scholarly journals System Performance Analysis for an Energy Harvesting IoT System Using a DF/AF UAV-Enabled Relay with Downlink NOMA under Nakagami-m Fading

Sensors ◽  
2021 ◽  
Vol 21 (1) ◽  
pp. 285
Author(s):  
Anh-Nhat Nguyen ◽  
Van Nhan Vo ◽  
Chakchai So-In ◽  
Dac-Binh Ha

This paper investigates system performance in the Internet of Things (IoT) with an energy harvesting (EH) unmanned aerial vehicle (UAV)-enabled relay under Nakagami-m fading, where the time switching (TS) and adaptive power splitting (APS) protocols are applied for the UAV. Our proposed system model consists of a base station (BS), two IoT device (ID) clusters (i.e., a far cluster and a near cluster), and a multiantenna UAV-enabled relay (UR). We adopt a UR-aided TS and APS (U-TSAPS) protocol, in which the UR can dynamically optimize the respective power splitting ratio (PSR) according to the channel conditions. To improve the throughput, the nonorthogonal multiple access (NOMA) technique is applied in the transmission of both hops (i.e., from the BS to the UR and from the UR to the ID clusters). The U-TSAPS protocol is divided into two phases. In the first phase, the BS transmits a signal to the UR. The UR then splits the received signal into two streams for information processing and EH using the APS scheme. In the second phase, the selected antenna of the UR forwards the received signal to the best far ID (BFID) in the far cluster and the best near ID (BNID) in the near cluster using the decode-and-forward (DF) or amplify-and-forward (AF) NOMA scheme. We derive closed-form expressions for the outage probabilities (OPs) at the BFID and BNID with the APS ratio under imperfect channel state information (ICSI) to evaluate the system performance. Based on these derivations, the throughputs of the considered system are also evaluated. Moreover, we propose an algorithm for determining the nearly optimal EH time for the system to minimize the OP. In addition, Monte Carlo simulation results are presented to confirm the accuracy of our analysis based on simulations of the system performance under various system parameters, such as the EH time, the height and position of the UR, the number of UR antennas, and the number of IDs in each cluster.

2021 ◽  
Author(s):  
Van Vo Nhan ◽  
Dang Ngoc Cuong ◽  
Tran Ban Thach ◽  
Hung Tran

In this paper, the system performance of an energy harvesting (EH) unmanned aerial vehicle (UAV) system for use in disasters was investigated. The communication protocol was divided into two phases. In the first phase, a UAV relay (UR) harvested energy from a power beacon (PB). In the second phase, a base station (BS) transmitted the signal to the UR using non-orthogonal multiple access (NOMA); then, the UR used its harvested energy from the first phase to transfer the signal to two sensor clusters, i.e., low-priority and high-priority clusters, via the decode-and-forward (DF) technique. A closed-form expression for the throughput of the cluster heads of these clusters was derived to analyze the system performance. Monte Carlo simulations were employed to verify our approach.


Author(s):  
Kui Xu ◽  
Ming Zhang ◽  
Jie Liu ◽  
Nan Sha ◽  
Wei Xie ◽  
...  

Abstract In this paper, we design the simultaneous wireless information and power transfer (SWIPT) protocol for massive multi-input multi-output (mMIMO) system with non-linear energy-harvesting (EH) terminals. In this system, the base station (BS) serves a set of uplink fixed half-duplex (HD) terminals with non-linear energy harvester. Considering the non-linearity of practical energy-harvesting circuits, we adopt the realistic non-linear EH model rather than the idealistic linear EH model. The proposed SWIPT protocol can be divided into two phases. The first phase is designed for terminals EH and downlink training. A beam domain energy beamforming method is employed for the wireless power transmission. In the second phase, the BS forms the two-layer receive beamformers for the reception of signals transmitted by terminals. In order to improve the spectral efficiency (SE) of the system, the BS transmit power- and time-switching ratios are optimized. Simulation results show the superiority of the proposed beam-domain SWIPT protocol on SE performance compared with the conventional mMIMO SWIPT protocols.


