scholarly journals Monitoring the Water Quality of Small Water Bodies Using High-Resolution Remote Sensing Data

2019 ◽  
Vol 8 (12) ◽  
pp. 553 ◽  
Author(s):  
Zehra Yigit Avdan ◽  
Gordana Kaplan ◽  
Serdar Goncu ◽  
Ugur Avdan
Keyword(s):  
Remote Sensing ◽  
Water Quality ◽  
High Resolution ◽  
Quality Parameters ◽  
Water Bodies ◽  
Water Quality Parameters ◽  
Water Turbidity ◽  
Small Water ◽  
Red Edge ◽  
Small Water Bodies

Remotely sensed data can reinforce the abilities of water resources researchers and decision-makers to monitor water quality more effectively. In the past few decades, remote sensing techniques have been widely used to measure qualitative water quality parameters. However, the use of moderate resolution sensors may not meet the requirements for monitoring small water bodies. Water quality in a small dam was assessed using high-resolution satellite data from RapidEye and in situ measurements collected a few days apart. The satellite carries a five-band multispectral optical imager with a ground sampling distance of 5 m at its nadir and a swath width of 80 km. Several different algorithms were evaluated using Pearson correlation coefficients for electrical conductivity (EC), total dissolved soils (TDS), water transparency, water turbidity, depth, suspended particular matter (SPM), and chlorophyll-a. The results indicate strong correlation between the investigated parameters and RapidEye reflectance, especially in the red and red-edge portion with highest correlation between red-edge band and water turbidity (r2 = 0.92). Two of the investigated indices showed good correlation in almost all of the water quality parameters with correlation higher than 0.80. The findings of this study emphasize the use of both high-resolution remote sensing imagery and red-edge portion of the electromagnetic spectrum for monitoring several water quality parameters in small water areas.

scholarly journals Evaluation of RapidEye-3 Satellite Data for Assessing Water Turbidity of Lake Borabey

Proceedings ◽  
2019 ◽  
Vol 48 (1) ◽  
pp. 14
Author(s):  
Gordana Kaplan ◽  
Zehra Yigit Avdan ◽  
Serdar Goncu ◽  
Ugur Avdan
Keyword(s):  
Remote Sensing ◽  
Water Quality ◽  
High Resolution ◽  
Remote Sensing Data ◽  
Quality Parameters ◽  
In Situ Measurements ◽  
Water Quality Parameters ◽  
Water Turbidity ◽  
Sensing Data

In water resources management, remote sensing data and techniques are essential in watershed characterization and monitoring, especially when no data are available. Water quality is usually assessed through in-situ measurements that require high cost and time. Water quality parameters help in decision making regarding the further use of water-based on its quality. Turbidity is an important water quality parameter and an indicator of water pollution. In the past few decades, remote sensing has been widely used in water quality research. In this study, we compare turbidity parameters retrieved from a high-resolution image with in-situ measurements collected from Borabey Lake, Turkey. Here, the use of RapidEye-3 images (5 m-resolution) allows for detailed assessment of spatio-temporal evaluation of turbidity, through the normalized difference turbidity index (NDTI). The turbidity results were then compared with data from 21 in-situ measurements collected in the same period. The actual water turbidity measurements showed high correlation with the estimated NDTI mean values with an R2 of 0.84. The research findings support the use of remote sensing data of RadipEye-3 to estimate water quality parameters in small water areas. For future studies, we recommend investigating different water quality parameters using high-resolution remote sensing data.

scholarly journals Small Water Body Detection and Water Quality Variations with Changing Human Activity Intensity in Wuhan

2022 ◽  
Vol 14 (1) ◽  
pp. 200
Author(s):  
Lingjun Wang ◽  
Wanjuan Bie ◽  
Haocheng Li ◽  
Tanghong Liao ◽  
Xingxing Ding ◽  
...  
Keyword(s):  
Remote Sensing ◽  
Water Quality ◽  
Water Body ◽  
Human Activities ◽  
Water Bodies ◽  
Small Water ◽  
Small Water Body ◽  
Water Indices ◽  
Small Water Bodies

