scholarly journals Interpretation of Hydrophobization Behavior of Dodecylamine on Muscovite and Talc Surface through Dynamic Wettability and AFM Analysis

Minerals ◽  
2018 ◽  
Vol 8 (9) ◽  
pp. 391 ◽  
Author(s):  
Hao Jiang ◽  
Ya Gao ◽  
Sultan Khoso ◽  
Wanying Ji ◽  
Yuehua Hu
Keyword(s):  
Dynamic Contact Angle ◽  
Dynamic Contact ◽  
Contact Angles ◽  
Interaction Forces ◽  
Force Microscopy ◽  
Adsorbed Amount ◽  
Atomic Force ◽  
Imaging Results ◽  
Afm Imaging ◽  
Afm Analysis

In this study, a new approach, “dynamic wettability”, and atomic force microscopy (AFM) imaging analysis techniques were successfully used to characterize the hydrophobization mechanism of the collector dodecylamine (DDA) on muscovite and talc surfaces. The attachment of bubbles to the minerals was studied through the dynamic contact angle to gain a detailed understanding of the hydrophobization mechanism of DDA on a muscovite and talc surface. AFM imaging and interaction forces were performed to explain the DDA adsorption mechanism on both minerals. Finally, flotation tests were performed to verify the effectiveness of these techniques. After treatments with DDA, the contact angles became much larger compared to initial angles, particularly for muscovite, and the attachment of bubbles on the talc surface was much easier than muscovite due to its natural hydrophobicity. From AFM imaging, both the muscovite and talc showed a similar tendency; the higher the DDA concentration, the more the adsorbed amount. However, the adsorbed amount of DDA on talc surface was obviously more than that on muscovite. As far as interaction forces are concerned, the maximum attractions occurred at certain different concentrations respectively for muscovite and talc and agreed well with the AFM-imaging results. Moreover, results obtained from flotation tests were promising and quite in agreement with the phenomenon of these techniques.

Chemical Functionalization of Water-etched Si(100)

2009 ◽  
Vol 1228 ◽  
Author(s):  
Carmen Say ◽  
Kate T. Queeney
Keyword(s):  
Hydrofluoric Acid ◽  
Room Temperature ◽  
Dynamic Contact Angle ◽  
Dynamic Contact ◽  
Silicon Hydride ◽  
Ambient Conditions ◽  
Organic Layers ◽  
Force Microscopy ◽  
Atomic Force ◽  
Nanoscale Topography

AbstractEtching of hydrogen-terminated Si(100) in deoxygenated water produces surfaces with a regular nanoscale topography. Surface infrared spectroscopy provides detailed information about this topography via interrogation of the silicon hydride species that populate this highly ordered surface. Here we investigate the feasibility of using siloxane chemistry to functionalize this surface while preserving the initial topography. The critical step in silanization to form high-quality organic layers is oxidative cleaning of the surface. By re-etching oxidized surfaces in hydrofluoric acid, we can repopulate surface hydride species and examine any apparent changes in topography that resulted from the oxidation step. We compare three different oxidation protocols and find that an SC-2 clean results in the least perturbation of the original topography. Preliminary results using both dynamic contact angle and atomic force microscopy suggest that the SC-2 oxidized surface can be functionalized with alkylsilane reagents to create a functionalized surface with regular, nanoscale topography, with all surface processing carried out under ambient conditions at or near room temperature.

scholarly journals Dynamic Contact Angle Analysis of Protein Adsorption on Polysaccharide Multilayer’s Films for Biomaterial Reendothelialization

2014 ◽  
Vol 2014 ◽  
pp. 1-10 ◽  
Author(s):  
Safiya Benni ◽  
Thierry Avramoglou ◽  
Hanna Hlawaty ◽  
Laurence Mora
Keyword(s):  
Contact Angle ◽  
Endothelial Cell ◽  
Protein Adsorption ◽  
Dynamic Contact Angle ◽  
Dynamic Contact ◽  
Force Microscopy ◽  
Atomic Force ◽  
Endothelial Cell Response ◽  
Adsorption Desorption ◽  
Contact Angle Analysis

