scholarly journals Characterization of Al Incorporation into HfO2 Dielectric by Atomic Layer Deposition

Micromachines ◽  
2019 ◽  
Vol 10 (6) ◽  
pp. 361 ◽  
Author(s):  
Md. Mamunur Rahman ◽  
Jun-Gyu Kim ◽  
Dae-Hyun Kim ◽  
Tae-Woo Kim

This study presents the characteristics of HfAlO films for a series of Al incorporation ratios into a HfO2 dielectric by atomic layer deposition on a Si substrate. A small amount of Al doping into the HfO2 film can stabilize the tetragonal phase of the HfO2, which helps to achieve a higher dielectric constant (k) and lower leakage current density, as well as a higher breakdown voltage than HfO2 film on its own. Moreover, assimilation of Al2O3 into HfO2 can reduce the hysteresis width and frequency dispersion. These are indications of border trap reduction, which was also verified by the border trap extraction mechanism. X-ray photoelectron spectroscopy (XPS) analysis also verified the HfAlO microstructural properties for various Al compositions. In addition, higher amounts of Al2O3 in HfAlO resulted in better interface and dielectric behavior through trap minimization, although the equivalent-oxide-thickness (EOT) values show the opposite trend.

2021 ◽  
Vol 1762 (1) ◽  
pp. 012041
Author(s):  
K Buchkov ◽  
A Galluzzi ◽  
B Blagoev ◽  
A Paskaleva ◽  
P Terziyska ◽  
...  

2020 ◽  
Vol 694 ◽  
pp. 137740 ◽  
Author(s):  
Mostafa Afifi Hassan ◽  
Aadil Waseem ◽  
Muhammad Ali Johar ◽  
Sou Young Yu ◽  
June Key Lee ◽  
...  

2011 ◽  
Vol 519 (22) ◽  
pp. 7723-7726 ◽  
Author(s):  
J. Shen ◽  
C.Y. Zhang ◽  
T.T. Xu ◽  
A.N. Jiang ◽  
Z.Y. Zhang ◽  
...  

Coatings ◽  
2018 ◽  
Vol 8 (10) ◽  
pp. 369 ◽  
Author(s):  
Richard Krumpolec ◽  
Tomáš Homola ◽  
David Cameron ◽  
Josef Humlíček ◽  
Ondřej Caha ◽  
...  

Sequentially pulsed chemical vapour deposition was used to successfully deposit thin nanocrystalline films of copper(I) chloride using an atomic layer deposition system in order to investigate their application to UV optoelectronics. The films were deposited at 125 °C using [Bis(trimethylsilyl)acetylene](hexafluoroacetylacetonato)copper(I) as a Cu precursor and pyridine hydrochloride as a new Cl precursor. The films were analysed by XRD, X-ray photoelectron spectroscopy (XPS), SEM, photoluminescence, and spectroscopic reflectance. Capping layers of aluminium oxide were deposited in situ by ALD (atomic layer deposition) to avoid environmental degradation. The film adopted a polycrystalline zinc blende-structure. The main contaminants were found to be organic materials from the precursor. Photoluminescence showed the characteristic free and bound exciton emissions from CuCl and the characteristic exciton absorption peaks could also be detected by reflectance measurements.


Sign in / Sign up

Export Citation Format

Share Document