scholarly journals Improving the Performance of Multi-GNSS (Global Navigation Satellite System) Ambiguity Fixing for Airborne Kinematic Positioning over Antarctica

2019 ◽  
Vol 11 (8) ◽  
pp. 992
Author(s):  
Li ◽  
Xu ◽  
Flechtner ◽  
Förste ◽  
Lu ◽  
...  
Keyword(s):  
Global Navigation Satellite System ◽  
Satellite System ◽  
Integer Ambiguity ◽  
Navigation Satellite ◽  
Satellite Clock ◽  
Kinematic Positioning ◽  
Ambiguity Fixing ◽  
Global Navigation ◽  
Global Navigation Satellite ◽  
Orbit Errors

Conventional relative kinematic positioning is difficult to be applied in the polar region of Earth since there is a very sparse distribution of reference stations, while precise point positioning (PPP), using data of a stand-alone receiver, is recognized as a promising tool for obtaining reliable and accurate trajectories of moving platforms. However, PPP and its integer ambiguity fixing performance could be much degraded by satellite orbits and clocks of poor quality, such as those of the geostationary Earth orbit (GEO) satellites of the BeiDou navigation satellite system (BDS), because temporal variation of orbit errors cannot be fully absorbed by ambiguities. To overcome such problems, a network-based processing, referred to as precise orbit positioning (POP), in which the satellite clock offsets are estimated with fixed precise orbits, is implemented in this study. The POP approach is validated in comparison with PPP in terms of integer ambiguity fixing and trajectory accuracy. In a simulation test, multi-GNSS (global navigation satellite system) observations over 14 days from 136 globally distributed MGEX (the multi-GNSS Experiment) receivers are used and four of them on the coast of Antarctica are processed in kinematic mode as moving stations. The results show that POP can improve the ambiguity fixing of all system combinations and significant improvement is found in the solution with BDS, since its large orbit errors are reduced in an integrated adjustment with satellite clock offsets. The four-system GPS+GLONASS+Galileo+BDS (GREC) fixed solution enables the highest 3D position accuracy of about 3.0 cm compared to 4.3 cm of the GPS-only solution. Through a real flight experiment over Antarctica, it is also confirmed that POP ambiguity fixing performs better and thus can considerably speed up (re-)convergence and reduce most of the fluctuations in PPP solutions, since the continuous tracking time is short compared to that in other regions.

scholarly journals Refining GPS/GLONASS Satellite Clock Offset Estimation in the Presence of Pseudo-Range Inter-Channel Biases

2020 ◽  
Vol 12 (11) ◽  
pp. 1821
Author(s):  
Qingsong Ai ◽  
Yunbin Yuan ◽  
Baocheng Zhang ◽  
Tianhe Xu ◽  
Yongchang Chen
Keyword(s):  
Global Navigation Satellite System ◽  
Satellite System ◽  
Navigation Satellite ◽  
Satellite Clock ◽  
Gps Satellites ◽  
Glonass Satellite ◽  
Global Navigation ◽  
Clock Estimation ◽  
Global Navigation Satellite ◽  
Clock Offset

Because of the frequency division multiple access (FDMA) technique, Russian global navigation satellite system (GLONASS) observations suffer from pseudo-range inter-channel biases (ICBs), which adversely affect satellite clock offset estimation. In this study, the GLONASS pseudo-range ICB is treated in four different ways: as ignorable parameters (ICB-NONE), polynomial functions of frequency (ICB-FPOL), frequency-specific parameters (ICB-RF), and satellite-specific parameters (ICB-RS). Data from 110 international global navigation satellite system (GNSS) service stations were chosen to obtain the ICBs and were used for satellite clock offset estimation. The ICBs from the different schemes varied from −20 ns to 80 ns. The ICB-RS model yielded the best results, improving the clock offset accuracy from 300 ps to about 100 ps; it could improve the GLONASS precise point positioning (PPP) accuracy and the converging time by approximately 50% and 30%, respectively. Along similar lines, we introduced the GPS-ICB parameters in the process of GPS satellite clock estimation and GPS/GLONASS PPP, as ICBs may exist for GPS because of different chip shape distortions among GPS satellites. This possibility was found to be the case. Further, the GPS-ICB magnitude ranged from −2 ns to 2 ns, and the estimated satellite clock offsets could improve the accuracy of the GPS and combined GPS/GLONASS PPP by 10%; it also accelerated the converging time by more than 15% thanks to the GPS-ICB calibration.

Refinement of GLONASS Phase Inter-Frequency Biases and Their Applications on Single-Epoch Ambiguity Fixing

2019 ◽  
Vol 73 (3) ◽  
pp. 530-546
Author(s):  
Yumiao Tian
Keyword(s):  
Global Navigation Satellite System ◽  
Particle Filtering ◽  
Satellite System ◽  
Navigation Satellite ◽  
Empirical Success ◽  
Ambiguity Fixing ◽  
Global Navigation ◽  
Value Sets ◽  
Single Epoch ◽  
Global Navigation Satellite

