scholarly journals Synthesis of Nitrogen-Rich Polymers by Click Polymerization Reaction and Gas Sorption Property

Molecules ◽  
2018 ◽  
Vol 23 (7) ◽  
pp. 1732 ◽  
Author(s):  
Jing-Ru Song ◽  
Wen-Gui Duan ◽  
Dian-Peng Li
Keyword(s):  
Surface Area ◽  
Sorption Property ◽  
Sorption Isotherms ◽  
Magic Angle Spinning ◽  
Polymerization Reaction ◽  
Magic Angle ◽  
Gas Sorption ◽  
Click Polymerization ◽  
Sorption Ability ◽  
Angle Spinning

Microporous organic polymers (MOPs) are promising materials for gas sorption because of their intrinsic and permanent porosity, designable framework, and low density. The introduction of nitrogen-rich building block in MOPs will greatly enhance the gas sorption capacity. Here, we report the synthesis of MOPs from the 2,4,6-tris(4-ethynylphenyl)-1,3,5-triazine unit and aromatic azides linkers by click polymerization reaction. Fourier transform infrared (FTIR) and solid-state 13C CP-MAS (Cross Polarization-Magic Angle Spinning) NMR confirm the formation of the polymers. CMOP-1 and CMOP-2 exhibit microporous networks with a BET (Brunauer–Emmett–Teller) surface area of 431 m2·g−1 and 406 m2·g−1 and a narrow pore size distribution under 1.2 nm. Gas sorption isotherms including CO2 and H2 were measured. CMOP-1 stores a superior CO2 level of 1.85 mmol·g−1 at 273 K/1.0 bar, and an H2 uptake of up to 2.94 mmol·g−1 at 77 K/1.0 bar, while CMOP-2, with its smaller surface area, shows a lower CO2 adsorption capacity of 1.64 mmol·g−1 and an H2 uptake of 2.48 mmol·g−1. In addition, I2 vapor adsorption was tested at 353 K. CMOP-1 shows a higher gravimetric load of 160 wt%. Despite the moderate surface area, the CMOPs display excellent sorption ability for CO2 and I2 due to the nitrogen-rich content in the polymers.

scholarly journals Synthesis of nitrogen-rich polymers by click polymerization reaction and gas sorption property

2018 ◽  
Author(s):  
Jingru Song ◽  
Wengui Duan ◽  
Dianpeng Li
Keyword(s):  
Surface Area ◽  
Sorption Property ◽  
Sorption Isotherms ◽  
Polymerization Reaction ◽  
Bet Surface Area ◽  
Gas Sorption ◽  
Click Polymerization ◽  
Sorption Ability ◽  
Microporous Organic Polymers ◽  
Co2 Adsorption Capacity

Microporous organic polymers (MOPs) are promising materials for gas sorption because of the intrinsic and permanent porosity, designable framework and low density. The introduction of nitrogen-rich building block in MOPs will greatly enhance the gas sorption capacity. Here, we report the synthesis of MOPs from the 2,4,6-tris(4-ethynylphenyl)-1,3,5-triazine unit and aromatic azides linkers via click polymerization reaction. FTIR and solid state 13C CP-MAS NMR confirm the formation of the polymers. CMOP-1 and CMOP-2 exhibit microporous networks with BET surface area of 431 and 406 m2 g-1 and narrow pore size distribution under 1.2 nm. Gas sorption isotherms including CO2 and H2 were measured. CMOP-1 stores superior CO2 level of 8.2 wt% (1.88 mmol g-1) at 273 K/1.0 bar and H2 uptake up to 0.6 wt% at 77 K/1.0 bar, while CMOP-2 with smaller surface area shows lower CO2 adsorption capacity of 7.3 wt% (1.66 mmol g-1) and H2 uptake (0.5 wt%). In addition, I2 vapor adsorption was tested at 353 K. CMOP-1 shows higher gravimetric load of 160 wt%. Despite of the moderate surface area, the CMOPs display excellent sorption ability for CO2 and I2 due to the nitrogen-rich content in the polymers.

Cross polarisation/magic angle spinning 13C-NMR spectroscopic studies of cellulose structural changes in hardwood dissolving pulp process

Holzforschung ◽  
2007 ◽  
Vol 61 (6) ◽  
pp. 675-679 ◽  
Author(s):  
Xolani Nocanda ◽  
Per Tomas Larsson ◽  
Andrew Spark ◽  
Tamara Bush ◽  
Ann Olsson ◽  
...  
Keyword(s):  
Surface Area ◽  
Structural Changes ◽  
Magic Angle Spinning ◽  
Dissolving Pulp ◽  
Magic Angle ◽  
Cellulose Fibril ◽  
Dissolving Pulps ◽  
Angle Spinning ◽  
Fibril Aggregates ◽  
Pulp Process

Abstract Cross polarisation/magic angle spinning 13C NMR spectroscopy has been used to study structural changes in cellulose induced by the dissolving pulp process. The cellulose structure in several dissolving pulps was investigated for commercial and laboratory cooked Eucalyptus 92α and 96α. The average lateral dimension, or average thickness, of the cellulose fibril aggregates is related to the amount of surface area exposed and could be one controlling factor for the chemical reactivity of commercial dissolving pulps during modification reactions. The thickness of the cellulose fibril aggregates governs the amount of surface area present in the fibre wall, and cellulose surface material constitutes the part of the cellulose that is directly accessible to reagents. In all sample series investigated, the raw pulp was found to be less aggregated than the corresponding bleached final pulp. Furthermore, an irreversible increase in fibril aggregate width was observed on free drying for both laboratory cooked and commercial pulps. Upon rewetting with water, the freely dried 96α pulp was found to be more aggregated than the freely dried 92α pulp, although sugar analysis showed very similar carbohydrate compositions. As indicated by the molecular mass distribution, the commercial 92α pulp contained larger amounts of degraded cellulose; this may be a plausible explanation for the different behaviour of the 92α and 96α pulps during free drying.