Small water bodies ranging in size from 1 to 50,000 m2, are numerous, widely distributed, and have various functions in water storage, agriculture, and fisheries. Small water bodies used for agriculture and fisheries are economically significant in China, hence it is important to properly identify and analyze them. In remote sensing technology, water body identification based on band analysis, image classification, and water indices are often designed for large, homogenous water bodies. Traditional water indices are often less accurate for small water bodies, which often contain submerged or floating plants or easily confused with hill shade. Water quality inversion commonly depends on establishing the relationship between the concentration of water constituents and the observed spectral reflectance. However, individual variation in water quality in small water bodies is enormous and often far beyond the range of existing water quality inversion models. In this study, we propose a method for small water body identification and water quality estimation and test its applicability in Wuhan. The kappa coefficient of small water body identification is over 0.95, and the coefficient of determination of the water quality inversion model is over 0.9. Our results show that the method proposed in this study can be employed to accurately monitor the dynamics of small water bodies. Due to the outbreak of the COVID-19 pandemic, the intensity of human activities decreased. As a response, significant changes in the water quality of small water bodies were observed. The results also suggest that the water quality of small water bodies under different production modes (intensive/casual) respond differently in spatial and temporal dimensions to the decrease in human activities. These results illustrate that effective remote sensing monitoring of small water bodies can provide valuable information on water quality.

scholarly journals Assessment of Water Quality Parameters Using Temporal Remote Sensing Spectral Reflectance in Arid Environments, Saudi Arabia

Water ◽  
2019 ◽  
Vol 11 (3) ◽  
pp. 556 ◽  
Author(s):  
Mohamed Elhag ◽  
Ioannis Gitas ◽  
Anas Othman ◽  
Jarbou Bahrawi ◽  
Petros Gikas
Keyword(s):  
Remote Sensing ◽  
Water Quality ◽  
Remote Sensing Data ◽  
Quality Parameters ◽  
Water Quality Parameters ◽  
Arid Environments ◽  
Water Turbidity ◽  
Mean Values ◽  
Sensing Data ◽  
Sentinel 2

Remote sensing applications in water resources management are quite essential in watershed characterization, particularly when mega basins are under investigation. Water quality parameters help in decision making regarding the further use of water based on its quality. Water quality parameters of chlorophyll a concentration, nitrate concentration, and water turbidity were used in the current study to estimate the water quality parameters in the dam lake of Wadi Baysh, Saudi Arabia. Water quality parameters were collected daily over 2 years (2017–2018) from the water treatment station located within the dam vicinity and were correspondingly tested against remotely sensed water quality parameters. Remote sensing data were collected from Sentinel-2 sensor, European Space Agency (ESA) on a satellite temporal resolution basis. Data were pre-processed then processed to estimate the maximum chlorophyll index (MCI), green normalized difference vegetation index (GNDVI) and normalized difference turbidity index (NDTI). Zonal statistics were used to improve the regression analysis between the spatial data estimated from the remote sensing images and the nonspatial data collected from the water treatment plant. Results showed different correlation coefficients between the ground truth collected data and the corresponding indices conducted from remote sensing data. Actual chlorophyll a concentration showed high correlation with estimated MCI mean values with an R2 of 0.96, actual nitrate concentration showed high correlation with the estimated GNDVI mean values with an R2 of 0.94, and the actual water turbidity measurements showed high correlation with the estimated NDTI mean values with an R2 of 0.94. The research findings support the use of remote sensing data of Sentinel-2 to estimate water quality parameters in arid environments.

Water quality parameters associated with prevalence of Legionella in hot spring facility water bodies

2010 ◽  
Vol 44 (16) ◽  
pp. 4805-4811 ◽  
Author(s):  
Shih-Wei Huang ◽  
Bing-Mu Hsu ◽  
Shu-Fen Wu ◽  
Cheng-Wei Fan ◽  
Feng-Cheng Shih ◽  
...  
Keyword(s):  
Water Quality ◽  
Hot Spring ◽  
Quality Parameters ◽  
Water Bodies ◽  
Water Quality Parameters

scholarly journals Detecting spatiotemporal variability in the physicochemical properties of water in the Lower Mearim using remote sensing data