Atherosclerosis is a major cardiovascular disease. One of the side effects is restenosis. The aim of this work was to study the coating of stents by dextran derivates based polyelectrolyte’s multilayer (PEM) films in order to increase endothelialization of injured arterial wall after stent implantation. Films were composed with diethylaminoethyl dextran (DEAE) as polycation and dextran sulphate (DS) as polyanion. One film was composed with 4 bilayers of (DEAE-DS)4and was labeled D−. The other film was the same as D− but with an added terminal layer of DEAE polycation: (DEAE-DS)4-DEAE (labeled D+). The dynamic adsorption/desorption of proteins on the films were characterized by dynamic contact angle (DCA) and atomic force microscopy (AFM). Human endothelial cell (HUVEC) adhesion and proliferation were quantified and correlated to protein adsorption analyzed by DCA for fibronectin, vitronectin, and bovine serum albumin (BSA). Our results showed that the endothelial cell response was optimal for films composed of DS as external layer. Fibronectin was found to be the only protein to exhibit a reversible change in conformation after desorption test. This behavior was only observed for (DEAE-DS)4films. (DEAE-DS)4films could enhance HUVEC proliferation in agreement with fibronectin ability to easily change from conformation.

Brittle Behaviour in Aspirin Crystals: Evidence of Spalling Fracture

2020 ◽  
Author(s):  
Benjamin P. A. Gabriele ◽  
Craig J. Williams ◽  
Douglas Stauffer ◽  
Brian Derby ◽  
Aurora J. Cruz-Cabeza
Keyword(s):  
Surface Roughness ◽  
Atomic Force Microscopy ◽  
Single Crystals ◽  
Spalling Fracture ◽  
Force Microscopy ◽  
Atomic Force ◽  
Afm Imaging

<div> <div> <div> <p>Single crystals of aspirin form I were cleaved and indented on their dominant face. Upon inspection, it was possible to observe strongly anisotropic shallow lateral cracks due to the extreme low surface roughness after cleavage. Atomic Force Microscopy (AFM) imaging showed spalling fractures nucleating from the indent corners, forming terraces with a height of one or two interplanar spacings d100. The formation of such spalling fractures in aspirin was rationalised using basic calculations of attachment energies, showing how (100) layers are poorly bonded when compared to their relatively higher intralayer bonding. An attempt at explaining the preferential propagation of these fractures along the [010] direction is discussed. </p> </div> </div> </div>

Brittle Behaviour in Aspirin Crystals: Evidence of Spalling Fracture

2020 ◽  
Author(s):  
Benjamin P. A. Gabriele ◽  
Craig J. Williams ◽  
Douglas Stauffer ◽  
Brian Derby ◽  
Aurora J. Cruz-Cabeza
Keyword(s):  
Surface Roughness ◽  
Atomic Force Microscopy ◽  
Single Crystals ◽  
Spalling Fracture ◽  
Force Microscopy ◽  
Atomic Force ◽  
Afm Imaging

<div> <div> <div> <p>Single crystals of aspirin form I were cleaved and indented on their dominant face. Upon inspection, it was possible to observe strongly anisotropic shallow lateral cracks due to the extreme low surface roughness after cleavage. Atomic Force Microscopy (AFM) imaging showed spalling fractures nucleating from the indent corners, forming terraces with a height of one or two interplanar spacings d100. The formation of such spalling fractures in aspirin was rationalised using basic calculations of attachment energies, showing how (100) layers are poorly bonded when compared to their relatively higher intralayer bonding. An attempt at explaining the preferential propagation of these fractures along the [010] direction is discussed. </p> </div> </div> </div>

scholarly journals Atomic force microscopy analysis of native infectious and inactivated SARS-CoV-2 virions

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Sébastien Lyonnais ◽  
Mathilde Hénaut ◽  
Aymeric Neyret ◽  
Peggy Merida ◽  
Chantal Cazevieille ◽  
...  
Keyword(s):  
Atomic Force Microscopy ◽  
Native Conformation ◽  
Force Microscopy ◽  
Enveloped Virus ◽  
Atomic Force ◽  
Afm Imaging ◽  
Level 3 ◽  
Microscopy Analysis ◽  
Virus Morphology ◽  
Nanoscale Level

AbstractSARS-CoV-2 is an enveloped virus responsible for the Coronavirus Disease 2019 (COVID-19) pandemic. Here, single viruses were analyzed by atomic force microscopy (AFM) operating directly in a level 3 biosafety (BSL3) facility, which appeared as a fast and powerful method to assess at the nanoscale level and in 3D infectious virus morphology in its native conformation, or upon inactivation treatments. AFM imaging reveals structurally intact infectious and inactivated SARS-CoV-2 upon low concentration of formaldehyde treatment. This protocol combining AFM and plaque assays allows the preparation of intact inactivated SARS-CoV-2 particles for safe use of samples out of level 3 laboratory to accelerate researches against the COVID-19 pandemic. Overall, we illustrate how adapted BSL3-AFM is a remarkable toolbox for rapid and direct virus analysis based on nanoscale morphology.

