scholarly journals Wide Bandwidth Vibration Energy Harvester with Embedded Transverse Movable Mass

Sensors ◽  
2021 ◽  
Vol 21 (16) ◽  
pp. 5517
Author(s):  
Nathan Jackson ◽  
Luis A. Rodriguez ◽  
Rahul Adhikari
Keyword(s):  
High Power ◽  
Proof Mass ◽  
Low Frequency ◽  
Solid Sphere ◽  
Vibration Energy ◽  
Vibration Energy Harvester ◽  
Linear Dynamics ◽  
Limited Bandwidth ◽  
Non Linear ◽  
Out Of Plane

One of the biggest challenges associated with vibration energy harvesters is their limited bandwidth, which reduces their effectiveness when utilized for Internet of Things applications. This paper presents a novel method of increasing the bandwidth of a cantilever beam by using an embedded transverse out-of-plane movable mass, which continuously changes the resonant frequency due to mass change and non-linear dynamic impact forces. The concept was investigated through experimentation of a movable mass, in the form of a solid sphere, that was embedded within a stationary proof mass with hollow cylindrical chambers. As the cantilever oscillated, it caused the movable mass to move out-of-plane, thus effectively altering the overall effective mass of the system during operation. This concept combined high bandwidth non-linear dynamics from the movable mass with the high power linear dynamics from the stationary proof mass. This paper experimentally investigated the frequency and power effects of acceleration, the amount of movable mass, the density of the mass, and the size of the movable mass. The results demonstrated that the bandwidth can be significantly increased from 1.5 Hz to >40 Hz with a transverse movable mass, while maintaining high power output. Dense movable masses are better for high acceleration, low frequency applications, whereas lower density masses are better for low acceleration applications.

An Electromagnetic Frequency Increased Vibration Energy Harvester

2011 ◽  
Vol 403-408 ◽  
pp. 4231-4234 ◽  
Author(s):  
Khalid Ashraf ◽  
Mohd Haris Md Khir ◽  
John Ojur Dennis
Keyword(s):  
Permanent Magnets ◽  
Energy Harvester ◽  
Proof Mass ◽  
Excitation Frequency ◽  
Average Power ◽  
Low Frequency ◽  
High Frequency Oscillation ◽  
Vibration Energy ◽  
Frequency Oscillation ◽  
Vibration Energy Harvester

This paper presents an impact-based frequency increased electromagnetic vibration energy harvester to scavenge energy in a low frequency environment. To realize the novel impact based frequency up-conversion mechanism, a coil has been elastically anchored with a platform on which four permanent magnets are arranged in such a way that a strong closed magnetic flux path, linking the coil, is formed. The proposed scavenger has two dynamics of motion. The first phase is a low frequency oscillation to absorb energy from ambient vibration during which both the coil and magnet act as proof mass and move collectively. The increased proof mass ensures maximization of absorbed energy. After crossing a certain clearance, the platform containing magnetic setup rigidly and supporting the coil elastically, collides with a rigid stopper and bounces back. As a result of this mechanical impact a high frequency oscillation is setup in the coil relative to the magnets during which energy is transferred to electrical domain by electromagnetic induction. A macro-prototype has been build to prove the proposed concept. Initial test results show that the proposed harvester generates a peak voltage of 1 volt across a load of 220 Ω at an excitation frequency of 5 Hz which corresponds to a peak power of 4.5 mW and average power of 660 µW.

scholarly journals Non-linear Terahertz driving of plasma waves in layered cuprates

2021 ◽  
Vol 12 (1) ◽  
Author(s):  
Francesco Gabriele ◽  
Mattia Udina ◽  
Lara Benfatto
Keyword(s):  
Low Frequency ◽  
Plasma Waves ◽  
Meissner Effect ◽  
High Energy ◽  
Plasma Mode ◽  
Light Pulses ◽  
High Frequency Plasma ◽  
Non Linear ◽  
Out Of Plane ◽  
Layered Cuprates

AbstractThe hallmark of superconductivity is the rigidity of the quantum-mechanical phase of electrons, responsible for superfluid behavior and Meissner effect. The strength of the phase stiffness is set by the Josephson coupling, which is strongly anisotropic in layered cuprates. So far, THz light pulses have been used to achieve non-linear control of the out-of-plane Josephson plasma mode, whose frequency lies in the THz range. However, the high-energy in-plane plasma mode has been considered insensitive to THz pumping. Here, we show that THz driving of both low-frequency and high-frequency plasma waves is possible via a general two-plasmon excitation mechanism. The anisotropy of the Josephson couplings leads to markedly different thermal effects for the out-of-plane and in-plane response, linking in both cases the emergence of non-linear photonics across Tc to the superfluid stiffness. Our results show that THz light pulses represent a preferential knob to selectively drive phase excitations in unconventional superconductors.

scholarly journals Inducing bistability with local electret technology in a microcantilever based non-linear vibration energy harvester

2013 ◽  
Vol 102 (15) ◽  
pp. 153901 ◽  
Author(s):  
M. López-Suárez ◽  
J. Agustí ◽  
F. Torres ◽  
R. Rurali ◽  
G. Abadal
Keyword(s):  
Energy Harvester ◽  
Vibration Energy ◽  
Linear Vibration ◽  
Vibration Energy Harvester ◽  
Non Linear

A Novel Broadband Vibration Energy Harvester

2014 ◽  
Vol 644-650 ◽  
pp. 3560-3563
Author(s):  
Yu Liu ◽  
Xiao Yan He ◽  
Shen Liu ◽  
Ying Wu ◽  
Yi Ou
Keyword(s):  
Resonance Frequency ◽  
Energy Harvester ◽  
Engineering Application ◽  
Low Frequency ◽  
Structure Design ◽  
Vibration Energy ◽  
Vibration Energy Harvester ◽  
Collector Efficiency ◽  
Energy Acquisition ◽  
Mode Energy

A single resonance frequency is the main factor of limiting vibration energy collector efficiency. In this paper, the multi degree of freedom oscillation adjusting bandwidth scheme is reported, designing a kind of new broadband vibration energy harvester, which has multi-mode energy acquisition, multi freedom vibration and broadband characteristics. Firstly, Broadband energy collector structure design. Secondly, Combining with the main vibration form, using the ANSYS carried out a detailed analysis of its working model. Finally, designing the prototype and doing some experimental verification, the results show that the designed energy collector with low frequency and wideband energy acquisition performance, the frequency domain of energy collection is 57.6 to 69.45HZ ,which break through the bottleneck of traditional single resonance frequency of energy acquisition, has a high value of theory and engineering application.

Sign in / Sign up

Export Citation Format

Share Document