scholarly journals Water-Gas Two-Phase Flow Behavior of Multi-Fractured Horizontal Wells in Shale Gas Reservoirs

Processes ◽  
2019 ◽  
Vol 7 (10) ◽  
pp. 664 ◽  
Author(s):  
Lei Li ◽  
Guanglong Sheng ◽  
Yuliang Su

Hydraulic fracturing is a necessary method to develop shale gas reservoirs effectively and economically. However, the flow behavior in multi-porosity fractured reservoirs is difficult to characterize by conventional methods. In this paper, combined with apparent porosity/permeability model of organic matter, inorganic matter and induced fractures, considering the water film in unstimulated reservoir volume (USRV) region water and bulk water in effectively stimulated reservoir volume (ESRV) region, a multi-media water-gas two-phase flow model was established. The finite difference is used to solve the model and the water-gas two-phase flow behavior of multi-fractured horizontal wells is obtained. Mass transfer between different-scale media, the effects of pore pressure on reservoirs and fluid properties at different production stages were considered in this model. The influence of the dynamic reservoir physical parameters on flow behavior and gas production in multi-fractured horizontal wells is studied. The results show that the properties of the total organic content (TOC) and the inherent porosity of the organic matter affect gas production after 40 days. With the gradual increase of production time, the gas production rate decreases rapidly compared with the water production rate, and the gas saturation in the inorganic matter of the ESRV region gradually decreases. The ignorance of stress sensitivity would cause the gas production increase, and the ignorance of organic matter shrinkage decrease the gas production gradually. The water film mainly affects gas production after 100 days, while the bulk water has a greater impact on gas production throughout the whole period. The research provides a new method to accurately describe the two-phase fluid flow behavior in different scale media of fractured shale gas reservoirs.

SPE Journal ◽  
2014 ◽  
Vol 19 (05) ◽  
pp. 793-802 ◽  
Author(s):  
Qihua Wu ◽  
Baojun Bai ◽  
Yinfa Ma ◽  
Jeong Tae Ok ◽  
Keith B. Neeves ◽  
...  

Summary Gas in tight sand and shale exists in underground reservoirs with microdarcy (µd) or even nanodarcy (nd) permeability ranges; these reservoirs are characterized by small pore throats and crack-like interconnections between pores. The size of the pore throats in shale may differ from the size of the saturating-fluid molecules by only slightly more than one order of magnitude. The physics of fluid flow in these rocks, with measured permeability in the nanodarcy range, is poorly understood. Knowing the fluid-flow behavior in the nanorange channels is of major importance for stimulation design, gas-production optimization, and calculations of the relative permeability of gas in tight shale-gas systems. In this work, a laboratory-on-chip approach for direct visualization of the fluid-flow behavior in nanochannels was developed with an advanced epi-fluorescence microscopy method combined with a nanofluidic chip. Displacements of two-phase flow in 100-nm-depth slit-like channels were reported. Specifically, the two-phase gas-slip effect was investigated. Under experimental conditions, the gas-slippage factor increased as the water saturation increased. The two-phase flow mechanism in 1D nanoscale slit-like channels was proposed and proved by the flow-pattern images. The results are crucial for permeability measurement and understanding fluid-flow behavior for unconventional shale-gas systems with nanoscale pores.


Geofluids ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-13
Author(s):  
Jun Li ◽  
Yuetian Liu ◽  
Kecong Ma

Hydraulic fracturing is a key technology in unconventional reservoir production, yet many simulators only consider the single-phase flow of shale gas, ignoring the two-phase flow process caused by the retained fracturing fluid in the early stage of production. In this study, a three-dimensional fluid–gas–solid coupling reservoir model is proposed, and the governing equations which involve the early injection water phenomenon and stress-sensitive characteristics of shale gas reservoirs are established. The finite element–finite difference method was used for discretisation of stress and strain equations and the equations of flow balances. Further, a sensitivity analysis was conducted to analyse fracture deformation changes in the production. Fracture characteristics under different rock mechanics coefficients were simulated, and the influence of rock mechanics parameters on productivity was further characterised. The stimulated reservoir volume zone permeability could determine the retrofitting effect, the permeability increased from 0.02 to 0.1 mD, and cumulative gas production increased from 18.08 to 26.42 million m3, thus showing an increase of 8.34 million m3, or 46%. The effect of Young’s modulus on the yield was smaller than Poisson’s ratio and the width and length of the fractures. Production was most sensitive to the length of the fractures. The length of the fracture increased from 200 to 400 m, and the cumulative gas production increased from 26.44 to 38.34 million m3, showing an increase of 11.9 million m3, or 45%. This study deepens the understanding of the production process of shale gas reservoirs and has significance for the fluid–gas–solid coupling of shale gas reservoirs.


ACS Omega ◽  
2020 ◽  
Vol 5 (41) ◽  
pp. 26955-26955
Author(s):  
Hongwen Luo ◽  
Beibei Jiang ◽  
Haitao Li ◽  
Ying Li ◽  
Zhangxin Chen

Sign in / Sign up

Export Citation Format

Share Document