scholarly journals The Effect of Cold Rolling on the Hydrogen Susceptibility of 5083 Aluminum Alloy

Metals ◽  
2017 ◽  
Vol 7 (11) ◽  
pp. 451 ◽  
Author(s):  
E.P. Georgiou ◽  
J.-P. Celis ◽  
C.N. Panagopoulos
Keyword(s):  
Aluminum Alloy ◽  
Cold Rolling ◽  
5083 Aluminum Alloy

scholarly journals Relationship between corrosion rate of 5083 aluminum alloy in alkaline solution and residual stress induced by cold rolling.

1994 ◽  
Vol 44 (2) ◽  
pp. 81-85
Author(s):  
Shu KURODA ◽  
Kazuaki OKUMURA ◽  
Tadakazu OHNISHI ◽  
Hiroyuki ICHINOSE ◽  
Nobuo KOBAYASHI
Keyword(s):  
Residual Stress ◽  
Aluminum Alloy ◽  
Corrosion Rate ◽  
Cold Rolling ◽  
Alkaline Solution ◽  
5083 Aluminum Alloy

scholarly journals Residual stress in butt welded 5083 aluminum alloy

1970 ◽  
Vol 20 (1) ◽  
pp. 7-13
Author(s):  
Eiji TANAKA ◽  
Katsuhiko HIRATA ◽  
Katsuji TAKEUCHI
Keyword(s):  
Residual Stress ◽  
Aluminum Alloy ◽  
5083 Aluminum Alloy

scholarly journals Texture Evolution and Control of 2524 Aluminum Alloy and Its Effect on Fatigue Crack Propagation Behavior

2021 ◽  
Vol 11 (12) ◽  
pp. 5550
Author(s):  
Yuqiang Chen ◽  
Chuang Xiong ◽  
Wenhui Liu ◽  
Suping Pan ◽  
Yufeng Song ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Aluminum Alloy ◽  
Fatigue Crack ◽  
Cold Rolling ◽  
Texture Evolution ◽  
Cold Deformation ◽  
Solution Treatment ◽  
Second Phase ◽  
Fatigue Crack Growth Resistance ◽  
Volume Fractions

The influences of cold rolling and subsequent heat treatment on the microstructure evolution of 2524 alloy were investigated using an orientation distribution function (ODF) and electron back-scattered diffraction (EBSD). A preparation method of 2524-T3 aluminum alloy with a strong Brass texture was developed, and its effect on the fatigue properties of the alloy was investigated using scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The results show that with the increase in cold rolling deformation from 0% to 80%, the volume fractions of Brass, copper, and S textures in the 2524-T3 alloy also increase, especially in the case of Brass and S textures. However, the volume fractions of cube and Goss textures are reduced significantly, especially for cube textures, which are decreased by 57.4%. Reducing coarse second-phase particles (CSPs) is conducive to the formation of a strong deformation texture during cold rolling. A 10% deformation at each rolling pass, followed by a step annealing, helps the preservation of a Brass texture even after solution treatment at 500 °C for 0.5 h, while a large cold deformation followed by high-temperature annealing helps the formation of a strong cube texture. The Brass texture can enhance the strength while decreasing the fatigue crack growth resistance of this alloy.

Sign in / Sign up

Export Citation Format

Share Document