?

2021 ◽  
Vol 13 (14) ◽  
pp. 7571
Author(s):  
Hadi Rostamzadeh ◽  
Saeed Rostami ◽  
Majid Amidpour ◽  
Weifeng He ◽  
Dong Han

Over recent years, the concept of waste heat recovery from the generators of wind turbines for driving a thermal-driven desalination system was introduced, and its advantages were highlighted. However, any selection of a bottoming thermal-driven desalination system among different existing technologies should be taken under consideration before making an ultimate recommendation. Unfortunately, no comprehensive comparison is available in the literature to compare the performance as well as the cost aspects of using the waste thermal energy of the generator of a wind turbine for desalinating seawater, comparing them with those of a layout where the power of the wind turbine is directly supplied to a mechanically driven desalination system for the same amount of drinkable water production. This study aims at analyzing the economic aspects of waste heat recovery from the generators of wind turbines for seawater desalination via the humidification-dehumidification (HDH) approach, versus the reverse osmosis (RO) unit. For this purpose, a closed-air water-heater HDH unit, directly coupled with a RO unit (called a hybrid HDH-RO unit) is employed, in which thermal energy is provided by the heat dissipating from the generator of the wind turbine while its power is supplied directly by the wind turbine. The energetic and exergetic performance, along with the cost aspects of a hybrid HDH-RO unit driven by the wind turbine, are compared with those of a solo RO unit. The results of the study were extended for six different types of wind turbines, and we concluded that the unit cost associated with the freshwater produced by the waste heat recovery approach is astronomically higher than that of the solo RO system for all wind turbine models, and hence is not practically feasible. It was found that more power can be recovered from the discarded brine from the solo RO unit than the hybrid HDH-RO unit. In addition, the solo RO desalination system, working directly with the power of the wind turbine, has a less complex configuration, and hence its investment cost rate is significantly lower than that needed for setting up an HDH-RO unit. At high wind speeds, however, the cost penalty associated with the freshwater produced by the HDH-RO unit decreases, but it is still huge. Among all screened wind turbines, the GW-136/4.8 is most appealing in terms of greater power generation, but its investment cost rate is the highest among all models due to its high rated power value. However, the freshwater unit cost of the GW-136/4.8 is significantly lower than the values obtained for other models. Finally, the two locations of Manjil and Zabol are selected as a benchmark and the results of the simulation are extended for these locations.

2019 ◽  
Vol 9 (19) ◽  
pp. 4017 ◽  
Author(s):  
Valencia ◽  
Duarte ◽  
Isaza-Roldan

Waste-heat recovery (WHR) systems based on the organic Rankine cycle (ORC) improve the thermal efficiency of natural gas engines because they generate additional electric power without consuming more gas fuel. However, to obtain a cost-effective design, thermoeconomic criteria must be considered to facilitate installation, operation, and penetration into real industrial contexts. Therefore, a thermo-economic analyses of a simple ORC (SORC), ORC with recuperator (RORC) and a double-pressure ORC (DORC) integrated with a 2 MW Jenbacher JMS 612 GS-N. L is presented using toluene as the organic working fluid. In addition, the cost rate balances for each system are presented in detail, with the analysis of some thermoeconomics indicator such as the relative cost difference, the exergoeconomic factor, and the cost rates of exergy destruction and exergy loss. The results reported opportunities to improve the thermoeconomic performance in the condenser and turbine, because the exergoeconomic factor for the condenser and the turbine were in the RORC (0.41 and 0.90), and DORC (0.99 and 0.99) respectively, which implies for the RORC configuration that 59% and 10% of the increase of the total cost of the system is caused by the exergy destruction of these devices. Also, the pumps present the higher values of relative cost difference and exergoeconomic factor for B1 (rk = 8.5, fk = 80%), B2 (rk = 8, fk = 85%).


Author(s):  
Leonardo Pierobon ◽  
Rambabu Kandepu ◽  
Fredrik Haglind

With increasing incentives for reducing the CO2 emissions offshore, optimization of energy usage on offshore platforms has become a focus area. Most of offshore oil and gas platforms use gas turbines to support the electrical demand on the platform. It is common to operate a gas turbine mostly under part-load conditions most of the time in order to accommodate any short term peak loads. Gas turbines with flexibility with respect to fuel type, resulting in low turbine inlet and exhaust gas temperatures, are often employed. The typical gas turbine efficiency for an offshore application might vary in the range 20–30%. There are several technologies available for onshore gas turbines (and low/medium heat sources) to convert the waste heat into electricity. For offshore applications it is not economical and practical to have a steam bottoming cycle to increase the efficiency of electricity production, due to low gas turbine outlet temperature, space and weight restrictions and the need for make-up water. A more promising option for use offshore is organic Rankine cycles (ORC). Moreover, several oil and gas platforms are equipped with waste heat recovery units to recover a part of the thermal energy in the gas turbine off-gas using heat exchangers, and the recovered thermal energy acts as heat source for some of the heat loads on the platform. The amount of the recovered thermal energy depends on the heat loads and thus the full potential of waste heat recovery units may not be utilized. In present paper, a review of the technologies available for waste heat recovery offshore is made. Further, the challenges of implementing these technologies on offshore platforms are discussed from a practical point of view. Performance estimations are made for a number of combined cycles consisting of a gas turbine typically used offshore and organic Rankine cycles employing different working fluids; an optimal media is then suggested based on efficiency, weight and space considerations. The paper concludes with suggestions for further research within the field of waste heat recovery for offshore applications.


2017 ◽  
Vol 5 (28) ◽  
pp. 14811-14818 ◽  
Author(s):  
Heqing Tian ◽  
Lichan Du ◽  
Chenglong Huang ◽  
Xiaolan Wei ◽  
Jianfeng Lu ◽  
...  

Thermal energy storage and transfer technology has received significant attention with respect to concentrating solar power (CSP) and industrial waste heat recovery systems.


2017 ◽  
Vol 1 (9) ◽  
pp. 1899-1908 ◽  
Author(s):  
Ravi Anant Kishore ◽  
Shashank Priya

This study demonstrates a novel thermal energy harvesting cycle and provides pathway for low-grade waste heat recovery using magnetocaloric materials.


Sign in / Sign up

Export Citation Format

Share Document