scholarly journals Different Myosin Head Conformations in Bony Fish Muscles Put into Rigor at Different Sarcomere Lengths

2018 ◽  
Vol 19 (7) ◽  
pp. 2091 ◽  
Author(s):  
Felicity Eakins ◽  
Jeffrey J. Harford ◽  
Carlo Knupp ◽  
Manfred Roessle ◽  
John M. Squire
Keyword(s):  
Sarcomere Length ◽  
Myosin Head ◽  
Bony Fish ◽  
Actin Binding ◽  
X Ray Diffraction ◽  
X Ray ◽  
Fish Muscles ◽  
Cross Bridge ◽  
Butanedione Monoxime ◽  
Tension Generation

At a resting sarcomere length of approximately 2.2 µm bony fish muscles put into rigor in the presence of BDM (2,3-butanedione monoxime) to reduce rigor tension generation show the normal arrangement of myosin head interactions with actin filaments as monitored by low-angle X-ray diffraction. However, if the muscles are put into rigor using the same protocol but stretched to 2.5 µm sarcomere length, a markedly different structure is observed. The X-ray diffraction pattern is not just a weaker version of the pattern at full overlap, as might be expected, but it is quite different. It is compatible with the actin-attached myosin heads being in a different conformation on actin, with the average centre of cross-bridge mass at a higher radius than in normal rigor and the myosin lever arms conforming less to the actin filament geometry, probably pointing back to their origins on their parent myosin filaments. The possible nature of this new rigor cross-bridge conformation is discussed in terms of other well-known states such as the weak binding state and the ‘roll and lock’ mechanism; we speculate that we may have trapped most myosin heads in an early attached strong actin-binding state in the cross-bridge cycle on actin.

The Frank-Starling mechanism is not mediated by changes in rate of cross-bridge detachment

1997 ◽  
Vol 273 (5) ◽  
pp. H2428-H2435 ◽  
Author(s):  
Thomas Wannenburg ◽  
Paul M. L. Janssen ◽  
Dongsheng Fan ◽  
Pieter P. De Tombe
Keyword(s):  
Cardiac Muscle ◽  
Maximum Rate ◽  
Sarcomere Length ◽  
Myosin Head ◽  
Isometric Force ◽  
Force Development ◽  
Cross Bridge ◽  
Average Slope ◽  
The Cross ◽  
Kinetics Of

We tested the hypothesis that the Frank-Starling relationship is mediated by changes in the rate of cross-bridge detachment in cardiac muscle. We simultaneously measured isometric force development and the rate of ATP consumption at various levels of Ca2+ activation in skinned rat cardiac trabecular muscles at three sarcomere lengths (2.0, 2.1, and 2.2 μm). The maximum rate of ATP consumption was 1.5 nmol ⋅ s−1 ⋅ μl fiber vol−1, which represents an estimated adenosinetriphosphatase (ATPase) rate of ∼10 s−1 per myosin head at 24°C. The rate of ATP consumption was tightly and linearly coupled to the level of isometric force development, and changes in sarcomere length had no effect on the slope of the force-ATPase relationships. The average slope of the force-ATPase relationships was 15.5 pmol ⋅ mN−1 ⋅ mm−1. These results suggest that the mechanisms that underlie the Frank-Starling relationship in cardiac muscle do not involve changes in the kinetics of the apparent detachment step in the cross-bridge cycle.

scholarly journals Resting myosin cross-bridge configuration in frog muscle thick filaments.

1986 ◽  
Vol 102 (2) ◽  
pp. 610-618 ◽  
Author(s):  
M Cantino ◽  
J Squire
Keyword(s):  
Myosin Head ◽  
Freeze Fracture ◽  
Optical Diffraction ◽  
Outer Diameter ◽  
X Ray ◽  
Cross Bridge ◽  
Thick Filaments ◽  
Myosin Filaments ◽  
Cross Bridges ◽  
The Right

Clear images of myosin filaments have been seen in shadowed freeze-fracture replicas of single fibers of relaxed frog semitendinosus muscles rapidly frozen using a dual propane jet freezing device. These images have been analyzed by optical diffraction and computer averaging and have been modelled to reveal details of the myosin head configuration on the right-handed, three-stranded helix of cross-bridges. Both the characteristic 430-A and 140-150-A repeats of the myosin cross-bridge array could be seen. The measured filament backbone diameter was 140-160 A, and the outer diameter of the cross-bridge array was 300 A. Evidence is presented that suggests that the observed images are consistent with a model in which both of the heads of one myosin molecule tilt in the same direction at an angle of approximately 50-70 degrees to the normal to the filament long axis and are slewed so that they lie alongside each other and their radially projected density lies along the three right-handed helical tracks. Any perturbation of the myosin heads away from their ideal lattice sites needed to account for x-ray reflections not predicted for a perfect helix must be essentially along the three helical tracks of cross-bridges. Little trace of the presence of non-myosin proteins could be seen.