2020 ◽  
Vol 42 ◽  
pp. e32
Author(s):  
George Colares Silva Filho ◽  
Juliana Martins dos Santos ◽  
Paulo Cesar Mendes Villis ◽  
Ingrid Santos Gonçalves ◽  
Isael Coelho Correia ◽  
...  
Keyword(s):  
Remote Sensing ◽  
Water Quality ◽  
Physicochemical Properties ◽  
Monitoring Program ◽  
Remote Sensing Data ◽  
Quality Parameters ◽  
Water Quality Parameters ◽  
Spatiotemporal Variability ◽  
Landsat 8 ◽  
Solids Content

Natural or anthropogenic chemical compounds of different origins often accumulate in estuarine regions. These compounds may alter the water quality. Therefore, It is important to constantly monitor the quality of estuarine regions. A combination of remote sensing and traditional sampling can lead to a better monitoring program for water quality parameters. The objective of this work is to assess the spatiotemporal variability of the physicochemical properties of water in the lower region of the Mearim River and estimate water quality parameters via remote sensing. Samples were collected at 16 points, from Baixo Arari to the mouth of the watershed, using a multiparameter meter and Landsat 8 satellite images. The physicochemical parameters of the water had high salinity levels, between 2.30 and 20.10 parts per trillion; a high total dissolved solids content, between 2.77 and 19.70 g/L; and minimum dissolved oxygen values. Estimating the physicochemical properties of the water via remote sensing proved feasible, particularly in the dry season when there is less cloud cover.

scholarly journals Remote sensing inversion of lake water quality parameters based on ensemble modelling

2020 ◽  
Vol 143 ◽  
pp. 02007
Author(s):  
Li Xiaojuan ◽  
Huang Mutao ◽  
Li Jianbao
Keyword(s):  
Remote Sensing ◽  
Water Quality ◽  
Quality Parameters ◽  
Water Quality Parameters ◽  
Entropy Weight ◽  
Ensemble Modelling ◽  
Chl A ◽  
Inversion Model ◽  
Entropy Weight Method ◽  
Weight Method

In this paper, combined with water quality sampling data and Landsat8 satellite remote sensing image data, the inversion model of Chl-a and TN water quality parameter concentration was constructed based on machine learning algorithm. After the verification and evaluation of the inversion results of the test samples, Chl-a TN inversion model with high correlation between model test results and measured data was selected to participate in remote sensing inversion ensemble modelling of water quality parameters. Then, the ensemble remote sensing inversion model of water quality parameters was established based on entropy weight method and error analysis. By applying the idea of ensemble modelling to remote sensing inversion of water quality parameters, the advantages of different models can be integrated and the precision of water quality parameters inversion can be improved. Through the evaluation and comparative analysis of the model results, the entropy weight method can improve the inversion accuracy to some extent, but the improvement space is limited. In the verification of the two methods of ensemble modelling based on error analysis, compared with the optimal results of a single model, the determination coefficient (R2) of Chlorophyll a and TN concentration inversion results was increased from 0.9288 to 0.9313 and from 0.8339 to 0.8838, and the root mean square error was decreased from 14.2615 μ/L to 10.4194 μ/L and from1.1002mg/L to 0.8621mg/L. At the same time, with the increase of the number of models involved in the set modelling, the inversion accuracy is higher.

Development of automatic coagulant dosage control technology for rapid change of raw water quality parameters

2012 ◽  
Vol 12 (6) ◽  
pp. 918-925 ◽  
Author(s):  
Y. Sangu ◽  
H. Yokoi ◽  
H. Tadokoro ◽  
T. Tachi
Keyword(s):  
Water Quality ◽  
Pilot Scale ◽  
Quality Parameters ◽  
Water Quality Parameters ◽  
Control Technology ◽  
Raw Water ◽  
Control Logic ◽  
Water Turbidity ◽  
Coagulant Dosage ◽  
Raw Water Quality

An automatic coagulant dosage control technology for water purification plants was developed to deal with rapid changes of raw water quality parameters. Control logic was developed to decide coagulant dosage based on aluminum concentration in rapid mixing tank water based on results of semi-pilot scale experiments. This logic enabled quick feedback on the excess or lack of coagulant. It was found that the aluminum residual rate, which was proposed as an indicator of coagulation reactions, could be given as a function of coagulant dosage and turbidity. The effectiveness of the control logic was verified in semi-pilot scale experiments. Settled water turbidity was within ±0.5 NTU of target value even when raw water turbidity increased rapidly up to 100 NTU.

Sign in / Sign up

Export Citation Format

Share Document