Output Feedback Dissipation Control for the Power-Level of Modular High-Temperature Gas-Cooled Reactors

Safety demonstration tests on the 10 MW High Temperature Gas-cooled Reactor-Test Module (HTR-10) were conducted to verify the inherent safety characteristics of modular High Temperature Gas-cooled Reactors (HTGRs) as well as to obtain the reactor core and primary cooling system transient data for validation of HTGR safety analysis models and codes. As one of these safety demonstration tests, a simulated anticipated transient without scram (ATWS) test called loss of forced cooling by tripping the helium circulator without reactor scram was carried out at 100% rated power level in July, 2005. This paper simulates the reactor transient behaviour during the test by using the THERMIX code system. The reactor power transition and a comparison with the test result are presented. Owing to the negative temperature coefficient of reactivity, the reactor undergoes a self-shutdown after the stop of the helium circulator and keeps subcritical till the end of the test. Due to the loss of forced cooling, the residual heat is slowly transferred from the core to the Reactor Cavity Cooling System (RCCS) by conduction, radiation and natural convection. The thermal response of this heat removal process is investigated. The calculated and test temperature transients of the measuring points in the reactor internals are given and the differences are preliminarily discussed. With respect to the safety features of the HTR-10, it is of most importance that the maximum fuel center temperature is always lower than 1230 °C which is the limited value at the first phase of the HTR-10 project. The simulation and test results show that the HTR-10 has the built-in passive safety features, and the THERMIX code system is applicable and reasonable for simulating and analyzing the helium circulator trip ATWS test.

Download Full-text

Physically-Based Power-Level Control for Modular High Temperature Gas-Cooled Reactors

IEEE Transactions on Nuclear Science ◽

10.1109/tns.2012.2207126 ◽

2012 ◽

Vol 59 (5) ◽

pp. 2531-2549 ◽

Cited By ~ 29

Author(s):

Zhe Dong

Keyword(s):

High Temperature ◽

Power Level ◽

Level Control ◽

Physically Based ◽

High Temperature Gas

Download Full-text

An Environmental Wet Cell For High Voltage Electron Microscopy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100070539 ◽

1973 ◽

Vol 31 ◽

pp. 18-19

Author(s):

N.J. Tighe ◽

H.M. Flower ◽

P.R. Swann

Keyword(s):

Electron Microscopy ◽

High Temperature ◽

Image Quality ◽

Inelastic Scattering ◽

High Voltage ◽

High Voltage Electron Microscopy ◽

Voltage Electron ◽

Environmental Cell ◽

Water Saturated ◽

High Temperature Gas

A differentially pumped environmental cell has been developed for use in the AEI EM7 million volt microscope. In the initial version the column of gas traversed by the beam was 5.5mm. This permited inclusion of a tilting hot stage in the cell for investigating high temperature gas-specimen reactions. In order to examine specimens in the wet state it was found that a pressure of approximately 400 torr of water saturated helium was needed around the specimen to prevent dehydration. Inelastic scattering by the water resulted in a sharp loss of image quality. Therefore a modified cell with an ‘airgap’ of only 1.5mm has been constructed. The shorter electron path through the gas permits examination of specimens at the necessary pressure of moist helium; the specimen can still be tilted about the side entry rod axis by ±7°C to obtain stereopairs.

Download Full-text