2019 ◽  
Vol 2019 ◽  
pp. 1-9 ◽  
Author(s):  
Yupeng Li ◽  
Zihao Wang ◽  
Ling Luo ◽  
Zhiyong Chen ◽  
Bin Xia ◽  
...  

In this paper, we investigate an energy harvesting scheme in a smart grid based on the cognitive relay protocol, where a primary transmitter scavenges energy from the nature sources and then employs the harvested energy to forward the primary signal. Depending on the intensity of the energy harvesting from nature, a secondary user dynamically acts as a relay node to assist the primary transmission or does not. When the energy is not enough powerful to support the direct transmission between two primary users, the secondary users share the spectrum by assisting the primary transmission. For the relaying scheme, both amplify-and-forward (AF) and decode-and-forward (DF) protocols are investigated. We analytically obtain the exact transmission rates for both primary and secondary networks and derive the exact expressions of the system outage probabilities for both primary and secondary users in the smart grid. Moreover, we develop the analytically optimal bandwidth allocation strategy to maximize the total sum rate of the proposed scheme. Numerical results are presented to demonstrate the performance gain of the proposed scheme over the nonoptimal scheme.


2019 ◽  
Vol 9 (11) ◽  
pp. 2283 ◽  
Author(s):  
Duy-Hung Ha ◽  
Si Thien Chau Dong ◽  
Tan N. Nguyen ◽  
Tran Thanh Trang ◽  
Miroslav Voznak

In this paper, we introduce a half-duplex (HD) energy harvesting (EH) relay network over the different fading environment with the effect of hardware impairment (HI). The model system was investigated with the amplify-and-forward (AF) and the power splitting (PS) protocols. The system performance analysis in term of the outage probability (OP), achievable throughput (AT), and bit error rate (BER) were demonstrated with the closed-form expressions. In addition, the power splitting (PS) factor was investigated. We verified the analytical analysis by Monte Carlo simulation with all primary parameters. From the results, we can state that the analytical and simulation results match well with each other.


Sensors ◽  
2020 ◽  
Vol 20 (9) ◽  
pp. 2472 ◽  
Author(s):  
Tianwen Yuan ◽  
Mingang Liu ◽  
Yizhi Feng

In this paper, we study the outage and throughput performance for the simultaneous wireless information and power transfer (SWIPT) cooperative decode-and-forward (DF) communication systems. The hybrid receiver that uses both time switching (TS) and power splitting (PS) methods for energy harvesting (EH) and information decoding (ID), and the piece-wise linear EH model that captures the non-linear input-output characteristic of the EH circuit, are considered. We present exact analytical expressions of the outage probability (OP) and throughput, which are expressed as single definite integral on finite interval and can be easily evaluated, for the systems in Rayleigh fading channel. For further simplicity of calculation, we derive novel and closed-form approximate expressions of the OP and throughput. The impact of different system parameters on the system performance is investigated. Numerical results show the high accuracy of the proposed closed-form approximate expressions especially in the region of higher signal-to-noise ratio (SNR). It is also shown that the system performance is greatly overestimated when the ideal linear EH model is used instead of the practical non-linear EH model. A different result to the non-hybrid receiver with both linear EH model and non-linear EH model that there exists an optimal location to minimize the OP for the hybrid receiving relay node with non-linear EH model is also demonstrated.


2018 ◽  
Vol 2 (1) ◽  
pp. 18
Author(s):  
Miroslav Voznak ◽  
Hoang Quang Minh Tran ◽  
N. Tan Nguyen

In recent years, harvesting energy from radio frequency (RF) signals has drawn significant research interest as a promising solution to solve the energy problem. In this paper, we analyze the effect of the interference noise on the wireless energy harvesting performance of a decode-and-forward (DF) relaying network. In this analysis, the energy and information are transferred from the source to the relay nodes in the delay-limited transmission and Delay-tolerant transmission modes by two methods: i) time switching protocol and ii) power splitting protocol. Firstly, due to the constraint of the wireless energy harvesting at the relay node, the analytical mathematical expressions of the achievable throughput, outage probability and ergodic capacity of both schemes were proposed and demonstrated. After that, the effect of various system parameters on the system performance is rigorously studied with closed-form expressions for system throughput, outage probability, and ergodic capacity. Finally, the analytical results are also demonstrated by Monte-Carlo simulation. The results show that the analytical mathematical and simulated results agree with each other.  This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.