Carrier-phase inter-frequency bias (IFB) exists in GLObal NAvigation Satellite System (GLONASS) baselines when receivers of different brands are used. Those biases need to be calibrated in GLONASS data processing to derive precise fixed solutions. Consequently, the accuracy of the IFB calibration affects ambiguity fixing, and low-accuracy IFB values in the calibration will degrade the positioning results. Hitherto, at least two IFB rate value sets for various receiver brands have been given in previous studies. Some of the differences between the value sets exceed 2 mm/FN (frequency number) and the effects of those differences on ambiguity fixing have not been investigated until now. This study showed that ambiguity fixing in GLONASS single-epoch positioning is very sensitive to the accuracy of the IFB rates. Even errors of millimetres can seriously lower the empirical success rate. The short baselines from the Global Navigation Satellite System (GNSS, which includes Russian GLONASS) networks of the International GNSS Service and the Regional Reference Frame Sub-Commission for Europe were employed to obtain more accurate IFB rate estimates with the proposed two-dimensional particle filtering. Afterwards, the IFB estimates were statistically refined by the least-squares method. Experiments showed that when the refined IFB rates were used in the IFB calibration, the empirical success rates of ambiguity fixing in GLONASS single-epoch positioning were largely improved compared with the values given before, improvements such as 20·6% for a Septentrio and Leica receiver combination.

scholarly journals OutFin, a multi-device and multi-modal dataset for outdoor localization based on the fingerprinting approach

2021 ◽  
Vol 8 (1) ◽  
Author(s):  
Fahad Alhomayani ◽  
Mohammad H. Mahoor
Keyword(s):  
Global Navigation Satellite System ◽  
Urban Areas ◽  
Satellite System ◽  
Reference Points ◽  
Navigation Satellite ◽  
Data Types ◽  
Entry Barrier ◽  
Promising Alternative ◽  
Global Navigation ◽  
Global Navigation Satellite

AbstractIn recent years, fingerprint-based positioning has gained researchers’ attention since it is a promising alternative to the Global Navigation Satellite System and cellular network-based localization in urban areas. Despite this, the lack of publicly available datasets that researchers can use to develop, evaluate, and compare fingerprint-based positioning solutions constitutes a high entry barrier for studies. As an effort to overcome this barrier and foster new research efforts, this paper presents OutFin, a novel dataset of outdoor location fingerprints that were collected using two different smartphones. OutFin is comprised of diverse data types such as WiFi, Bluetooth, and cellular signal strengths, in addition to measurements from various sensors including the magnetometer, accelerometer, gyroscope, barometer, and ambient light sensor. The collection area spanned four dispersed sites with a total of 122 reference points. Each site is different in terms of its visibility to the Global Navigation Satellite System and reference points’ number, arrangement, and spacing. Before OutFin was made available to the public, several experiments were conducted to validate its technical quality.

Implementation of a Dual-Frequency GLONASS and GPS L1 C/A Software Receiver

2010 ◽  
Vol 63 (2) ◽  
pp. 269-287 ◽  
Author(s):  
S. Abbasian Nik ◽  
M. G. Petovello
Keyword(s):  
Global Navigation Satellite System ◽  
Critical Role ◽  
Satellite System ◽  
Navigation Satellite ◽  
Dual Frequency ◽  
Software Receiver ◽  
The Public ◽  
Global Navigation ◽  
Global Navigation Satellite

These days, Global Navigation Satellite System (GNSS) technology plays a critical role in positioning and navigation applications. Use of GNSS is becoming more of a need to the public. Therefore, much effort is needed to make the civilian part of the system more accurate, reliable and available, especially for the safety-of-life purposes. With the recent revitalization of Russian Global Navigation Satellite System (GLONASS), with a constellation of 20 satellites in August 2009 and the promise of 24 satellites by 2010, it is worthwhile concentrating on the GLONASS system as a method of GPS augmentation to achieve more reliable and accurate navigation solutions.

scholarly journals Computation Approach for Quantitative Dielectric Constant from Time Sequential Data Observed by CYGNSS Satellites

2021 ◽  
Vol 13 (11) ◽  
pp. 2032
Author(s):  
Junchan Lee ◽  
Sunil Bisnath ◽  
Regina S.K. Lee ◽  
Narin Gavili Kilane
Keyword(s):  
Dielectric Constant ◽  
Soil Moisture ◽  
Global Navigation Satellite System ◽  
Measurement Data ◽  
Satellite System ◽  
Computation Method ◽  
Navigation Satellite ◽  
Local Soil ◽  
Global Navigation ◽  
Global Navigation Satellite

This paper describes a computation method for obtaining dielectric constant using Global Navigation Satellite System reflectometry (GNSS-R) products. Dielectric constant is a crucial component in the soil moisture retrieval process using reflected GNSS signals. The reflectivity for circular polarized signals is combined with the dielectric constant equation that is used for radiometer observations. Data from the Cyclone Global Navigation Satellite System (CYGNSS) mission, an eight-nanosatellite constellation for GNSS-R, are used for computing dielectric constant. Data from the Soil Moisture Active Passive (SMAP) mission are used to measure the soil moisture through its radiometer, and they are considered as a reference to confirm the accuracy of the new dielectric constant calculation method. The analyzed locations have been chosen that correspond to sites used for the calibration and validation of the SMAP soil moisture product using in-situ measurement data. The retrieved results, especially in the case of a specular point around Yanco, Australia, show that the estimated results track closely to the soil moisture results, and the Root Mean Square Error (RMSE) in the estimated dielectric constant is approximately 5.73. Similar results can be obtained when the specular point is located near the Texas Soil Moisture Network (TxSON), USA. These results indicate that the analysis procedure is well-defined, and it lays the foundation for obtaining quantitative soil moisture content using the GNSS reflectometry results. Future work will include applying the computation product to determine the characteristics that will allow for the separation of coherent and incoherent signals in delay Doppler maps, as well as to develop local soil moisture models.

Sign in / Sign up

Export Citation Format

Share Document