scholarly journals Gain-Enhanced Metamaterial Absorber-Loaded Monopole Antenna for Reduced Radar Cross-Section and Back Radiation

Materials ◽  
2020 ◽  
Vol 13 (5) ◽  
pp. 1247
Author(s):  
Heijun Jeong ◽  
Yeonju Kim ◽  
Manos M. Tentzeris ◽  
Sungjoon Lim
Keyword(s):  
Cross Section ◽  
Radar Cross Section ◽  
Metamaterial Absorber ◽  
Monopole Antenna ◽  
Magnetic Conductor ◽  
Low Profile ◽  
Before And After ◽  
Unit Cells ◽  
Lumped Elements ◽  
Peak Gain

This paper proposes a gain-enhanced metamaterial (MM) absorber-loaded monopole antenna that reduces both radar cross-section and back radiation. To demonstrate the proposed idea, we designed a wire monopole antenna and an MM absorber. The MM absorber comprised lumped elements of subwavelength unit cells and achieved 90% absorbance bandwidth from 2.42–2.65 GHz. For low-profile configurations, the MM absorber was loaded parallel to and 10 mm from the monopole antenna, corresponding to 0.09 λ0 at 2.7 GHz. The monopole antenna resonated at 2.7 GHz with a 3.71 dBi peak gain and 2.65 GHz and 6.46 dBi peak gain, before and after loading the MM absorber, respectively. Therefore, including the MM absorber increased peak gain by 2.7 dB and reduced back radiation by 15 dB. The proposed antenna radar cross-section was reduced by 2 dB compared with a monopole antenna with an artificial magnetic conductor.

scholarly journals Radar Cross Section Reduction of Low Profile Fabry-Perot Resonator Antenna Using Checker Board Artificial Magnetic Conductor

2018 ◽  
Vol 7 (2) ◽  
pp. 76-82 ◽  
Author(s):  
V. A. Libi Mol ◽  
C. K. Aanandan
Keyword(s):  
Cross Section ◽  
Ground Plane ◽  
Radar Cross Section ◽  
Bottom Surface ◽  
Board Structure ◽  
Magnetic Conductor ◽  
Artificial Magnetic Conductor ◽  
Low Profile ◽  
Fabry Perot ◽  
Checker Board

This paper presents a novel low profile, high gain Fabry-Perot resonator antenna with reduced radar cross section (RCS). An artificial magnetic conductor which provides zero degree reflection phase at resonant frequency is used as the ground plane of the antenna to obtain the low profile behavior. A checker board structure consisting of two artificial magnetic conductor (AMC) surfaces with antiphase reflection property is used as the superstrate to reduce the RCS. The bottom surface of superstrate is perforated to act as partially reflective surface to enhance the directivity of antenna. The antenna has a 3 dB gain bandwidth from 9.32 GHz to 9.77 GHz with a peak gain of 12.95 dBi at 9.6 GHz. The cavity antenna also has reduced reflectivity with a maximum reduction of 14.5 dB at 9.63 GHz.

scholarly journals Low-Cost, Low-Profile Wide-Band Radar Cross Section Reduction Using Dual-Concentric Phase Gradient Modulated Surface

Electronics ◽  
2021 ◽  
Vol 10 (13) ◽  
pp. 1552
Author(s):  
Yousef Azizi ◽  
Mohammad Soleimani ◽  
Seyed Hasan Sedighy ◽  
Ladislau Matekovits
Keyword(s):  
Cross Section ◽  
Low Cost ◽  
Wide Band ◽  
Radar Cross Section ◽  
Phase Gradient ◽  
Full Wave ◽  
Low Profile ◽  
Anomalous Reflection ◽  
Measurement Results ◽  
Unit Cells

Design criteria of low-cost, dual-concentric metasurface possessing wideband phase gradient (PG) are introduced. The radar cross-section reduction (RCSR) is explained by anomalous reflection that characterizes the superficial planar. The geometry consists of two single band RCSR modulated surfaces (MSs) that are triggered in each other. Each MS is built-up of square patch (SP) unit cells configured as a modulation structure to realize PG that causes anomalous reflection and monostatic RCSR behavior. Applying sinusoidal modulation to the sequence of the SP unit cells leads to the formation of PG along the surface and hence the intensity of the reflected wave is reduced for the broadside direction (θr=0∘). The proposed structure fabricated on a 0.8 mm thin FR-4 substrate extends over 249 × 249 mm2. It achieves a wide RCSR bandwidth from 20.9 GHz to 45.7 GHz (i.e., relative bandwidth of 75%) as designed in Dassault Systèmes (CST) Microwave Studio as a full-wave simulator and confirmed by the measurement results.

Integrated Low-Profile Low Radar Cross Section Circularly Polarized Dipole Antenna Array

2021 ◽  
pp. 1-1
Author(s):  
Cheng Jin ◽  
Binchao Zhang ◽  
Liyuan Yin ◽  
Qihao Lv ◽  
Lingwen Kong ◽  
...  
Keyword(s):  
Antenna Array ◽  
Cross Section ◽  
Radar Cross Section ◽  
Dipole Antenna ◽  
Circularly Polarized ◽  
Low Profile

Radar cross-section reduction based on an iterative fast Fourier transform optimized metasurface

2016 ◽  
Vol 30 (18) ◽  
pp. 1650233 ◽  
Author(s):  
Yi-Chuan Song ◽  
Jun Ding ◽  
Chen-Jiang Guo ◽  
Yu-Hui Ren ◽  
Jia-Kai Zhang
Keyword(s):  
Fourier Transform ◽  
Fast Fourier Transform ◽  
Cross Section ◽  
Radar Cross Section ◽  
Simulation Software ◽  
Pattern Synthesis ◽  
Array Pattern ◽  
Unit Cells ◽  
Polarization Insensitive ◽  
Geometry Parameter

A novel polarization insensitive metasurface with over 25 dB monostatic radar cross-section (RCS) reduction is introduced. The proposed metasurface is comprised of carefully arranged unit cells with spatially varied dimension, which enables approximate uniform diffusion of incoming electromagnetic (EM) energy and reduces the threat from bistatic radar system. An iterative fast Fourier transform (FFT) method for conventional antenna array pattern synthesis is innovatively applied to find the best unit cell geometry parameter arrangement. Finally, a metasurface sample is fabricated and tested to validate RCS reduction behavior predicted by full wave simulation software Ansys HFSS[Formula: see text] and marvelous agreement is observed.

Sign in / Sign up

Export Citation Format

Share Document