2021 ◽  
Vol 10 (2) ◽  
pp. 793-800
Author(s):  
Anh-Tu Le ◽  
Dinh-Thuan Do

In this paper, we investigate non-orthogonal multiple access (NOMA) network relying on wireless power transfer to prolong lifetime. The base station (BS) sends common signals to the relay with two functions (energy harvesting (EH) and signal processing) to further serve two NOMA users in downlink. Performance gap exists since different power allocation factor assigned from power splitting protocol adopted at the relay and such relay employs both amplify-and-forward (AF) and decode-and-forward schemes. To provide performance metrics, we prove formulas of the outage probability which is a function of transmit signal to noise ratio. Simulation results indicate specific parameters to adjust system performance of two user in the considered EH-NOMA system. This finding is important recommendation to design EH-NOMA which shows particular outage performance at required target rates.


2020 ◽  
Vol 2020 ◽  
pp. 1-13
Author(s):  
Hoang Van Toan ◽  
Tran Manh Hoang ◽  
Le The Dung

In this paper, we evaluate a two-way relay system consisting of two terminals and an intermediate relay. In this model, two terminals do not have a direct link but exchange data with each other via the relay in three phases. The relay utilizes energy harvesting technology to collect energy from the received signals of two terminals in the first two phases and then uses the obtained energy for signal transmission in the third phase. Each node is equipped with a single antenna and operates under a half-duplex mode. All wireless channels are influenced by reversible independent flat Rayleigh fading. Using analytical methods, we provide the exact and approximate closed-form expressions of user outage probability and system outage probability. The approximate expressions of these outage probabilities are more explicit and straightforward, providing a better understanding of the influences of network parameters on the system quality. Monte-Carlo simulations are used to confirm the correctness of mathematical analyses.


Author(s):  
Tan N. Nguyen ◽  
Minh Tran ◽  
Van-Duc Phan ◽  
Hoang-Nam Nguyen ◽  
Thanh-Long Nguyen

<p>In this work, the half-duplex (HF) power beacon-assisted (PB) energy harvesting (EH) relaying network, which consists of a source (S), Relay (R), destination (D) and a power beacon (PB) are introduced and investigated. Firstly, the analytical expressions of the system performance in term of outage probability (OP) and the system throughput (ST) are analyzed and derived in both amplify-and-forward (AF) and decode-and-forward (DF) modes. After that, we verify the correctness of the analytical analysis by using Monte-Carlo simulation in connection with the primary system parameters. From the numerical results, we can see that all the analytical and the simulation results are matched well with each other.</p>


Electronics ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 40
Author(s):  
Nabila Sehito ◽  
Shouyi Yang ◽  
Esraa Mousa Ali ◽  
Muhammad Abbas Khan ◽  
Raja Sohail Ahmed Larik ◽  
...  

In this article, we investigated the secrecy performance of a three-hop relay network system with Power Splitting (PS) and Energy Harvesting (EH). In the presence of one eavesdropper, a signal is transferred from source to destination with the help of a relay. The source signal transmits in full-duplex (FD) mood, jamming the relay transfer signals to the destination. The relay and source employ Time Switching (TS) and Energy Harvesting (EH) techniques to obtain the power from the power beacon. In this study, we compared the Secrecy Rate of two Cooperative Schemes, Amplify and Forward (AF) and Decode and Forward (DF), for both designed systems with the established EH and PS system. The Secrecy Rate was improved by 50.5% in the AF scheme and by 44.2% in the DF scheme between the relay and eavesdropper at 40 m apart for the proposed system in EH and PS. This simulation was performed using the Monto Carlo method in MATLAB.


Sign in / Sign up

Export Citation Format

Share Document