Pulse Shaped Dynamic Nuclear Polarization Under Magic Angle Spinning

2019 ◽  
Author(s):  
ASIF EQUBAL ◽  
Kan Tagami ◽  
Songi Han
Keyword(s):  
Electron Spin ◽  
Lattice Relaxation ◽  
Magic Angle Spinning ◽  
Spin Lattice Relaxation ◽  
Magic Angle ◽  
Total Electron ◽  
Spin Lattice ◽  
Maximum Benefit ◽  
Selective Saturation ◽  
Angle Spinning

In this paper, we report on an entirely novel way of improving the MAS-DNP efficiency by shaped μw pulse train irradiation for fast and broad-banded (FAB) saturation of the electron spin resonance. FAB-DNP achieved with Arbitrary Wave Generated shaped μw pulse trains facilitates effective and selective saturation of a defined fraction of the total electron spins, and provides superior control over the DNP efficiency under MAS. Experimental and quantum-mechanics based numerically simulated results together demonstrate that FAB-DNP significantly outperforms CW-DNP when the EPR-line of PAs is broadened by conformational distribution and exchange coupling. We demonstrate that the maximum benefit of FAB DNP is achieved when the electron spin-lattice relaxation is fast relative to the MAS frequency, i.e. at higher temperatures and/or when employing metals as PAs. Calculations predict that under short T<sub>1e </sub>conditions AWG-DNP can achieve as much as ~4-fold greater enhancement compared to CW-DNP.

High Resolution Magic Angle Spinning NMR in Combinatorial Chemistry

2001 ◽  
Vol 4 (4) ◽  
pp. 333-351 ◽  
Author(s):  
G. Lippens ◽  
R. Warrass ◽  
J. Wieruszeski ◽  
P. Rousselot-Pailley ◽  
G. Chessari
Keyword(s):  
High Resolution ◽  
Combinatorial Chemistry ◽  
Magic Angle Spinning ◽  
Magic Angle ◽  
Angle Spinning

Wideline 2H -NMR Spectroscopy and Imaging of Solids

1994 ◽  
Vol 49 (1-2) ◽  
pp. 19-26 ◽  
Author(s):  
B. Blümich
Keyword(s):  
Nmr Spectroscopy ◽  
Excitation Power ◽  
Magic Angle Spinning ◽  
Magic Angle ◽  
2H Nmr ◽  
Stochastic Excitation ◽  
2H Nmr Spectroscopy ◽  
Spatially Inhomogeneous ◽  
Recent Developments ◽  
Angle Spinning

Abstract Recent developments, focussing on reduction of the rf excitation power by stochastic excitation, on improvements in sensitivity and excitation bandwidth by magic angle spinning, and on combining wideline spectroscopy with spatial resolution for investigations o f spatially inhomogeneous objects are reviewed.

scholarly journals Preparation of Li3PS4–Li3PO4 Solid Electrolytes by Liquid-Phase Shaking for All-Solid-State Batteries

2021 ◽  
Vol 2 (1) ◽  
pp. 39-48
Author(s):  
Nguyen H. H. Phuc ◽  
Takaki Maeda ◽  
Tokoharu Yamamoto ◽  
Hiroyuki Muto ◽  
Atsunori Matsuda
Keyword(s):  
Solid Solution ◽  
Solid State ◽  
Liquid Phase ◽  
Room Temperature ◽  
Reaction Medium ◽  
Magic Angle Spinning ◽  
Resonance Spectroscopy ◽  
Synthesis Methods ◽  
Magic Angle ◽  
Angle Spinning

A solid solution of a 100Li3PS4·xLi3PO4 solid electrolyte was easily prepared by liquid-phase synthesis. Instead of the conventional solid-state synthesis methods, ethyl propionate was used as the reaction medium. The initial stage of the reaction among Li2S, P2S5 and Li3PO4 was proved by ultraviolet-visible spectroscopy. The powder X-ray diffraction (XRD) results showed that the solid solution was formed up to x = 6. At x = 20, XRD peaks of Li3PO4 were detected in the prepared sample after heat treatment at 170 °C. However, the samples obtained at room temperature showed no evidence of Li3PO4 remaining for x = 20. Solid phosphorus-31 magic angle spinning nuclear magnetic resonance spectroscopy results proved the formation of a POS33− unit in the sample with x = 6. Improvements of ionic conductivity at room temperature and activation energy were obtained with the formation of the solid solution. The sample with x = 6 exhibited a better stability against Li metal than that with x = 0. The all-solid-state half-cell employing the sample with x = 6 at the positive electrode exhibited a better charge–discharge capacity than that employing the sample with x = 0.

Sign in / Sign up

Export Citation Format

Share Document