Atomic force microscopy (AFM) imaging suggests that stromal interaction molecule 1 (STIM1) binds to Orai1 with sixfold symmetry

FEBS Letters ◽  
2014 ◽  
Vol 588 (17) ◽  
pp. 2874-2880 ◽  
Author(s):  
Dilshan Balasuriya ◽  
Shyam Srivats ◽  
Ruth D. Murrell-Lagnado ◽  
J. Michael Edwardson
Keyword(s):  
Atomic Force Microscopy ◽  
Force Microscopy ◽  
Stromal Interaction Molecule 1 ◽  
Atomic Force ◽  
Afm Imaging ◽  
Sixfold Symmetry

scholarly journals Back to Nature: Combating Candida albicans Biofilm, Phospholipase and Hemolysin Using Plant Essential Oils

Antibiotics ◽  
2021 ◽  
Vol 10 (1) ◽  
pp. 81
Author(s):  
Ahmed M. El-Baz ◽  
Rasha A. Mosbah ◽  
Reham M. Goda ◽  
Basem Mansour ◽  
Taranum Sultana ◽  
...  
Keyword(s):  
Candida Albicans ◽  
Essential Oils ◽  
Docking Study ◽  
New Drugs ◽  
Molecular Docking Study ◽  
Plant Essential Oils ◽  
Force Microscopy ◽  
Atomic Force ◽  
Afm Analysis ◽  
Phenotypic Methods

Candida albicans is the causative agent of fatal systemic candidiasis. Due to limitations of antifungals, new drugs are needed. The anti-virulence effect of plant essential oils (EOs) was evaluated against clinical C. albicans isolates including cinnamon, clove, jasmine and rosemary oils. Biofilm, phospholipase and hemolysin were assessed phenotypically. EOs were evaluated for their anti-virulence activity using phenotypic methods as well as scanning electron microscopy (SEM) and atomic force microscopy (AFM). Among the C. albicans isolates, biofilm, phospholipase and hemolysins were detected in 40.4, 86.5 and 78.8% of isolates, respectively. Jasmine oil showed the highest anti-biofilm activity followed by cinnamon, clove and rosemary oils. SEM and AFM analysis showed reduced adherence and roughness in the presence of EOs. For phospholipase, rosemary oil was the most inhibitory, followed by jasmine, cinnamon and clove oils, and for hemolysins, cinnamon had the highest inhibition followed by jasmine, rosemary and clove oils. A molecular docking study revealed major EO constituents as promising inhibitors of the Als3 adhesive protein, with the highest binding for eugenol, followed by 1,8-cineole, 2-phenylthiolane and cinnamaldehyde. In conclusion, EOs have a promising inhibitory impact on Candida biofilm, phospholipase and hemolysin production, hence EOs could be used as potential antifungals that impact virulence factors.

Imaging of Xenopus laevis Oocyte Plasma Membrane in Physiological-Like Conditions by Atomic Force Microscopy

2013 ◽  
Vol 19 (5) ◽  
pp. 1358-1363 ◽  
Author(s):  
Massimo Santacroce ◽  
Federica Daniele ◽  
Andrea Cremona ◽  
Diletta Scaccabarozzi ◽  
Michela Castagna ◽  
...  
Keyword(s):  
Atomic Force Microscopy ◽  
Plasma Membrane ◽  
High Resolution ◽  
Membrane Proteins ◽  
Xenopus Laevis ◽  
Functional Study ◽  
Xenopus Laevis Oocyte ◽  
Force Microscopy ◽  
Atomic Force ◽  
Afm Imaging

AbstractXenopus laevis oocytes are an interesting model for the study of many developmental mechanisms because of their dimensions and the ease with which they can be manipulated. In addition, they are widely employed systems for the expression and functional study of heterologous proteins, which can be expressed with high efficiency on their plasma membrane. Here we applied atomic force microscopy (AFM) to the study of the plasma membrane of X. laevis oocytes. In particular, we developed and optimized a new sample preparation protocol, based on the purification of plasma membranes by ultracentrifugation on a sucrose gradient, to perform a high-resolution AFM imaging of X. laevis oocyte plasma membrane in physiological-like conditions. Reproducible AFM topographs allowed visualization and dimensional characterization of membrane patches, whose height corresponds to a single lipid bilayer, as well as the presence of nanometer structures embedded in the plasma membrane and identified as native membrane proteins. The described method appears to be an applicable tool for performing high-resolution AFM imaging of X. laevis oocyte plasma membrane in a physiological-like environment, thus opening promising perspectives for studying in situ cloned membrane proteins of relevant biomedical/pharmacological interest expressed in this biological system.

Sign in / Sign up

Export Citation Format

Share Document