scholarly journals Cross-bridge conformation as revealed by x-ray diffraction studies on insect flight muscles with ATP analogues

1975 ◽  
Vol 15 (7) ◽  
pp. 687-705 ◽  
Author(s):  
R.S. Goody ◽  
K.C. Holmes ◽  
H.G. Mannherz ◽  
J.B. Leigh ◽  
G. Rosenbaum
Keyword(s):  
Insect Flight ◽  
X Ray Diffraction ◽  
X Ray ◽  
Cross Bridge ◽  
Flight Muscles ◽  
Atp Analogues

scholarly journals Effect of Active Lengthening and Shortening on Small-Angle X-ray Reflections in Skinned Skeletal Muscle Fibres

2021 ◽  
Vol 22 (16) ◽  
pp. 8526
Author(s):  
Venus Joumaa ◽  
Ian C. Smith ◽  
Atsuki Fukutani ◽  
Timothy R. Leonard ◽  
Weikang Ma ◽  
...  
Keyword(s):  
Steady State ◽  
Small Angle ◽  
Isometric Contraction ◽  
Sarcomere Length ◽  
Force Enhancement ◽  
X Ray ◽  
Cross Bridge ◽  
Residual Force ◽  
Residual Force Enhancement ◽  
Cross Bridges

Our purpose was to use small-angle X-ray diffraction to investigate the structural changes within sarcomeres at steady-state isometric contraction following active lengthening and shortening, compared to purely isometric contractions performed at the same final lengths. We examined force, stiffness, and the 1,0 and 1,1 equatorial and M3 and M6 meridional reflections in skinned rabbit psoas bundles, at steady-state isometric contraction following active lengthening to a sarcomere length of 3.0 µm (15.4% initial bundle length at 7.7% bundle length/s), and active shortening to a sarcomere length of 2.6 µm (15.4% bundle length at 7.7% bundle length/s), and during purely isometric reference contractions at the corresponding sarcomere lengths. Compared to the reference contraction, the isometric contraction after active lengthening was associated with an increase in force (i.e., residual force enhancement) and M3 spacing, no change in stiffness and the intensity ratio I1,1/I1,0, and decreased lattice spacing and M3 intensity. Compared to the reference contraction, the isometric contraction after active shortening resulted in decreased force, stiffness, I1,1/I1,0, M3 and M6 spacings, and M3 intensity. This suggests that residual force enhancement is achieved without an increase in the proportion of attached cross-bridges, and that force depression is accompanied by a decrease in the proportion of attached cross-bridges. Furthermore, the steady-state isometric contraction following active lengthening and shortening is accompanied by an increase in cross-bridge dispersion and/or a change in the cross-bridge conformation compared to the reference contractions.

scholarly journals X-ray Diffraction Studies on the Structural Origin of Dynamic Tension Recovery Following Ramp-Shaped Releases in High-Ca Rigor Muscle Fibers

2020 ◽  
Vol 21 (4) ◽  
pp. 1244
Author(s):  
Haruo Sugi ◽  
Maki Yamaguchi ◽  
Tetsuo Ohno ◽  
Hiroshi Okuyama ◽  
Naoto Yagi
Keyword(s):  
Muscle Contraction ◽  
Actin Filaments ◽  
Myosin Head ◽  
Muscle Fibers ◽  
Skinned Fibers ◽  
Myosin Filament ◽  
X Ray Diffraction ◽  
X Ray ◽  
Tension Recovery ◽  
Pass Through

It is generally believed that during muscle contraction, myosin heads (M) extending from myosin filament attaches to actin filaments (A) to perform power stroke, associated with the reaction, A-M-ADP-Pi → A-M + ADP + Pi, so that myosin heads pass through the state of A-M, i.e., rigor A-M complex. We have, however, recently found that: (1) an antibody to myosin head, completely covering actin-binding sites in myosin head, has no effect on Ca2+-activated tension in skinned muscle fibers; (2) skinned fibers exhibit distinct tension recovery following ramp-shaped releases (amplitude, 0.5% of Lo; complete in 5 ms); and (3) EDTA, chelating Mg ions, eliminate the tension recovery in low-Ca rigor fibers but not in high-Ca rigor fibers. These results suggest that A-M-ADP myosin heads in high-Ca rigor fibers have dynamic properties to produce the tension recovery following ramp-shaped releases, and that myosin heads do not pass through rigor A-M complex configuration during muscle contraction. To obtain information about the structural changes in A-M-ADP myosin heads during the tension recovery, we performed X-ray diffraction studies on high-Ca rigor skinned fibers subjected to ramp-shaped releases. X-ray diffraction patterns of the fibers were recorded before and after application of ramp-shaped releases. The results obtained indicate that during the initial drop in rigor tension coincident with the applied release, rigor myosin heads take up applied displacement by tilting from oblique to perpendicular configuration to myofilaments, and after the release myosin heads appear to rotate around the helical structure of actin filaments to produce the tension recovery.

Sign in / Sign up

Export Citation Format

Share Document